EL-MF877-00 Page 2
Template Revision B
PSG instructions for this template are available at EL-MF877-01
Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Size (if
applicable)
Description #1 Screwdriver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove screw rubber foot and screw *6 pcs
2. Disassemble the rear cover from the top cover
3. Remove the top FFC cable
4. Remove battery cable and DC-in cable from MB connector
5. Remove CPU Fan ,connector and screw *3
6. Remove GPU Fan ,connector and screw *3
7. Remove Thermal module and screw *8
8. Remove antenna support L lower and screw *2
9. Remove Main and Aux
10. Remove Waln card and screw *1
11. Remove lower holder BKT and screw *2
12. Remove internal battery and screw *3 /Remove RTC battery
13. Remove external battery BKT L / R and screw *4
14. Remove DC-in BKT and screw *1
15. Remove DC-in cable
16. Remove Antenna support R upper and screw *1
17. Remove Antenna support L upper and screw *1
18. Remove Absorber on top IO holder BKT
19. Remove top IO holder BKT and screw *2
20. Remove sheilding can
21. Remove fan screw nut *2
22. Remove power board and screw *2
23. Remove VR DC-out cable
24. Remove MB and screw *2
25. Remove power button BLM
26. Remove MB
27. Remove VR DC-out BKT and screw *2
28. Remove screw rubber foot and screw *6 pcs
29. Remove bottom door from the Dock cover
30. Remove left / right cover from the Dock cover
31. Remove Dock cover from Dock inside
32. Remove DC cable*2
33. Remove Docking MB and screw *6.
34. Remove DC holder BKT and screw*2
35. Remove DC cable and Dock DC PCB.
