HP df808 Series User manual

HP df808 Series
Digital Picture Frame
User Manual

1

1
English
FCC Compliance Statement
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, only use shielded interface
cables when connecting to computer or peripheral devices. Any changes
or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

2
English
3
Table of Contents
What’s in the Box..........................................................2
Getting Started..............................................................3
Installing the Foot Stand..............................................5
Powering on the Frame.................................................6
Using the Digital Photo Frame......................................7
Settings Menu..............................................................15
Cleaning and Care Tips................................................17
Getting Help.................................................................18

2
3
English
What’s in the Box
Qty Item Image
1 Digital Picture Frame
1Remote Control
Replacement Battery = CR2025
1 Universal Power Adapter (5V, 2A)
1 USB Cable
1User Manual with
Declaration of Conformity
1 Quick Start Guide
1 Warranty Document

4
English
5
Getting Started
Identifying the parts
Front view
LCD (Liquid Crystal Display) panel
Rear view
Control buttons
Hanging slot
Lock slot

4
5
English
Left view
Power socket
Power switch transfer
Mini USB port for le transfer
Right view
5-in-1 memory card slot
(SD/SDHC, MMC, MS, MS-Pro, xD)
Foot stand
CF memory card slot

6
English
7
Installing the Foot Stand
On the back of the frame, align the foot stand with the lock slot.1.
Install the foot stand onto the frame as illustrated until it clicks into2.
place.

6
7
English
Powering on the Frame
Plug the AC power adapter into the power outlet, then plug the other1.
end into the power socket of the frame.
DC 5V
Insert a memory card (to be purchased separately) to the appropriate2.
card slot.
Note: You can also view the demo images preloaded in the internal•
memory of this frame without inserting a memory card.
Supported memory card type: Secure Digital™, xD-Picture Card™,•
MultiMedia Card™, Memory Stick™, and Memory Stick PRO™.
Both 5-in-1 and CF memory card slots support hot-swap function.•
When one memory card is inserted and then a second one is•
inserted, the frame only will display les from the second one.
When two memory cards are inserted simultaneously and the•
power is turned off and then back on, the frame only will display
les from the SD card.
This frame may not read all image or video les downloaded from •
the Internet.
Turn on the frame by sliding the power switch to the ON position.3.

8
English
9
Using the Digital Photo Frame
Using the control buttons
You can operate this frame by pressing the control buttons which are located
on the back of the frame. The icons at the top of the screen correspond to the
control buttons. If there are no icons at the top of the screen, then press any
of the control buttons to display the icons.
Note: Control buttons do not always perform the same function between•
modes.
Using the remote control
This frame comes with a remote control. Below is a table of all the buttons
and a description of their functions.
Note: This guide assumes you are using the remote control to control the•
frame.
1
9
12
11
13
8
2
3
4
5
7
6
No Description
1Backlight Saving
Press this button to activate Backlight Saving function.
2Alarm
In Calendar mode, you can press this button to set up the alarm.
3Setup
Press this button to access the Setup menu.
4
Mode selection
Press this button to switch among different Photo, Calendar, Video, and
Settings modes.
5
Return
Press this button to cancel current action and/or go back to the previous
page.

8
9
English
6OK & Play/Pause
Press this button to conrm a selection, start, or pause le playback.
7Copy
Press this button to copy a selected le to the internal memory.
8
Mute
Press this button to activate the Mute mode. Press it again to restore the
volume.
9Vol+ / Vol-
Press these buttons to increase/decrease the volume.
10
Rotate
Each time you press this button, the selected photo rotates clockwise 90
degrees.
11 Zoom in/Zoom out
Press these buttons to zoom in/zoom out the selected image le.
12
Navigation buttons
• In list or menus: Press to scroll up, down, left or right.
• / : Press to scroll to the previous/next item.
13 Delete
Press this button to delete the selected le.

10
English
11
Main Menu
You can access the different modes from the main menu.
Press the button to view the main menu as illustrated below.
Press button to view the Main Menu as illustrated below.
Note: Depending on the screen you are originating from, you will have to•
press the button either once or twice to display the main menu.
Press the• once to cycle to the next mode icon.
When you get to the desired mode icon, allow two seconds for the•
mode to be selected.
5 modes available: Photo, Calendar, Music, Video, and Settings Menu•
Photo mode
The Photo mode allows you to view images in three kinds of viewing
modes: slideshow view, single view, and thumbnail view.
After the frame is turned on, a slideshow starts automatically.
Note: In a slideshow, background music will play sequentially if the•
feature has been enabled. Please refer to the section on the
Settings Menu on page 14

10
11
English
Slideshow mode will begin automatically a few seconds after the•
frame is powered on or when an external memory card is inserted.
To switch to thumbnail view, press the button• . Use buttons
and to move among images.
To switch to photo slideshow mode, press the button• .
To view images individually, press• again to pause slideshow on
a particular photo.
Note: This frame only supports the JPEG le format.•
Calendar mode
The Calendar mode displays a monthly calendar.
After you turn on the frame, press the button• to switch to the
Calendar mode.
To switch to the next month, press the button• .
To switch to the previous month, press the button• .
Setting the date and time
Go to the Calendar mode1.
Press the button2. to go to Calendar setup menu.
Use the buttons3. / to move to different elds, and use the
buttons / to adjust date and time.
Press the button4. .
Setting the alarm
Go to the Calendar mode.1.

12
English
13
Press the button2. .
Use the buttons3. / to move to different elds, and use the
buttons / to adjust alarm time, tone, and mode.
Press the button4. .
Music mode
The Music mode allows you to play audio les that are stored in the
internal memory or on the inserted memory card.
Note: This frame only supports the MP3 audio le format.•
Playing the music
After you turn on the frame, press the button1. to switch to the
Music mode.
Press the button2. to show the Music List.
Use the buttons3. / to select a music le.
Press the button4. to start the playback.
To increase volume, press the button• .
To decrease volume, press the button• .
Deleting a music le
After you turn on the frame, press the button1. to switch to the
Music mode.
Press the button2. to show the Music List.
From the Music List screen that appears, use the buttons3. /

12
13
English
to select the music le to be deleted.
Press the button4. .
A conrmation message appears.5.
To delete the selected music le, press the button • .
To cancel, press the button• .
Note: This frame only deletes les from internal memory.•
Copying a music le
After you turn on the frame, press the button1. to switch to the Music
mode.
Press the button2. to show the Music List.
From the Music List screen that appears, use the buttons3. / to
select the music le to be copied.
Press the button4. .
A conrmation message appears.5.
To copy the selected music le, press the button • .
To cancel, press the button• .
Note: This frame only copies les from external memory to internal memory.•
Video mode
Viewing a video le
After you turn on the frame, press the button1. to switch to the Video
mode.
The2. Video List screen appears.

14
English
15
Use the buttons3. / to select a video le.
Press the button4. to start the playback.
To increase volume, press the button• .
To decrease volume, press the button• .
Note:
This frame only supports Motion JPEG video le format • (640X480
at 30 fps).
Deleting a video le
After you turn on the frame, press the button1. to switch to the
Music mode.
The2. Video List screen appears.
From the Video List screen that appears, use the buttons3. /
to select the video le to be deleted.
Press the button4. .
A conrmation message appears.5.
To delete the selected video le, press the button • .
To cancel, press the button• .
Note: This frame only deletes les from internal memory.•
Copying a video le
After you turn on the frame, press the button1. to switch to the
Video mode.
The2. Video List screen appears.
From the Video List screen that appears, use the buttons3. /
to select the video le to be copied.

14
15
English
Press the button4. .
A conrmation message appears.5.
To copy the selected video le, press the button • .
To cancel, press the button• .
Note: This frame only copies les from external memory to internal •
memory.

16
English
17
Settings Menu
After you turn on the frame, press the mode selection button to switch
to the Settings mode.
Settings
menu Sub-menus Formats the internal memory.
Photo Display
Full Screen
Optimizes the image to t the whole
screen.
Note: Some cropping of the images
may occur in this option.
Real Size Displays images in their original aspect
ratio.
Photo
Information
On Allows you to display or hide the
information about image les in the
thumbnail mode.
Off
Display Clock On Allows you to display or hide the clock in
the slideshow mode.
Off
Slideshow
Setup...
Background
Music
On Turns the background music on or off.
Off
Frequency
5 Secs
Selects speed of your slideshow.
30 Secs
1 Min.
15 Mins.
30 Mins.
1 Hr.
4 Hrs.
12 Hrs.
1 Day
1 Week
Effect
None
Selects style of image transition.
Fade
Shutter
Cross
Mask
Brick
Order
Sequential Allows images to be displayed in a
sequential order.
Random Allows images to be displayed in a
random order.

16
17
English
System
Setup...
Brightness
0
Allows you to adjust the brightness of
the screen.
1
2
3
4
5
Language
English
Changes the OSD menu language.French
Spanish
Auto Copy
On Allows you to select whether image les
will be automatically copied from an
inserted memory card to the internal
memory. An auto copy message will
appear once a memory card is inserted.
Press the button to conrm.
Off
System Reset... Reset all settings back to default.
Format...
Formats the internal memory.
Note: If you use this option to format
the internal memory, all image/ video/
audio les will be deleted permanently.

18
English
19
Cleaning and Care Tips
Please power off the HP Digital Picture Frame before cleaning.√
DO NOT√ push on the screen too rmly.
DO NOT√spray or pour liquid cleaning agents directly on the screen
or frame.
DO NOT√use ammonia, alcohol, or abrasive detergent cleaning
agents.
Cleaning the Screen:
Wipe screen with a clean, soft, lint-free cloth to remove dust and1.
loose particles.
If further cleaning is required, apply an appropriate cleaning agent2.
(approved for LCD displays) to a clean, soft, lint-free cloth and wipe
the screen.
Cleaning the Frame and Backing:
Use a clean, soft, lint-free cloth to remove dust and loose particles.1.
If desired, apply an appropriate cleaning agent to a clean, soft,2.
lint-free cloth and wipe the appropriate surfaces.