HP FlexNetwork 6616 User manual

HP 6616 routers meet the requirement of FIPS security level 2. Installing a FIPS enclosure
Installation preparation
BOM:3105A022 Part number:5998-3567R
HP 6616 Router FIPS Enclosure (JG576A) Installation Guide-6PW102
Wear an ESD-preventive wrist strap, and make sure that the wrist strap has
a good skin contact and is well grounded.
The installation procedures must be performed by qualified personnel.
Before installation, you should read the Compliance and Safety Manual for
router compatibility information.
!
Installation tools (user supplied)
FIPS enclosure assembly
Attach the mounting plates to the chassis with M3 countersunk-head
screws.
Before installing mounting plates, remove the fastening screws from where
mounting plates are to be installed on the chassis.
Needle-nose pliers ESD-preventive
wrist strap Philips screwdriver Alcohol-based cleaning pad
Rear opacity shield Mounting plates M3 countersunk-
head screw Front opacity shield
If the router has been mounted to a rack, remove the router from the rack
first.
If an air filter has been attached to the router, remove it from the chassis.
Only use the screws and hex bolts that are supplied in the opacity shield kit
to secure the opacity shield.
!
Attach the mounting plates to the chassis with M3 countersunk-head
screws.
1
2

Attach the front opacity shield to where the air vents are located on the front
of the chassis and fasten the captive screws on the opacity shield.
To access documentation and support services, go to the Hewlett Packard
Enterprise Support Center website:
www.hpe.com/support/hpesc
Documentation
Applying tamper evidence labels
Make sure the ambient air is above 10°C (50°F).
Clean the chassis before applying tamper evident labels. Alcohol-based
cleaning pads are recommended.
Apply tamper evidence labels to all removable components on the device.
Two tamper evidence labels are provided with the FIPS enclosure
assembly.
!
Apply tamper evidence labels as shown in the figures.
5998-3567R