hp StorageWorks
Tape Fan Option Kit for
ProLiant ML530/570
Servers
Tape Fan Option Kit for ProLiant ML530/570 Servers
Second Edition(October 2003)
Part Number: 345999-002
© Copyright 2003 Hewlett-Packard Development Company, L.P.
Hewlett-Packard Company makes no warranty of any kind with regard to
this material, including, but not limited to, the implied warranties of
merchantability and fitness for a particular purpose. Hewlett-Packard shall
not be liable for errors contained herein or for incidental or consequential
damages in connection with the furnishing, performance, or use of this
material.
This document contains proprietary information, which is protected by
copyright. No part of this document may be photocopied, reproduced,
or translated into another language without the prior written consent of
Hewlett-Packard. The information contained in this document is subject to
change without notice.
Product names mentioned herein may be trademarks of their respective
companies as reflected by an associated footnote.
Hewlett-Packard Company shall not be liable for technical or editorial
errors or omissions contained herein. The information is provided “as is”
without warranty of any kind and is subject to change without notice. The
warranties for Hewlett-Packard Company products are set forth in the
express limited warranty statements for such products. Nothing herein
should be construed as constituting an additional warranty.
Printed in the U.S.A.
Installation
Instructions
Read instructions completely before
beginning the installation procedure
345999- 002
About this document
Use these instructions to install a cooling fan into an hp
ProLiant ML530 or ML570 server with SDLT or Ultrium tape
drives. Refer to your server documentation for complete
instructions to install a tape drive.
Note: With the exception of a 90° rotation, installation in a tower
server is similar to that of a rack version shown in these instructions.
Step 1: Power down the server
Step 2: Remove the top/side panel
Note: Before the installing fan, be sure all PCI adapters have been
installed in the server
Step 3: Remove the tape drive or blanks
15055
1
2
11
15048
1
2
1
15056
