HP Rp3440-4 - 9000 - 0 MB RAM Owner's manual

Safety and Regulatory Information
HP 9000 rp3410 and HP 9000 rp3440
Regulatory Model Number: FCLSA-0201
Manufacturing Part Number: A7137-96010-en
Fourth Edition
February 2007
© Copyright 2004-2007 Hewlett-Packard Development Company, L.P.

English 2
Legal Notices
Copyright Notices. © Copyright 2004-2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the express warranty statements
accompanying such products and services. Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.

HP 9000 rp3410 and HP 9000 rp3440 System Safety and Regulatory Information
Overview
Chapter 1 English 3
1HP 9000 rp3410 and HP 9000 rp3440 System
Safety and Regulatory Information
Overview
Regulatory Compliance statements are required by some countries or regions for international importation of
HP servers. The following information is provided:
Notational Conventions
Product Information
Regulatory Information
Regulatory Model Number
Electrical Safety
Electrostatic Discharge (ESD) Precautions
Lithium Battery Caution (for User Replaceable Batteries)
Laser Safety
Cabinet Safety Precautions
Disposal of waste equipment by users in private household in the European Union
Perchlorate Material - Special Handling May Apply
People’s Republic of China Electronic Industry Standard, SJ/T11364-2006
European Union RFI Statement
USA Radio Frequency Interference (FCC Notice)
Japan Radio Frequency Interference (VCCI)
Japan Power Cord Notice
Korea RFI Statement
Canada RFI Statement
Australia C-Tick Label
Taiwan BSMI
Taiwan Battery Warning
Germany Acoustics
Declaration of Conformity

HP 9000 rp3410 and HP 9000 rp3440 System Safety and Regulatory Information
Overview
Chapter 1
English 4
Notational Conventions
WARNING Warnings highlight procedures or information necessary to avoid injury to
personnel. The warning should tell the reader exactly what will result from what
actions and how to avoid them.
CAUTION A caution highlights procedures or information necessary to avoid damage to equipment,
damage to software, loss of data, or invalid test results.
NOTE A note highlights supplemental information.
Product Information
For detailed information on the HP 9000 rp3410 and HP 9000 rp3440 products, go to http://docs.hp.com
(Enterprise Servers, Workstations and Systems Hardware section).
Regulatory Information
For your protection, this product has been tested for conformance to various national and international
regulations and standards. The scope of this regulatory testing includes electrical and mechanical safety,
electromagnetic emissions, immunity, acoustics and hazardous materials.
When required, approvals are obtained from third party test agencies. Approval marks appear on the product
label. In addition, various regulatory bodies require some information under the headings listed in this
section.
Regulatory Model Number
For the purpose of regulatory compliance certifications and identification, the HP 9000 rp3410 and HP 9000
rp3440 servers are assigned an HP regulatory model number. The HP regulatory model number for these
products is FCLSA-0201. This number can be found on the product label, along with the required approval
markings and information. When requesting certification information for this product, always refer to this
regulatory model number.
NOTE Do not confuse the regulatory model number with the marketing or model number assigned to
your HP 9000 rp3410 or HP 9000 rp3440 server.

HP 9000 rp3410 and HP 9000 rp3440 System Safety and Regulatory Information
Overview
Chapter 1 English 5
Electrical Safety
Locate the AC outlet near the server! The AC power cords/cables are this product's main AC disconnect
devices and must be easily accessible at all times.
This product has not been evaluated for connection to an “IT” power system (AC distribution system having
no direct connection to earth according to IEC 60950).
Installation Conditions
See installation instructions before connecting this equipment to the input supply.
WARNING The equipment must be provided with a proper AC protective earth (PE) ground
connection.
Network Connected Equipment
WARNING The installation must provide a ground connection for the network equipment.
Electrostatic Discharge (ESD) Precautions
When handling any electronic component or assembly (such as a PCI card or memory SIMM), you must
observe the following antistatic precautions to prevent damage. An ESD kit (HP P/N A3024-80004) is
available (or supplied with memory additions). This kit contains one wrist strap, one conductive sheet, and
one antistatic foam pad.
• Always disconnect power from the server and wear a grounded wrist strap when working around the
server. Always wear a grounded wrist strap when handling printed circuit boards.
• Treat all assemblies, components and interface connections as static-sensitive.
• Avoid working in carpeted areas, and keep body movement to a minimum while removing or installing
boards, to minimize buildup of static charge.
Lithium Battery Caution (for User Replaceable Batteries)
WARNING Observe the correct polarity when changing the lithium battery. There is a danger of
explosion if battery is installed incorrectly.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions and local
disposal requirements.
IMPORTANT Switzerland: Annex 4.10 of SR 814.013 applies to batteries.

HP 9000 rp3410 and HP 9000 rp3440 System Safety and Regulatory Information
Overview
Chapter 1
English 6
Laser Safety
NOTE Laser devices installed in this equipment must be certified as Class 1 Laser devices by the
Regulatory Agency recognized by the country where the equipment is installed.
NOTE If a Fibre Channel I/O card is present, the following laser safety statement applies.
This product contains a laser internal to the Optical Link Module (OLM) for connection to the Fibre
communications port.
In the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained in the
Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The certification is
indicated by a label on the plastic OLM housing.
Outside the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained in
IEC 60825-1:1993 and EN 60825-1:1994, including Amendment 11:1996.
NOTE If a DVD is present, the following laser safety statement applies.
This product contains a laser internal to the Digital Versatile Disc (DVD) housing.
In the USA, the DVD is certified as a Class 1 laser product conforming to the requirements contained in the
Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The certification is
indicated by a label on the DVD housing.
Outside the USA, the DVD is certified as a Class 1 laser product conforming to the requirements contained in
IEC 60825-1:1993+A1 and EN 60825-1:1994+A11.
Cabinet Safety Precautions
WARNING Cabinets are heavy even when empty. Exercise caution when moving cabinets
whether equipment is installed in the cabinet or not. Avoid rolling cabinets on rough
or uneven surfaces or inclines greater than 10 degrees. Unloading cabinets from the
pallet and movement of cabinets should be performed by at least two people.
Slideable products are not to be extended from the cabinet while the equipment is
on the shipping pallet. The cabinet must be unloaded from the pallet and all anti-tip
devices properly installed prior to extending any slideable product.
Once installed, all anti-tip devices must remain in place to maintain stability. Only
one slideable product must be extended at a time.
To determine ballast requirements, refer to the ballast worksheets in documentation
accompanying the cabinet, or to information available at http://docs.hp.com.
Failure to follow these precautions can result in damage to equipment or injury to
personnel.

HP 9000 rp3410 and HP 9000 rp3440 System Safety and Regulatory Information
Overview
Chapter 1 English 7
Disposal of waste equipment by users in private household in the European
Union
This symbol on the product or on its packaging indicates that this product must not be
disposed of with your other household waste. Instead, it is your responsibility to dispose
of your waste equipment by handing it over to a designated collection point for the
recycling of waste electrical and electronic equipment. The separate collection and
recycling of your waste equipment at the time of disposal will help to conserve natural
resources and ensure that it is recycled in a manner that protects human health and the
environment. For more information about where you can drop off your waste equipment
for recycling, please contact your local city office, your household waste disposal service
or the shop where you purchased the product.
Perchlorate Material - Special Handling May Apply
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate.
This product may include a real-time clock battery or coin cell battery that may contain perchlorate and may
require special handling when recycled or disposed of in California. Refer to the product user documentation
to determine if this product contains batteries, and if so, the battery type(s) that are used.
People’s Republic of China Electronic Industry Standard, SJ/T11364-2006
Marking for the Control of Pollution Caused by Electronic Information Products
Unless otherwise labeled, this Electronic Information Product Pollution Control Mark applies to HP-branded
Enterprise Storage and Server products.
Additional information about this product may be obtained at the following url:
http://www.hp.com/go/chinarohs
European Union RFI Statement
This is a Class A product. In a domestic environment, this product may cause radio interference in which case
the user may be required to take adequate measures.

HP 9000 rp3410 and HP 9000 rp3440 System Safety and Regulatory Information
Overview
Chapter 1
English 8
USA Radio Frequency Interference (FCC Notice)
The Federal Communications Commission (in 47 CFR Part 15 subpart B) has specified that the following
notice be brought to the attention of the users of this product.
NOTE This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
HP’s system verification tests were conducted with HP-supported peripheral devices and HP shielded cables,
such as those you receive with your computer. Changes or modifications not expressly approved by HP could
void the user’s authority to operate the equipment. Cables used with this device must be properly shielded to
comply with the requirements of the FCC.
Japan Radio Frequency Interference (VCCI)
Harmonics Current Guideline-Compliant Device
This equipment is in the Class A category information technology equipment based on the rules of Voluntary
Control Council For Interference by Information Technology Equipment (VCCI). When used in a residential
area, radio interference may be caused. In this case, the user may be required to take appropriate corrective
actions.
Japan Power Cord Notice
Your computer must use only the power cord that was shipped with the computer. Do not use this power cord
with any other products.
Korea RFI Statement
This equipment has been tested to comply with the limits for a Class A digital device. This equipment should
be operated in a commercial environment. Please exchange if you purchased this equipment for
noncommercial purposes.
Canada RFI Statement
This Class A digital apparatus complies with Canadian ICES-003.

HP 9000 rp3410 and HP 9000 rp3440 System Safety and Regulatory Information
Overview
Chapter 1 English 9
Australia C-Tick Label
Taiwan BSMI
This product has been reviewed and is fully compliant to CNS 13438 (CISPR 22: 1993) Class A.
Warning Users: This is a Class A IT (Information Technology) Product. If this product is used in a domestic
environment, radio frequency disturbance may occur, in which case the user may be required to take
corrective actions.
Taiwan Battery Warning
The Taiwan EPA requires dry battery manufacturing or importing firms in accordance with Article 15 of the
Waste Disposal Act are required to indicate the recovery marks on the batteries used in sales, giveaway or
promotion. Contact a qualified Taiwanese recycler for proper battery disposal.
Figure 1-1 Taiwan Battery Warning
Germany Acoustics
Acoustic noise
• Sound Pressure: LpAm < 55dB
• Sound Power: LWAd < 7.5 Bels
LpAm is weighted Sound Pressure Level (LpA) measured at the bystander position and normal operation per
ISO 9296. LWAd is a weighted Sound Power Level Reference at normal operation per ISO 9296.

HP 9000 rp3410 and HP 9000 rp3440 System Safety and Regulatory Information
Overview
Chapter 1
English 10
Declaration of Conformity