HP DreamWorks Shrek 3-D puss in boots User manual

GETTING STARTED
ASSEMBLE YOUR PUSS IN BOOTS
Hat feather, feet, hat brim, arms, and tail:
Fold pieces in half and glue together.
Cut out shapes along solid gray lines.
Tail: Insert (from non-printed side) into slit on back of body.
Glue tabs to inside of body.
Body: Starting at the top, glue tabs on side body panels to front body panel.
Then, glue tabs on back body panel to each side body panel.
To close top and bottom of body, fold in tabs and glue in place.
Time to complete: Approximately 45 minutes
ASSEMBLY INSTRUCTIONS
Level: Medium
4
6
5
3Fold all pieces along
score lines, using the
folding key below as a
reference.
Mountain Fold
Valley Fold
1Score all the pieces: Using
a ruler as a guide, run the
back side of a butter knife
rmly along all dashed and
dotted lines.
2Using scissors or a craft
knife and cutting mat, cut
out pieces along solid
lines. Don’t forget to cut
slits on the body piece.
3-D puss in boots
Shrek Forever After ™ & © 2010 DreamWorks Animation L.L.C.
Shrek is a registered trademark of DreamWorks Animation L.L.C.
©2010 Hewlett-Packard Company hp.com/create
Hey kids,
make sure to ask
an adult for help!
Materials
• Metal-edged ruler
• Butter knife
• Scissors or craft knife
• Cutting mat (optional)
• Multipurpose glue

ASSEMBLY INSTRUCTIONS CONTINUED
Arms: Insert arms into slits on sides of body.
You’re done!
12
8
Shrek Forever After ™ & © 2010 DreamWorks Animation L.L.C.
Shrek is a registered trademark of DreamWorks Animation L.L.C.
©2010 Hewlett-Packard Company hp.com/create
Feet: Glue feet to base of body.
7
Belt: Wrap around body (above the tail) and glue
ends together.
11
Hat: Wrap hat around and glue tab behind other end.
Fold down top of hat and glue tabs inside hat.
Glue tabs on bottom of hat to top of brim.
Feather: Cut small slits along sides
of feather, and curl around nger to give shape.
Glue to left side of hat. Fold up side of hat brim.
Glue hat to top of head.
9 10