Hubbell Quartz Flood Q500 Series User manual

HubbellCanadaLP,LightingDivision
870BrockRoadSouth,Pickering,ON,L1W1Z8
Tel.(905)8391138
Formoreinformation,visitourwebsite: www.hubbellonline.com
INSTALLATIONINSTRUCTIONS
QuartzFlood
Q500/Q300Series
WARNING
DISCONNECTPOWERDURINGINSTALLATIONANDBEFORESERVICING.
READALLINSTRUCTIONSCOMPLETELYBEFORESTARTINGINSTALLATION
SAFETYPRECAUTIONS
1.Donotmountthebodyofthisfixturewithinaninchofanycombustible
material.
2.Donotmountinaclosedroomorboxedinlocationwhereaircannotcirculate
aroundthefixture.Thenormaloperatingtemperatureofaquartzhalogen
fixtureisveryhighandrequiresfreeaircirculationsothefixturewill
notoverheat.
3.Turnoffpowerbeforeinstallationandservicing.Beforeinstallingconsult
localelectricalcodesforwiringandgroundingrequirements.
4.Forusewith120voltsonly.
5.Donotlookdirectlyatlightedlamp.
INSTALLATION
1.Thisunitoperatesonregularhouseholdpower.(120V,60HZ)
2.FixtureissuppliedwithtwoleadsofI~AWG,SF2wiressixincheslong.
Connectonetoblackservicewireandothertowhiteservicewire,usingwire
nuts,crimponlugsorotherapproveddevice.Makesureconnectionsare
secureandnoloosewirestrandsarestickingoutofconnector.Then,connect
fixturegroundwiretohousegroundwireforgroundingrequirement.

HubbellCanadaLP,LightingDivision
870BrockRoadSouth,Pickering,ON,L1W1Z8
Tel.(905)8391138
Formoreinformation,visitourwebsite: www.hubbellonline.com
INSTALLATIONINSTRUCTIONS
QuartzFlood
Q500/Q300Series
WARNING
DISCONNECTPOWERDURINGINSTALLATIONANDBEFORESERVICING.
READALLINSTRUCTIONSCOMPLETELYBEFORESTARTINGINSTALLATION
AIMING
1.Rotatefixturehorizontallytoilluminatethedesiredarea.Makesurethat
thebulbinthefixtureisnomorethan4degreesfromlevelhorizontallyfor
electricshock,positionthefixture15degreesbelowhorizontalforrain
tight.
2.Settheverticalaimingbyloosingboltatthepivot.Aimfixtureatdesired
angleandsecurelyretightenbolt.Applysiliconesealantonthefollowing
locationforraintight.
A.Elbowscrew.C.Threadplug
B.Elbowjoint.D.Coverandjunctionboxjoints
INSTALLINGBULB&SERVICING
1.Unscrewtoreleaseglassshield.
2.UsingacleanclothorpapertoprotecttheT3bulbfromyourbarehands,
fittheT3bulbintotherighthandspringloadedsocketandpushtowardsit.
Makesurethateachofthebulbissecurelyseatedagainstthesocket
contact.
3.Closedoorandtightenscrewforsecureseal.
TROUBLESHOOTERCHECKLISTIFLIGHTDOESNOTWORK:
CheckYourPowerSource.
CheckToInsureProperSeatingOfLamp.
CheckElectricalConnections.
CheckIfLampFilamentIsBurnedOutorBroken.