HULALA HOME CTBSD0368 User manual

NOTE:
ITEM NO. CTBSD0368
This brochure contains IMPORTANT safty info. Please read and keep for
future reference.
1/12

MAINTAINANCE
AND WARNING
Keep furniture away from heat.
Do not clean furniture with harsh cleansers
or polish. Do not use detergents, Solvents,
abrasives, spray packs or leather cleaner. Use
non-color mild soap with warm water clean
spills(Mix 1:10 soap to water)
Do not place furniture under direct sunlight,
material will possibly fade over time.
Do not use on site dry Cleaning machine.
Children should not climb or jump on the
furniture.
Do not write on furniture without a padded
barrier to protect the surface.
Not for commercial use, For residential use
only.
Weight Limitation
100LBS
2/12

PARTS
LIST
3/12

4/12
Explosive View

5/12
HARDWARE
LIST
Be sure to check all packing material carefully for
small parts, which may have come loose inside the
carton during shipment.
SPARE

6/12
ASSEMBLY
INSTRUCTIONS
Under help of adult partner,
Place the table top #1
& #2 upside down on clean
padded surface, fasten bolt
K by hand and insert wood
dowel C on bottom edge of
top#1 & #2. Insert wood
dowel D and fasten bolt E on
bottom edge of top#1.
Use philips head screw driver
to fasten cam bolt A on bottom of top #2.
Place the partition panel #6 & end panel #3 on clean padded surface,
Use philips head screw driver to fasten cam bolt A on edge of partition
panel #6 & end panel #3.

7/12
Insert cam bolt on end panel #3
through end holes of back panel #8,
fasten cam nut B to secure.
Insert cam bolt A & fasten bolt C/K by
hand on top panel #2 through end
holes of end panel #3 & back panel #8,
use philips head screw driver to fasten
cam nut B to secure and Paste sticker
N to cover the cam nut.Then
use allen key L to fasten flat
washer J,allen nut I to bottom
of end panel #3 and fasten
to secure.

8/12
Insert bolt C/K on top panel #1
through end holes of end panel
#4 & edge holes of shelf #7.
Then insert wood dowel D
to bottom edge and dowel
C on end holes of shelf #7
and have adult partner to
hold other end of shelf #7.
Insert bolt E & wood dowel D on end of top panel #1
through holes on partition panel #6. Then use philips
head screw driver to fasten cam bolt B to secure
partition panel #6 and shelf #7 and use sticker N to
cover cam bolt B.
Bottom

9/12
Insert bolt E & wood dowel D on end of top panel #1 through end holes on top #2
(Make sure the bolt E inserted through half-round gasket F)and cam bolt A through
end holes of back panel #8. Fasten cam bolt B to secure partition panel #6 and back
panel #8 then use sticker N to cover cam bolt B. Use open wrench H to fasten hex nut
G in order to secure top #1 and #2 together then use sticker O to cover the half-round
gasket and nuts.

10/12
Insert bolt K & wood dowel D through end holes of end panel #5, use
allen key L to fasten flat washer J,allen nut I to bottom of end panel #5
and fasten to secure.
Make sure the bottom edge of
end panel #3 & #5 and remove
the protection paper on floor
pad M then carefully align the
pad with edge of end panel
and press it to secure.