Hurricane PRO HGC736489 User manual

OWNER’S MANUAL
READ AND SAVE THESE INSTRUCTIONS
Note: Pictures in the manual are for reference only.
Product #HGC736489
Product #HGC736490
HIGH VELOCITY
PRO
HIGH VELOCITY OSCILLATING
WALL MOUNT FAN 20”/ 30”

CAUTION: Read instructions carefully for safe operation.
SAFETY INFORMATION
WARNING:
1. Unplug the fan before moving it or performing maintenance.
2. DO NOT touch the fan when your hands are wet.
3. Those who are not qualified electricians should not disassemble, repair or rebuild the fan.
3. Unplug the fan when it is not in use.
4. DO NOT unplug the fan by holding the cable cord. Unplug by holding the plug.
5. DO NOT use the fan when there is damage to the cable cord or plug.
6. DO NOT use the fan with extension cord.
7. DO NOT use the fan close to fire.
8. DO NOT insert your hand or other objects into the guard or the movable parts.
9. To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed
control device.
10. If the supply cord is damaged, it has to be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid hazard.
11. DO NOT use this fan outdoors.
CAUTION:
1. Unplug the fan from the socket and clean it with a soft cloth.
2. DO NOT immerse the fan.
3. Fit the guard onto fan before starting up the fan.
4. This fan is not intended for use by people (including children) with reduced physical,
sensory or mental capabilities or lack of experience and knowledge unless they have
been given supervision or instruction concerning use of the fan by a person responsible
for their safety. Supervise children to ensure they DO NOT play with the fan.
CARE AND MAINTENANCE
Unplug the appliance before cleaning. Don’t use any water for cleaning metal surfaces. Slightly
moisten a cloth and then wipe off the surfaces of the fan. In order to remove the dust from the
grill, use a vacuum cleaner or remove the front grill by removing the securing screw on the
edge of the grill with a screwdriver. After cleaning, remount the grill. After doing this, fasten the
securing screw on the edge of the grill.
TECHNICAL SPECIFICATIONS
ITEM NO. SIZE VOLTS/Hz CURRENT (A) CFM RPM
736489 20” 120V/60Hz. 1.35 4600 1100
736490 30” 120V/60Hz. 2.9 7250 1100
2

ASSEMBLY INSTRUCTIONS
Step 1:
a. Mark the hole locations by using the
bracket, and then drill the holes.
b. For concrete wall installation, after drilling,
you would insert the wall anchors and
tap them flush with the wall, position the
bracket and then screw the bolts into
the anchors, securely attaching the wall.
c. For wall stud installation, after drilling the
smaller diameter pilot hole, position the
bracket and screw the two bolts into the
wall until they are secured.
CAUTION: Use the mounting accessories shipped with products for wall mounting
Step 2:
Remove four sets of hexagonal nuts,
spring washers and big washers from
motor. Save them for next step.
Step 3:
Set rear guard in the proper position, and fix
it to the motor by securing the back using the
hexagonal nuts, spring washers and big
washers from last step.
3

Step 4:
Assemble fan blade onto motor shaft by
tightening the two screws which are located
on fan blade. Make sure screw are tightly
secured.
Step 5:
Assemble front guard to rear guard by fixing
both guards together with clips.
Step 6:
Secure the assembly of front guard and rear
guard by tightening a screw and nut at the
bottom position.
4
Rear guard Front guard

Step 7:
First, hang the fan head on the bracket.
Then, fasten using No.1 screw, No.3 spring
washer, No.4 and No. 5 hexangular nut.
Finally, fix No.2 screw or adjusting the tilt
angle of fan head.
OPERATING INSTRUCTIONS
CAUTION: Make sure control is in the “0” (off) position.
1. Connect power plug to any standard 120V AC outlet.
2. The fan comes with two different speeds. Pull power chain once to operate the low speed
and allow to operate for 10 seconds. Once 10 seconds have passed, you may now pull the
power chain to the high position.
PARTS DIAGRAM
PARTS LIST
3
2
1
4
5
5

6
ITEM NO. DESCRIPTION QUANTITY
1 Front grill 1
2 Blade 1
3 Rear grill 1
4 Motor 1
5 Bracket 1

7
NOTES

PRODUCT #HGC736489
PRODUCT #HGC736490
HIGH VELOCITY
METAL DRUM FAN
FOR MORE INFORMATION VISIT:
www.hurricane-fans.com
Exclusively distributed by Hawthorne Hydroponics LLC,
a subsidiary of The Hawthorne Gardening Company,
3204 NW 38th Circle, Vancouver, WA 98660
HawthorneGC.com | Canada: HawthorneGC.ca
©2020. World rights reserved.