Hurricane Supreme Series User manual

CARE & STORAGE
1. BE SURE THE PLUG IS REMOVED FROM OUTLET before
attempting any cleaning or maintenance.
2. Use only a soft, moist cloth with a soap solution.
3. DO NOT immerse the fan in water, and never allow water
to drip into the motor housing.
4. DO NOT use a gasoline thinner or other chemicals to clean fan.
5. To dismantle for cleaning or long-term storage: Follow
assembly instructions in reverse order. The fan blade may
be washed in warm water using a little mild detergent.
Alternatively it may be wiped clean with a soft damp cloth.
Be sure it is completely dry before re-fitting.
6. The front and rear guards can be cleaned with a soft brush
or soft damp cloth.
7. The motor housing and pedestal can be wiped clean with
a soft damp cloth.
8. For storage, clean fan carefully as instructed and store in
it’s original box. Store fan in a clean, dry place.
Fan must be mounted on a vertical wall.
Do not mount
on a ceiling.
Do not mount
on an incline.
Do not mount
on an angle.
• Place the fan base ush to
the hanging bracket.
• Make sure the power cord
does not get pinched.
www.hurricane-fans.com
™
www.hurricane-fans.com
™
16" Oscillating
Wall Mount Fan
Instructions
Supreme Series
D
E
L
A
S
E
R
I
E
S
U
P
R
E
M
O
Use a “QR Code App”
on your smart phone
to access our website
& browse our product
offering or go to:
www.hurricane-fans.com

FAN SETUP
1. Determine the desired location of fan. Mount fan
at least 5 FEET above the floor.
2. Mark the 2 screw holes with a pencil by holding the
hanging bracket to the wall.
3. Drill starter holes at the 2 pencil marks.
4. Insert anchors (not included) into each hole and
lightly tap them flush to the wall with a hammer.
5. Securing the hanging bracket with the 2 provided screws.
6. Hang the fan on the fan base into the hanging bracket.
FAN OPERATION
1. Plug the power cord into a standard 120 volt AC wall outlet.
2. To turn the fan on, gently pull on the chain to select your desired
speed. One pull turns the fan on LOW, two pulls for MEDIUM and
three pulls for HIGH. The fourth pull will turn the fan OFF.
3. TILTING: Always switch off the fan before making any adjustments.
Holding the Rear Motor Cover, tilt the fan head either up or down.
4. OSCILLATION: Press the Oscillation Control Knob down
to make the fan oscillate, pull it up to stop.
INSTRUCTIONS
2 Bracket
Screws
110 VAC
Polarized
Plug
Speed
Control
Knob
110 VAC
Power Cord
Rear Grill
Front Grill
Grill Ring
Clip
Ring Clip
Screw
Fan Blade
Rear Motor
Cover
Pull Chain
Switch
Wall Mount
Bracket
Oscillation
Control Knob
Motor Housing
Motor
Shaft
Spindle
Shaft
Pin Grill Lock
Nut
Blade Cap
1. Use fan only as directed in these instructions. Failure to do so may cause fire,
electrical shock or injury.
2. Intended for household use, not commercial or industrial.
3. DO NOT immerse unit, plug or cord in water or spray with liquids.
4. DO NOT leave children unsupervised around any appliance.
5. Unplug fan from outlet when not in use, when moving fan or before cleaning.
6. Avoid contact with moving parts.
7. DO NOT operate in the presence of explosive and/or flammable fumes.
8. DO NOT place fan or any parts near an open flame, cooking or other heating appliance.
9. DO NOT operate fan with a damaged cord, plug, after the fan malfunctions or after the
fan has been dropped or damaged in any manner.
10. DO NOT use outdoors.
11. DO NOT let cord hang over the edge of a table/counter or let it touch hot surfaces.
12. To disconnect, grip plug and pull from wall outlet. NEVER YANK ON CORD.
13. Always use on a dry, level surface.
14. DO NOT hang or mount fan on ceiling.
15. DO NOT operate without fan grills properly in place.
16. To reduce the risk of shock, the polarized plug is intended to fit in a polarized outlet only
one way (one blade is wider than the other). If the plug does not fit in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician. DO NOT defeat the purpose
of this safety feature.
SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electrical shock and/or injury to persons – DO NOT
use in a window.
WARNING: DO NOT use this fan with any solid state speed control device.
FOLLOW THESE SAFETY PRECAUTIONS CAREFULLY!