HUSAN MONEY SAFE User manual

Important:
-“MONEY SAFE”is made in accordance with European safety and EMC regulation,
attested by the label “CE”fixed on the box.
-Not suitable for the children under 3 years old as the toy is electrical and mechanical in
nature.
-The “MONEY SAFE”is recommended for the ages 6 and up.
Batteries installation:
NOTE: Any batteries purchased for use in the Safe may pose a hazard to children. Please
check safety notice supplied with batteries before use.
There are three “AA / LR6”batteries (excluded) to power the Safe. We recommend using
alkaline batteries only and to never use rechargeable batteries.
Cautions:
-Use fresh batteries of the required size and
recommended type only.
-Do not mix old and new batteries.
-Never mix alkaline batteries with other types of batteries.
-If you do not plan to use the Safe for several weeks,
remove the batteries. Batteries can leak chemicals that
can destroy electronic parts.
Follow these steps for batteries installation.
1. Use a screwdriver to loosen the screws in the battery
compartment cover, then lift up the cover.
2. Put batteries in the compartment as indicated by the
polarity symbols (+ and -) marked inside.
3. Replace the cover and tighten the screws.
If the Safe does not work properly, its lights dim, replace
the batteries.
The “MONEY SAFE” guards your personal stuff. Use the
safe to store things like your play jewelry, playing cards.
The note auto feeder and coins slot at the top lets you use
the safe as a piggy bank.
WF-3001

Using the Safe
To open the Safe, you have to enter a four-digit code. The present code for the Safe is 0000.
You may either use the present code or enter your own.
See “Changing the code”.
Follow these steps to use the Safe.
1. Enter the 4-digit code, the green light switches on. If
you enter the wrong code, the red light switches on and
produces negative sounds.
2. Rotate the knob clockwise and pull open the door.
Green light switches on for about 10 seconds and you
hear creaking sound. If the door is kept on open for
longer than 10 seconds, green lights will be off and
produce beep sound every 20 seconds to remind you
close the door.
3. When you finish, close the door to lock the Safe.
Changing the Code
The factory default code of the Safe is 0000.
To change the code, follow these steps:
1. Enter the current code (default: 0000) and open the
door.
2. Hold the * button down until both green and red lights
flashing.
3. Within 15 seconds, enter the new 4-digit code. Press
# button to store your new code, both lights stop
flashing.
Note: If the new code is not entered within 15 seconds ,
the procedure will terminate and you will have to
restart the changing procedure.
4. Release the * button and close the door of the Safe.
Note: If you forget the code, it can be reset to factory
default by removing and reinstalling the batteries..
Beeps Sound or Voice
1. Move the switch on the back side of door to set the beeps sound or voice.
2. Close the door of the Safe.
Note: The sound setting may be vary by the development in different countries, some
version is without of Voice version.
Auto Note Feeder
-Push the note into the feeder softy, the Safe will catch your note automatically.
Note: To protect your child, do not allow to insert any cards, hard objects or fingers to
the feeder slot. Also, be aware the hairs or clothes being caught in the feeder.