HOLD the magnet in a horizontal
position and place over icons.
The blinking red light will be
immediately followed by a
blinking green light.
Wait 2-10 minutes to allow the sensor
to connect to the server. During this
time you will not see any lights.
You will see a series of green blinks that
indicates the sensor has been successfully
activated. Blinking will last five minutes.
Optional:
At this point,
you can swipe
the magnet to
stop the blinking.
You will immediately see a green
blink followed by a series of red blinks.
When the green light starts blinking,
HOLD the magnet in a horizontal
position and place over icons for 2
seconds, until you get a solid green light.
Remove the magnet when red
light starts blinking.
Remove the magnet.
A single red blink indicates
the sensor is busy.
A single green blink followed by red
blinks indicates the sensor is inactive.
A series of green blinks indicates
the sensor is active.
STATUS CHECK ACTIVATION
Need help?
Scan this QR code for
an activation video!
1 2 3
4 5 6
7 8
