Husqvarna CRT 36-25 User manual

Operator’s manual, EN
Dear customer,
Thank you for choosing a Husqvarna quality product. We hope that you will
genuinely enjoy it.
Please note that the enclosed manual contains Wacker Neuson references.
The Husqvarna Group is vouching for the quality of this product.
If you have any questions, please do not hesitate to contact our local sales or
service point, or visit www.husqvarnacp.com.
Husqvarna AB
SE-561 82 Huskvarna, Sweden
Huskvarna, 2019-12-01
CRT 36-25
CRT 36-26A
1142220-26

Operator’s Manual
Ride-On Trowel
CRT 36-25
CRT 36-26A
Type CRT 36-25, CRT 36-26A
Document 5200001020
Date 0918
Revision 08
Language EN
5200001020

CALIFORNIA Proposition 65 Warning
wc_tx004643en.fm 3
CALIFORNIA Proposition 65 Warning
WARNING
The engine exhaust from this product contains chemicals known to the State of
California to cause cancer, birth defects, or other reproductive harm.
WARNING
Diesel engine exhaust and some of its constituents are known to the State of
California to cause cancer, birth defects, and other reproductive harm.
WARNING
Cancer and Reproductive Harm -
www.P65Warnings.ca.gov.
WARNING
Batteries, battery posts, terminals and related accessories contain lead and lead
compounds, and other chemicals known to the State of California to cause cancer
and birth defects or other reproductive harm. WASH HANDS AFTER HANDLING.
NOTICE! CALIFORNIA AIR RESOURCES BOARD
(CARB): This machine is considered a preempt Off-Road
Applicatoin as relating to CARB standards. The U.S. EPA
has sole authority to establish emission standards for
preempt construction equipment. For more information see
www.arb.ca.gov/msprog/offroad/preempt.htm

CALIFORNIA Proposition 65 Warning
wc_tx004643en.fm
4
Notes

wc_tx001268gb.fm 5
CRT 36 Foreword
Foreword
SAVE THESE INSTRUCTIONS—This manual contains important instructions for
the machine models below. These instructions have been written expressly by
Wacker Neuson Production Americas LLC and must be followed during installation,
operation, and maintenance of the machines.
Machines
covered by
this manual
Machine
documentation
From this point forward in this documentation, Wacker Neuson Production
Americas LLC will be referred to as Wacker Neuson.
Keep a copy of the Operator’s Manual with the machine at all times.
For spare parts information, please see your Wacker Neuson Dealer, or visit the
Wacker Neuson website at http://www.wackerneuson.com/.
When ordering parts or requesting service information, be prepared to provide
the machine model number, item number, revision number, and serial number.
Expectations
for
information in
this manual
This manual provides information and procedures to safely operate and
maintain the above Wacker Neuson model(s). For your own safety and to
reduce the risk of injury, carefully read, understand, and observe all instructions
described in this manual.
Wacker Neuson expressly reserves the right to make technical modifications,
even without notice, which improve the performance or safety standards of its
machines.
The information contained in this manual is based on machines manufactured
up until the time of publication. Wacker Neuson reserves the right to change any
portion of this information without notice.
The illustrations, parts, and procedures in this manual refer to Wacker Neuson
factory-installed components. Your machine may vary depending on the
requirements of your specific region.
Masin Osa nr Masin Osa nr
CRT 36-26A 0620999 CRT 36-25 0620115
CRT 36-26A 0621000 CRT 36-25 0620295
CRT 36-26A 0621001 CRT 36-25 0620803
CRT 36-26A 0621002 CRT 36-25 0620804

wc_tx001268gb.fm
6
Foreword CRT 36
CALIFORNIA
Proposition
65 Warning
Combustion exhaust, some of its constituents, and certain vehicle components
contain or emit chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm.
Laws
pertaining to
spark
arresters
NOTICE: State Health Safety Codes and Public Resources Codes specify that in
certain locations spark arresters be used on internal combustion engines that use
hydrocarbon fuels. A spark arrester is a device designed to prevent accidental
discharge of sparks or flames from the engine exhaust. Spark arresters are
qualified and rated by the United States Forest Service for this purpose. In order to
comply with local laws regarding spark arresters, consult the engine distributor or
the local Health and Safety Administrator.
Manufacturer’s
approval
This manual contains references to approved parts, attachments, and
modifications. The following definitions apply:
Approved parts or attachments are those either manufactured or provided by
Wacker Neuson.
Approved modifications are those performed by an authorized Wacker
Neuson service center according to written instructions published by Wacker
Neuson.
Unapproved parts, attachments, and modifications are those that do not
meet the approved criteria.
Unapproved parts, attachments, or modifications may have the following
consequences:
Serious injury hazards to the operator and persons in the work area
Permanent damage to the machine which will not be covered under warranty
Contact your Wacker Neuson dealer immediately if you have questions about
approved or unapproved parts, attachments, or modifications.

EC Declaration of Conformity
We, Husqvarna AB, SE 561 82 Huskvarna, SWEDEN, Tel. [phone] declare on our sole responsibility
that the product:
Description Concrete Smoothing Machine, Trowel
Brand HUSQVARNA
Type / Model CRT 36-26A
Identication Serial numbers dating from 2019 and onwards
complies fully with the following EU directives and regulations:
Directive/Regulation Description
2006/42/EC
2014/30/EU
“relating to machinery”
“relating to electromagnetic compatibility”
and that the following standards and/or technical specications are applied;
EN 12649:2008+A1:2011
Partille, 2019-12-01
Martin Huber
R&D Director, Concrete Surfaces & Floors
Husqvarna AB, Construction Division
Responsible for technical documentation

Table of Contents
CRT 36
wc_bo5200001020_08TOC.fm 9
CALIFORNIA Proposition 65 Warning 3
Foreword 5
EC Declaration of Conformity 7
1 Safety Information 11
1.1 Signal Words Used in this Manual ..................................................... 11
1.2 Machine Description and Intended Use ............................................. 12
1.3 Operating Safety ................................................................................ 13
1.4 Operator Safety while Using Internal Combustion Engines ............... 14
1.5 Service Safety .................................................................................... 15
2 Labels 17
2.1 Label Locations .................................................................................. 17
2.2 Label Meanings .................................................................................. 19
3 Operation 24
3.1 Features and Controls ........................................................................ 24
3.2 Position of the Operator ..................................................................... 26
3.3 Preparing the Machine for First Use ................................................... 26
3.4 Recommended Fuel ........................................................................... 26
3.5 Break-in Period ................................................................................... 27
3.6 Before Starting ................................................................................... 27
3.7 Starting ............................................................................................... 28
3.8 Stopping ............................................................................................. 28
3.9 Operation ............................................................................................ 28
3.10 Steering .............................................................................................. 29
3.11 Pitch Adjustment ................................................................................ 30
3.12 Emergency Shutdown Procedure ....................................................... 30
4 Maintenance 31
4.1 Maintaining the Emission Control System .......................................... 31
4.2 Periodic Maintenance Schedule ......................................................... 32
4.3 Trowel Gearboxes .............................................................................. 33
4.4 Control Linkage Lubrication ................................................................ 34
4.5 Control Arm Adjustment (Forward or Backward) ................................ 35

Table of Contents CRT 36
wc_bo5200001020_08TOC.fm
10
4.6 Right-hand Control Arm Adjustment (Right or Left) .............................36
4.7 Mounting Float Pans ...........................................................................36
4.8 Transporting the Machine ....................................................................37
4.9 Drive Belt .............................................................................................38
4.10 Battery Jump Start Procedure .............................................................39
4.11 Spark Plug ...........................................................................................40
4.12 Air Cleaner—CRT 36 ..........................................................................41
4.13 Engine Oil and Filter (Honda engine) ..................................................42
4.14 Engine Oil and Filter (Wacker Neuson engine) ...................................43
4.15 Storage ................................................................................................44
4.16 Troubleshooting ...................................................................................45
5 Technical Data 47
5.1 Engine .................................................................................................47
5.2 Trowel ..................................................................................................48
5.3 Sound and Vibration Specifications .....................................................49
6 Emission Control Systems Information and Warranty—Gasoline 50
6.1 Emission Control System Background Information .............................50
6.2 Limited Defect Warranty for Exhaust Emission Control System .........51
6.3 Limited Defect Warranty for Wacker Neuson Evaporative
Emission Control Systems ..................................................................51
7 Schematics 54
7.1 Schematic Components ......................................................................55
8 AEM Safety Manual 57