MULTIQUIP Whiteman HHNG5 User manual

Parts Manual
THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.
To find the latest revision of this
publication, visit our website at:
www.multiquip.com
SERIES
MODEL HHNG5
RIDE-ON TROWEL
(VANGUARD 540000 35 HP GASOLINE ENGINE)
Revision #0 (10/09/13)
PN: 30053


TABLE OF CONTENTS
NOTICE
Specifications and part numbers are subject to change
without notice.
HHNG5 RIDE-ON TROWEL
Table Of Contents.................................................... 2
Parts Ordering Procedures...................................... 3
Explanation Of Code In Remarks Column............... 4
Suggested Spare Parts ........................................... 5
Nameplate And Decals......................................... 6-7
Steering Control Handle Assembly....................... 8-9
Steering Control (Assist) Assembly.................. 10-11
Pivot Assembly ................................................. 12-13
Gearbox Assembly ........................................... 14-15
Pitch Control Tower Assembly .......................... 16-17
Pitch Control Tower Assembly .......................... 18-19
Pitch Control Drive Cable Assembly................. 20-21
Fuel Tank Assembly. ......................................... 22-23
Drive Assembly. ................................................ 24-25
Engine Mounting Assembly.............................. 26-27
Engine Clutch Assembly................................... 28-29
Engine Components 1...................................... 30-31
Engine Components 2...................................... 32-33
Spider Assembly (Left) .................................... 34-35
Spider Assembly (Right) .................................. 36-37
Stabilizer Ring Assembly.................................. 38-39
Seat And Frame Assembly............................... 40-41
Frame And Components Assembly.................. 42-43
Foot Pedals Assembly ...................................... 44-45
Battery Assembly.............................................. 46-47
Spray Assembly................................................ 48-49
Lights Assembly ............................................... 50-51
Front Panel Assembly....................................... 52-53
Top Right Control Panel Assembly ................... 54-55
Harness Assembly............................................ 56-57
E-Z Mover And Lift Handle Assembly............... 58-59
Terms And Conditions Of Sale — Parts ........... 60-61


PARTS ORDERING PROCEDURES
www.multiquip.com
Ordering parts has never been easier!
Choose from three easy options:

When ordering parts, please supply:
❒Dealer Account Number
❒Dealer Name and Address
❒
❒Return Fax Number
❒
❒
❒
✓ UPS/Fed Ex ✓DHL
■Priority One ✓Tr u ck
■Ground
■Next Day
■Second/Third Day
If you have an MQ Account, to obtain a Username
and Password, E-mail us at:


To obtain an MQ Account, contact your
District Sales Manager for more information.

Order parts on-line using Multiquip’s SmartEquip website!
■View Parts Diagrams
■Order Parts
■Print Specification Information
Note: Discounts Are Subject To Change
Goto www.multiquip.com and click on
Order Parts to log in and save!
Use the internet and qualify for a 
on Standard orders for all orders which include
complete part numbers.*

All customers are welcome to order parts via Fax.

1-800-6-PARTS-7 (800-672-7877)
Fax your order in and qualify for a 
on Standard orders for all orders which include
complete part numbers.*
 
1-800-427-1244

International Customers should contact
their local Multiquip Representatives for
Parts Ordering information.

Contact your local Multiquip Dealer for
parts or call 800-427-1244 for help in
locating a dealer near you.
Note: Discounts Are Subject To Change
Effective:
January 1st
, 2006
NOTICE
All orders are treated as Standard Orders and will
ship the same day if received prior to 3PM PST.


EXPLANATION OF CODE IN REMARKS COLUMN
The following section explains the different symbols and
remarks used in the Parts section of this manual. Use the
help numbers found on the back page of the manual if there
are any questions.


   
1 12345 BOLT
.....................1.....INCLUDES ITEMS W/%
2% WASHER, 1/4 IN.
..........NOT SOLD SEPARATELY
2% 12347 WASHER, 3/8 IN.
..1.....MQ-45T ONLY
3 12348 HOSE
..................A/R ...MAKE LOCALLY
4 12349 BEARING
..............1.....S/N 2345B AND ABOVE

  — All items with same unique
symbol
(@, #, +, %, or >) in the number column belong to the
same assembly or kit, which is indicated by a note in the
“Remarks” column.
— Duplicate numbers indicate
multiple part numbers, which are in effect for the same
general item, such as different size saw blade guards in
use or a part that has been updated on newer versions
of the same machine.

— Part numbers can be indicated by a
number, a blank entry, or TBD.
TBD (To Be Determined) is generally used to show a
part that has not been assigned a formal part number
at the time of publication.
A blank entry generally indicates that the item is not sold
separately or is not sold by Multiquip. Other entries will
be clarified in the “Remarks” Column.
NOTICE
The contents and part numbers listed in the parts
section are subject to change . Multiquip
does not guarantee the availability of the parts listed.
NOTICE
When ordering a part that has more than one item
number listed, check the remarks column for help in
determining the proper part to order.


— Item quantity can be indicated by a
number, a blank entry, or A/R.
A/R (As Required) is generally used for hoses or other
parts that are sold in bulk and cut to length.
A blank entry generally indicates that the item is not sold
separately. Other entries will be clarified in the “Remarks”
Column.
 Column
Some of the most common notes found in the “Remarks”
Column are listed below. Other additional notes needed
to describe the item can also be shown.

— All items on the parts list with the
same unique symbol will be included when this item is
purchased.
Indicated by:
“INCLUDES ITEMS W/(unique symbol)”

— Used to list an effective serial
number range where a particular part is used.
Indicated by:
“S/N XXXXX AND BELOW”
“S/N XXXX AND ABOVE”
“S/N XXXX TO S/N XXX”

— Indicates that the part
is used only with the specific model number or model
number variant listed. It can also be used to show a
part is NOT used on a specific model or model number
variant.
Indicated by:
“XXXXX ONLY”
“NOT USED ON XXXX”

— Indicates that the part can
be purchased at any hardware shop or made out of
available items. Examples include battery cables, shims,
and certain washers and nuts.

— Indicates that an item cannot
be purchased as a separate item and is either part of an
assembly/kit that can be purchased, or is not available
for sale through Multiquip.


SUGGESTED SPARE PARTS
NOTICE
Part numbers on this Suggested Spare Parts list may
supersede/replace the part numbers shown in the
following parts lists.


  
1............23365....................BELT, CUT CLUTCH
1............2108......................CAP, SPRAY TANK
1............23970....................CABLE, THROTTLE
1............11029....................CABLE, CHOKE 60"
1............23514....................CAP, RATCHET W/ GAUGE "GASOLINE"
3............20445....................OIL, 24 OZ. BOTTLE
1............23284-300 ............FUSE, 30 AMP
3............23284-100 ............FUSE, 10 AMP
1............22725-600 ............FUSE, 60 AMP
1............22725-200 ............FUSE, 20 AMP
1............12017....................RELAY, KILL
1............23973....................RELAY, 50 AMP
3............491055S ...............SPARK PLUG
3............842921..................FILTER, OIL
2............692519..................FILTER, AIR CLEANER CARTRIDGE
1............692520..................FILTER, PRE AIR CLEANER
1............842109..................SOLENOID, FUEL W/O-RING
5............691035..................FILTER, FUEL
3............842921..................FILTER, OIL
1............841281..................SWITCH, OIL PRESSURE
2............23959-1 ................KEY, IGNITION W/ BOOT
2............2829-1 ..................ARM, TROWEL, SILVER
4............11039....................BUSHING, TROWEL LARGE ARM


NAMEPLATE AND DECALS
E
C
D
B
A
CHECK
GEAR DRIVE
GEAR DRIVE
CHECK
HOT
BELT DRIVE CLOCKWISE
COUNTER
CLOCKWISE
LUBRICATION
LUBRICATION
LIFTING POINTLIFTING POINT
LUBRICATION
LUBRICATION
LIFTING POINT
LUBRICATION
LUBRICATION
Engine exhaust and some of
its constituents, and some dust created
of California to cause cancer, birth
defects and other reproductive harm.
by power sanding, sawing, grinding,
drilling and other constructionactivities
contains chemicals known to the State
Some examples of these chemicals are:
Leadfrom lead-based paints.
Crystallinesilicafrom bricks.
Cementand other masonry products.
Arsenicand chromium fromchemically
treatedlumber.
Your risk from these exposures varies,
dependingonhow often youdothis type
of work. To reduce your exposure to
these chemicals: ALWAYS work in a
well ventilated area, and work with
approved safety equipment, such as
dust masks that are specially designed
to filter out microscopic particles.
CHECK
BELT DRIVE
P/N 36099
To avoid injury,
you MUST read
and understand
operator’s manual
before using this
machine.
Ask for training
as needed.
This machine to
be operated by
qualified
personnel only.
P/N 35137
WARNING
GEAR DRIVE
CHECK
GEAR DRIVE
MODEL
SERIAL NO.
1
6
LIFTING POINT
2E
5
7
3
1
8
2
10
2B
2C
2C
13
2B
12
2A
GREASE DAILY
P/N 23967
11
2D
2D
2E
UNLEADED GAS ONLY
23587
3
45
9


NAMEPLATE AND DECALS
    
1 2634 DECAL, DANGER COMPRESSION 2
2 11246 DECAL, INTERNATIONAL SYMBOLS 1
3 21455 DECAL, WARNING, LIFTING /CRUSHING HAZARD 2
4 23587 DECAL, UNLEADED GAS ONLY 1
5 35168 DECAL, WARNING, ROTATING BLADE HAZARD 2
6 36099 DECAL, HELMET, BOOT, GLOVES (ISO BLUE) 1
7 35137 DECAL, WARNING READ MAN., ASK FOR TRAINING 1
8 23235 BADGE, FOOT PLATFORM 1
9 13118 DECAL, POWDER COATED 1
10 DECAL, SERIAL PLATE, EPA EVAP ................................... 1........... CONTACT MQ PARTS DEPT.
11 23967 DECAL, GREASE DAILY 1
12 20525 DECAL, WARNING CA PROP 65 1
13 36090 DECAL, WARNING VENTILATION 1


STEERING CONTROL HANDLE ASSY.
SEE SPRAY ASSY.
24
8
22
23
22
34
23
2
34
27
32
18
34
23
32
9
6
28
4
3
11
RIGHT SIDE
31
33
33
7
5
16
LEFT SIDE
13
9
13
4
3
11
26
23
19
10 10
2
1
29
20
10
17
25
23
2
19
15
15
12
30
2
15
36
37
NOTES:
1
1
FOR COMPLETE STEERING ASSY
ORDER PART# 30061.


STEERING CONTROL HANDLE ASSY.
    
1 0131 A SCREW, HHC 1/4-20 X 3/4" 4
2 0447 WASHER, FLAT, 1/2 SAE 3
3 0735 BEARING, CONE, TIMKEN #A6075 4
4 0735 A BEARING, CUP, TIMKEN #A6157 4
5 07046-011 BOLT, CARRIAGE 5/16-18X1-1/2" GR5 ZINC 8
6 2197 NUT, ACORN 1/4-20 2
7 2219 PIN, COTTER 1/8" X 1-1/2" 2
8 22762 GRIP HANDLE, LEFT-RIGHT 2
9 5277 SCREW, HHC 1/4-20 X 1-1/2" 2
10 EM963105 SCREW, HHC 1/2-13 X 2" 3
11 8151 WASHER, FLAT, 3/4" SAE 4
12 10024 NUT, NYLOC 1/4-20 4
13 49071 NUT, NYLOC 3/8-16 8
15 10176 NUT, NYLOC 1/2-13 4
16 11138 BEARING, P-BLOCK HOUSING 47MPB 4
17 11139 HOUSING SET, BEARING FLANGE 40M-2 6
18 22405 SPACER, .75 X .50 X 2.0 1
19 11142 ROD END, 1/2-20 MALE RH 11
20 11143 ROD END, 1/2-20 FEMALE RH 1
22 11145 SCREW. SHC 1/2-20 X 3" PLTD 2
23 11146 NUT, HEX JAM 1/2-20 5
24 11149 BEARING, SB-204-12 4
25 11150 BEARING, SB-201-B 6
26 11172 ROD, L/R MOTION CONTROL 1
27 22404 NUT, COUPLING, 1/2-20 X 2.0 X .75 HEX 1
28 11177 HANDLE TUBE, UPPER 2
29 12193 LEVER, L/R MOTION 1
30 12903 STEERING CONTROL W/A LS ASSIST 1
31 12904 STEERING CONTROL W/A RS ASSIST 1
32 12425 HANDLE , LOWER 2
33 12426 NUT, SLOTTED 3/4-16 PLATED 2
34 21944 ROD END, 1/2-20 M RH W/ CUSTOM BALL 3


STEERING CONTROL (ASSIST) ASSY.
NOTES:
1SEE STEERING CONTROL
HANDLES ASSY.
PART OF FRAME.
2
1
1
1
2
311
15
15
4
10
14
8
8
4
4
4
12
13
11
8
3
4
8
4
20 2
5
11
8
6
9
1
16
13
19
18
17 2712
5
13
13
13
8
12
12 20
12
12
12
2
2
2