Huvema Jarrer WL R15LD Series User manual

THE ART AND SCIENCE OF LIGHTING
To prevent accidents and appliance damage,
read these instructions before installation or
use.
INSTRUCTION MANUAL
WL R15LD SERIES LED WORK L AMP

JML-R15 SERIES LED WORK LAMP
SAFETY INFORMATION
The work light has been designed
to meet the latest standard and
manufactured with high-quality
materials, tested by standard process.
Still, the use of the product may
constitute a risk to persons or cause
material damage.
Explosion hazard
This lamp is not designed for use in
flammable and explosive areas.
Do not operate the lamp in hazardous
location.
Electrical Safety
Compare the mains voltage with the
nominal voltage and the hertz specified
on the product and make sure that they
are identical.
Do not connect a damaged cable.
Bright light source exposure risk
Placed the lighting in an angle to avoide
looking directly into the light source.
Do not look directly into the light source.
Ambient temperature
The allowed ambient temperature for the
light will be around 40°C.
Avoide direct exposure to the sunlight.

JML-R15 SERIES LED WORK LAMP

GENERAL INFORMATION
Intended purpose:
Stationary light for working machines.
Place of use:
For use on working machines.
Operating mode:
The light is designed for continuous
operation.
Classifications:
Protection class IP20.
Product dimensions:
LD
TD
MD
JML-R15 SERIES LED WORK LAMP
Model watt Volt
WL R15MD
14 AC 100V-240V
WL R15LD
WL R15TD

INSTALL THE LAMP
Mounting:
The light must be mounted on an
stable, non-flammable surface with the
included screws.
The user has to verify the reliability when
using mounting elements which have
not been proposed by the manufacturer.
Putting into operation:
Before operating the light, please check
whether the mains voltage is identical to
the rated voltage specified on the rating
plate.
JML-R15 SERIES LED WORK LAMP

MAINTENANCE AND REPAIR
Disconnect the light from the
power source before carrying
out any maintenance or repair work!
This work may only be carried out by a
qualified electrician!
Disconnect a damaged connecting cable
immediately from the power supply and
have it replaced by the manufacturer or
by a qualified electrician.
Only parts approved by the manu-
facturer may be used as spare parts.
Cleaning:
Clean the transparent shade regularly to
ensure maximum brightness.
Please use a cloth impregnated with a
normal household detergent to clean the
lamp components.
Please ensure that the detergent used
are compatible with paints and plastics.
JML-R15 SERIES LED WORK LAMP