HydroSure 100205202 User manual

HydroSure Hose Reel Cart
SKU: 100205202
Height - 38.5” (98cm)
Width - 22”(56cm)
Length Incl. Handle - 33”(84cm)
Length Excl. Hanlde - 25”(64cm)
Capacity:
13mm (1/2”) = 125m
19mm (3/4”) = 70m
25mm (1”) = 30m
Specications:

Package Contents

Assembly Instructions
Insert the two Side Frame (B) into the U-Tube (A). In-
sert Bolt (P) into one of the holes of the U-Tube and
tighten with Lock Nut (R) using the provided Wrench
(U) and Allen Wrench (V). Repeat on the other side.
Place Rear Cross Tube (C), with the holes facing up,
between Side Frames (B). Secure with Bolts (P) on
both sides of the Side Frames with Allen Wrench (V).
Insert Axles (D) into the Axle Holes on both Side
Frames.
3.
2.
1.

Making sure the Tire Stem faces outward, slide the
Pneumatic Tires (E) on end of the Axles. Secure the
tires with Washers (T) and Lock Nuts (S) on the end
of the Axle with the Wrench (U).
NOTE: Do not over tighten the Lock Nut.
Insert Handle (F) into the ends of the Side Frames
(B). Secure by using a Bolt (P) and Lock Nut (R)
Align the holes of the Bearing Seat (G) with the
holes on the U-Tube (A). Secure both sides of the
Bearing Seat with one Nut (R) and Bolt (P).
NOTE: The plastic bushing is not attached to the
Bearing Seat and may be loose in the parts kit.
The Plastic bushing is necessary for smooth rota-
tion of the Crank.
4.
5.
6.

Locate the Reel Flange (H) and place it on one end
of the Hose Drum (I). Secure the Reel Flange and
Hose Drum together using 3 Bolts (P). Repeat for the
other Reel Flange.
Slide the In/Out Tube (J) into the centre hole of the
Hose Drum
Insert the long end of the J-Bolt (K) into one of the
remaining two holes on the end of the Hose Drum.
Slide the J-Bolt down until it hooks over the In/Out
Tube and the short end slides into the second hold
on the Hose Drum. The Long end of the J-Bolt wil
exit the rear of the Hose Drum.
Secure the J-Bolt using Nut (R).
7.
8.
9.

Insert the Crank Hub End of the Hose Drum into the
Bearing Seat (G) that is attached to the U-Tube.
Locate the Bearing Seat (G) on the IN/Out Tube to
secure the Hose Coupling End of the Hose Drum to
the Rear Cross Tube (C). Align the holes on the Bear-
ing Seat with the holes on the Rear Cross Tube and
fasten using Bolt (P) and Nut (R)
10.
11.

Insert Crank (L) into the Crank Hub of the Hose
Drum. Align the holes in the Crank with the holes in
the Crank Hub and secure using Bolt (Q) and Nut (R).
12.