Hygger HG028 User manual

USER MANUAL
MODEL:HG026
MODEL:HG028

2.HG026 PRODUCT PARAMETERS AND INSTRUCTION
(1)Unpack the box and check if the light and other accessories are included. If missing
parts, please contact the seller.
(2)Install the Holder onto the edge of the aquarium and secure it with the screws. The
Holder must be secured firmly enough to prevent the light from falling into the water.
(3)Position the fixture over the hole of the "Holder" by adjusting the "Stand bar" to a proper
height so that it can securely hold the fixture in place.
(4)Connect the power supply with the light, then plug it in. Ensure a drip loop is created
before the outlet as shown in the warning.

3.HG028 PRODUCT PARAMETERS AND INSTRUCTION
(1)Unpack the box and check if the light and other accessories are included. If missing
parts, please contact the seller.
(2)Expand both sides’ metal bracket fit to match the length of your aquarium.
(3)Connect the power supply with the light, then plug it in. Ensure a drip loop is created
before the outlet as shown in the warning.

If you encounter the following situation:
1.Your phone can't connect to the APP light
2. Connect to a new mobile device
Please plug and unplug the DC supply three times, each time with an
interval of 10 seconds.
After the indicator blinks for three times, the device is reset successfully
and ready for pairing.

FOR HG028 RESET
FOR HG026 RESET
2.After 10 seconds, unplug and
plug in the connector between
the light and the power adapter
3 times
3.Then wait for a few seconds, the
light will flash, at this time, the light
has been reset and can be found by
TUYA APP
1.Plug in the power adapter
12 3
unplug and
plug in 3 times

09
SOLUTION 1:
If power failure or going out, causing the APP connection to be disconnected.
Step1. In the Doodle APP interface directly drop down to update.
SOLUTION 2:If power failure or going out, causing the APP connection
to be disconnected. Tthere is no need to reset the operation, just turn on
the Bluetooth again and click on the main doodle interface to refresh it.
The default value is 3 minutes.