hylite MIGHTYLITE Manual

Installation & operating instructions
Job Light
INSTRUCTION MANUAL
8W, 16W & 28W Rechargable Job Light with H Stand

HYLITE MIGHTYLITE JOB LIGHT– INSTALLATION AND OPERATING INSTRUCTIONS
The Mightylite Job Light is compact and lightweight with an extremely tough polycarbonate casing. Utilizing the
latest bright LEDs. Making it perfect for use in all working environments.
The unit will function using 110/230 AC 50Hz using a adaptor cable.
IMPORTANT SAFETY INSTRUCTIONS
PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL AND OPERATE
THIS LIGHT.
IMPORTANT INSTALLATION INSTRUCTIONS
IMPORTANT OPERATION & MAINTENANCE INSTRUCTIONS
DO NOT position the light near flammable or combustible materials (such as wood, cloth, paper) or near flammable,
combustible or explosive liquids, solids, gases or equipment.
DO NOT direct the light into a person’s eyes. This light has a very intensive light output, which if incorrectly used
could cause eye damage.
ALWAYS disconnect the power supply before servicing or performing any maintenance.
ALWAYS maintain the light in good condition, with repairs only undertaken by a qualified electrician.
ONLY carry out repairs using genuine parts. Non-authorized parts may be dangerous and will invalidate the warranty.
230V - 110V. Auto select. For 110V usage, use 110V plug with adaptor or
hardwire 110V plus
TROUBLE SHOOTING
If your Job Light does not operate after following all of the instructions, please try the following steps:
- Check that the ON switch is in the correct position
- Check that the battery is installed correctly.
- Check that the battery is charged (look at the charge level LED’s)
CONTENTS OF KIT
1, 1x Job Light
2, H stand, Handle & 4x rubber feet
3, Battery
4, USB Charger (500ma/1000ma)
5, Fixing kit
2x Long Knurled Bolt,
2x Plastic Washers
1x Mightylite Job Floodlight 1x H Stand Kit &
4x Rubber Feet
1x Battery 4x H Stand Clips

2
From Left to right:
- Charge Level: indicators for
the battery charge level.
- Charging: indicates when the
Job Light is charging.
- Battery OK: battery check LED.
- USB (500ma/1000ma)
- DC Jack + inner.
HOW TO OPERATE THE JOB LIGHT:
Fully charge before use.
Slide and lock the battery to the unit.
Charge by mains, car or laptop via the USB charge point.
Check the charging levels via the charge level indicator.
Once charged you can operate the Job Light.
The Mightylite can be powered from either USB port or the power jack connected to a 5V 500ma or 1000ma power
supply. On the unit there are five LEDs. Three red LEDs together, these indicate the battery charge level.
Next to the charge level LEDs there is a charging LED indicator, when charging this will flash red, when the battery is
fully charged it will turn green. If this LED is flashing orange it indicated the battery is not connected correctly and the
unit will not function. The LED marked battery ok indicates that the unit is connected to an external power source and
the systems are functioning.
To operate, unplug from external power source and switch on. Note; that the LEDs indicators will briefly flash through
an initialisation set up, the lamp will now illuminate. The power of the lamp can be adjusted by switching the power
switch on and off within 2 seconds this will reduce the lamp by 50% and increase the battery life. Repeat again and it
will reduce to 25% and again double the battery life.
When the fitting is plugged into the charger the floodlight cannot be used.
Within10 seconds of charging the Mightylite will go out and will now operate in emergency mode, if the power is then
removed from either the DC jack or the USB input then the light will illuminate after10 seconds.
BATTERY CONDITION LED
BATTERY LIFE (APPROXIMATE):
Charge time = Full charge 6hrs
8W Tool Light
Description
16W Tool Light
28W Tool Light
8Hrs 24Hrs 36Hrs12Hrs
2AH 4AH 6AH 12AH 18AH
4Hrs
4Hrs
2Hrs 12Hrs 18Hrs6Hrs
2Hrs 6Hrs 9Hrs3Hrs1Hr
16Hrs 48Hrs 72Hrs24Hrs
2AH 4AH 6AH 12AH 18AH
8Hrs
8Hrs
4Hrs 24Hrs 36Hrs12Hrs
4Hrs 12Hrs 18Hrs6Hrs2 Hrs
High Power 100% Medium Power 50% Low Power 25%
4Hrs 12Hrs 18Hrs6Hrs
2AH 4AH 6AH 12AH 18AH
2Hrs
2Hrs
1Hrs 6Hrs 9Hrs3Hrs
1Hrs 3Hrs 4.5Hrs1.5Hrs30 Min
IMPORTANT
The unit will not operate correctly unless it is fully charged.
• Check the contents in the box
• Build the H Stand as shown on the next page using the clips provided and make sure the handle is secure.
• Mount the H Stand Job Light using the KNURLED BOLTS provided.
• Slide on the battery to the back of the Job Light until it’s clipped securely into place.
• Charge the battery before you use the Job Light.
• Once fully charged the Job Light can be used.
Disconnect the battery and place somewhere safe when not in use.

-WARNING: LI-ION BATTERY WARNING
Take great care when handling the battery.
Lithium-ion cells and battery packs may get hot, explode or ignite and cause serious injury if exposed to extreme conditions.
Be sure to follow the safety warnings listed below:
Do not connect the positive terminal and negative terminal of the battery to each other with any metal object (such as wire).
Do not carry or store battery together with necklaces, hairpins or other metal objects.
Do not pierce the battery with nails, strike the battery with a hammer, step on the battery or otherwise subject it to strong
impacts or shocks.
Do not expose battery to water or salt water, or allow the battery to get wet.
Do not place the battery in or near fire, on stoves or other high temperature locations.
Do not place the battery in direct sunlight, or use or store the battery inside cars in hot weather. Doing so may cause the
battery to generate heat, explode or ignite. Using the battery in
this manner may also result in a loss of performance and a shortened life expectancy.
Do not disassemble or modify the battery.The battery contains safety and protection devices, which, if damaged, may cause the
battery to generate heat, explode or ignite.
Immediately discontinue use of the battery if, while using, charging or storing the battery, the battery emits an unusual smell, feels
hot, changes colour or shape, or appears abnormal in any other way.
Do not place the battery in microwave ovens, high-pressure containers or on induction cookware.
In the event the battery leaks and the fluid gets into your eye, do not rub the eye. Rinse well with water and immediately seek
medical care. If left untreated, the battery fluid could cause damage to the eye.
MIGHTYLITE
KNURLED BOLT
PLASTIC
WASHER
HANDLE
SIDE PANEL OF ‘H’ STAND
RUBBER FEET
Global Tech China Ltd 3 Floor,Wai Yip Industrial Building.
171 Wai Yip Street, Kwun Tong, Kowloon, Hong Kong.
1 2 3 4
ON/ OFF
within 2 Secs
(100%, 50%, 20%)