HYPER TOY COMPANY 1:10 HIGH SPEED DRIFT TRUCK User manual

MADE IN CHINA
FULL FUNCTION LITHUM BATTERY
USB CHARGER
This device complies with Industry Canada licence-exempt RSS 210 standard. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
1:10 HIGH SPEED DRIFT TRUCK

CONTENTS
BATTERY INSTALLATION
FUNCTIONS
TROUBLESHOOTING
Vehicle Remote Controller
Back of Remote Controller
Bottom of Vehicle
Instruction Manual
Rechargeable Battery
(Installed Inside Vehicle)
USB Charging Cable
ON / OFF switch
DEMO MODE
BACKWARD
Wheel Alignment
TURN RIGHT
TURN LEFT
TURN LEFT once to wake up
from sleep mode.
5 minstes without input will go
to SLEEP MODE.
DRIFT FRONT LEFT
DRIFT LEFT
DRIFT BACK LEFT
DRIFT FRONT RIGHT
DRIFT RIGHT
DRIFT BACK RIGHT
FORWARD
1) Removed battery cover by
pressing the clip on top of the cover.
2) Put 2 1.5V AA batteries in the
battery slots with correct polarity.
3) Close the battery cover.
ON / OFF switch
Charging the Battery: 150 minutes
1) Remove the battery cover by
loosen the screw
2) Disconnect the battery from the
vehicle.
3) Connect USB power output from
USB plug / Computer USB to the
battery.
4) When finished charging,light on
USB will turn off.
1) Unscrew the screw which locate
on battery cover by screw driver.
2) Put the rechargeable battery in
the battery slots and connect it to
the vehicle.
3) Close the battery cover and tight
the screw with screw driver.