INSTRUCTION MANUAL FOR 30W DIMMABLE LED DRIVER
MODEL NO.: HE4030-A
WIRING DIAGRAM
Switch-Dim wiring diagram 1-10V wiring diagram
SYNCHRONIZATION
Up to 50pcs drivers can be connected to the same switch, thanks to the programme. This means there is no need for any additional
synchrony wire in large installation, where many drivers should be controlled by one switch.
Please follow the steps below to achieve synchronization function if more than one driver are connected to the same push botton:
Press the push button for more than 1s (long push), then a short push (<1s). Now the devices are switched off.
Long push the button, the system is now synchronized.
SWITCH-DIM
push and hold to dim On/off control: short push (<1s) on the switch.
Note: Short push should be at least 0.12s, and the time interval between two pushes should be longer than
0.12s also.
Stepless dimming: long push (>1s) on the switch.
For fine tuning of light level: with every other long push, the light level goes to the opposite direction.
Built--in with permanent memory: light returns to the previous dimming level when switched off and on again,
even at power failure.
Note: 1. Default setting is “1-10V” dimming.
2. This “1-10V” output is isolated, SELV output.
3. To shift dimming from “Switch-Dim” to “1-10V”, the end-user should short-circuit “1-10V” first for at least 3s.
30.5
53.5
4.1
122.8
150
3rd Floor, block C, complex building, 155#, Bai'gang road south,
Bai'gang village, Xiao Jin Kou town, Huicheng district, Huizhou 516023
Tel:86-752-2772020 F:86-752-2777877
CHINA FACTORY
Room D, 10/f, Tower A, Billion Center, 1 wang Kwong Road,
Kowloon Bay, Kowloon, Hongkong
T: 00852-35197525 F: 00852-30116936
HYTRONIK INDUSTRIAL LIMITED
