Hyundai HY3000I User manual

MADE UNDER LICENSE OF HYUNDAI CORP. SEOUL, KOREA
Basic HY3000I HY6000I HY7000I HY9000I
Economic HY2500 HY3100 HY6000 HY7000 HY9000
Professional HY2500L(S) HY3100L(S)(E) HY6000L(S)(E)
HY7000L(S)(E)-(3) HY9000L(S)(E)-(3)
GASOLINE POWER GENERATORS
USER MANUAL
CHECK CAREFULY THIS USER MANUAL IN ORDER TO AVOID INJURIES
EN

INDEX
1. SAFETY INFORMATION
2. COMPONENTS
3. CHECK BEFORE USE
4. START OF THE ENGINE
5. STOP OF THE ENGINE
6. MAINTENANCE
7. PROBLEM/SOLUTIONS
8. SPECIFICATIONS
1
2
3
4
5
5
8
9

1
1. SAFETY INFORMATION
Before use of the machine please read carefully this manual
Any use of the generator without reading this manual could cause hard
damage to the machine o can hurt yourself seriously
Pay special attenction to the next:
• Do not use the generator in a non ventilated area
• Do not use the generators in wet conditions
• Do not start the generator when device plug.
• Keep at least 1 meters from flammable objects
• Do not refill the fuel tank with the generator running
• Do not smoke when fuel refill
• Do not overfill the fuel
SAFETY GUARDS:
1. Do not use kerosene or other fuel, only use gasoline fuel.
Clean all the excess of fuel when refill.
2. Any flammable or explosive product shall be kept away from
the generator, due to the high temperature of the engine.
3. Install your group on a flat, horizontal surface, to avoid spilla-
ge of gasoline.
4. Inhalation of exhaust gas:
The exhaust gases contain poisonous carbon monoxide. Never
use the group in a poorly ventilated area
5. Never touch the exhaust when the generator is running or
after starting.
6. Short circuits:
Do not touch your group with wet hands. The generator is not
waterproof, so it should not be exposed to water or snow.
7. Other safety points:
Yon must know how to absolutely stop your group before using it.
Never allow someone to use the generator without having read the
manual! Always wear a safety shoes and keep you always ready to
clean rags. Keep children and pets away

2. COMPONENTS
1 Frame
2 Muffler
3 Fuel tank
4 Air filter
5 Carburetor
6 Sockets
7 Earth connection
8 Recoil starter
9 On/Off switch
10 Oil dip
11 Fuel valve
12 Spark plug
13 Fuel tank
14 Oil drain
1 Frame
2 Muffler
3 Fuel tank
4 Air filter
5 Carburetor
6 Sockets
7 Earth connection
8 Recoil starter
9 On off swich / Key contactor
10 Oil dip stick
11 Fuel valve
12 Spark plug
13 Fuel tank
14 Oil drain
2
3
3
3
4
8
8
9
9
10
10
11
11
1
1
1
1
2
2
4
4
5
5
6
6
7
7
12
12
13
13
13
14
14
2

3. CHECK BEFORE USE
Control the oil level when the unit is off.
1. Take the dipstick and wipe with a clean cloth.
2. Place the dipstick without turning.
3. Check the level on the dipstick mark
3. If the level is below the mark, fill to the mark
4. Screw the dipstick
Fuel level
1. Open the fuel cap of the fuel tank
2. Check the level of the fuel
3. Fill with fuel up to the prime fuel filter
4. Screw the fuel cap
Air filter
1. Loosen the filter housing and remove the air filter
2. Remove the screw and washer, and remove the filter element
3. Remove filter
4. Clean it with water, do not use soup
5. Dry the filter complete and place it again in the filter housin.
6. Tight the filter housing
3

4. START OF THE ENGINE
1. Before start the engine, do not connect to device.
2. Place the fuel valve on "ON"
3. Place the starter in position "OPEN"
4. Set switch to "ON"
5a. MANUAL START: Slowly pull the starter until it becomes
"harder" then yank.
5b. ELECTRIC START: Turn the key to the start position and
them relase
6. Replace the Starter in place
PRECAUTIONS
1. Do not conectec several devices at the same time
2. Run your generator for about 3 minutes without connecting
devices.
3. All appliances require a higher power at startup. Ask your
dealer to check if your generator is suitable for your appliance
4. Connect one device after the other, respecting the maximum
power allowed for your generator.
5. Be sure all appliances are in good working condition before
connecting to the Group.
6. If a device does not work anymore or stops suddenly, stop
IMMEDIATELY using the main switch and unplug the unit and
check. Do not forget to desconnect any device before stop the
generator. Stop the generator with power connected can damage
the machine
7. If the value on the voltmeter is too high, stop the machine
and check the dysfunction. If the value shown on the voltmeter is
230V + / - 10% (50 Hz), the generator can be restarted.
8. DC: Do not use the 12V along with the 230. Connection to
the DC should be used for loading "rechargeable" 12V. When
charging batteries, make sure the correct polarity (+ to + and - to
-). Make the connection to the battery first, then your generator.
9. Connecting your generator on a network requires the
intervention of an electrician.
10. The improper connection of the latter can cause serious
damage.
4

5. STOP THE ENGINE
Turn off power connected to the generator
Set the switch to "OFF"
Turn the fuel valve to "OFF"
Note
In case of emergency to stop your group's position switch to
"OFF"
6. MAINTENANCE
It is very important to effecuer following maintenance controls and
to ensure the proper functioning of your group.
The Group consists of the gasoline engine and an AC generator,
frame, etc..
Stop the unit before any maintenance. Make sure your group is
located in a ventilated area to avoid carbon monoxide poisoning.
Clean your group with a dry cloth to prevent corrosion on it.
Element Every day Every month
or every 20h Every 3 month
or every 50h
Every 6 months
or every 100h Every year
or every 300h
Check oil level o Check
Change oil o Replace o Replace
Check air filter o Check
Clean fuel filter o Clean
Oil carte o Clean
Oil filter o Clean
Spark plug o Clean
Spark plug o Check and
asjust
Spark plug o Clean
Fuel tank Replace every 3 yearsor when necesary
5

6. MAINTENACE
Replace engine oil
1. Unscrew and remove the dipstick
2. Unscrew the drain plug and drain the oil in the crankcase.
3. Tighten the drain plug after drained.
4. Fill the crankcase until the maximum level gauge
5. Reposition the dipstick and tighten.
It is recomend to run the engine for 15min before replace the oil
Oil tipe:
4-stroke gasoline engine oil recommended SAE 10W-30
Air Filter
1. Undo or loosen the filter housing and remove the air filter
2. Remove the screw and washer, and remove the filter element
3. Remove filter
4. Clean it with water and dry complete
5. Place the filter in the housing
6. Filx the housing
6

6. MAINTENANCE
SPARK PLUG
1. Disconnect the spark plug cable
2. Unscrew and remove the spark plug housing
3. Clean the spark plug with a wire brush
4. Check the electrode gap
5. Screw the spark plug and its connect cable
Spark plu type:
F6RTC or F7RTC
FUEL FILTER
1. Position fuel valve to "OFF" and remove the fuel filter
2. Clean fuel filter
3. Replace the O-ring tank after cleaning to ensure tightness.
HIVERNAGE
In case of prolonged storage of your generator do the following:
1. Unscrew the screw of the carburetor bowl to empty its
contents.
2. Unscrew the oil drain screw and drain the oil from the crank-
case
3. Screw the oil cap after refilling with new oil
4. Fill the oil to the max.
5. Slowly pull up the pitcher has to feel a hard spot (this opera-
tion is intended to close the valves and prevent corrosion in
your engine).
7

7. PROBLEM/SOLUTIONS
CASE SOLUTION
The Engine does
not start
- No oil in the engine - Oil level is too low
- Main switch in not in on position
-positionner l'interrupteur principal
sur "ON"
- Fuel valve close/not fuel - Open the fuel valve, fill fuel in
the fuel tank
- There is no ignition - Check ignition coil and spark plug
- Spark plug fouled - Clean the spark plug with a metal
brush
Thegeneratorisnot
givingpower
- The main circuit breaker is not in
ON position - Place main circuit breaker to on
position. UP
-Plugs on the generator - Check the plugs are in good
conditions
- The engine speed is not enought - Check with your dealer
8