Hyundai HYVI75-2 User manual

WET - DRY VACUUM
HYVI75-2
User manual
FOR YOUR SAFETY
You must Read and understand
this manual before use.
Keep this manual for future
reference.

Page 2

Page 3
SAFETY DIRECTIONS
IMPORTANTSAFEGUARDS
When using an electrical appliance, basic precautions should always be followed, including
the following;
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
To reduce the risk of fire, electric shock or injury;
• Do not use outdoors.
• Do not leave the vacuum cleaner plugged in. Turn off the power switch and unplug the power
cord when not in use or before servicing.
• Do not allow it to be used as a toy. Great care should be taken when used by or nearchildren.
• Use only as described in this manual. Only use attachments recommended by themanufacturer.
• Do not use the vacuum cleaner if the cord or plug is damaged.
• Do not pull or carry the vacuum cleaner by pulling on the cord, do not use the cord as a handle,
do not close the door on the cord, or pull the cord around sharp edges or corners. Do not place
the vacuum cleaner on the cord. Keep the cord away from heated surfaces.
• Do not use extension cords or outlets with an inadequate current carrying capacity.
• Turn off all controls before unplugging.
• Do not unplug by pulling on cord. To disconnect, grasp the plug, not the cord.
• Do not handle the plug or vacuum cleaner with wet hands or operate without shoes.
• Do not put any objects in the openings. Do not use with any blocked opening; Keep it free of
dust, lint, hair and anything that can reduce airflow.
• This vacuum cleaner creates suction and contains a rotating brush. Keep hair, loose clothing,
fingers and all body parts away from openings and moving parts.
• Do not pick up anything that is burning like cigarettes, matches or hot ashes. • Do not use
without the dust cup or filter in place.
• Use extra care when cleaning stairs.
• Do not use to collect flammable or combustible liquids such as gasoline, or to use in areas where
they may be present.
• Store your cleaner in a cool, dry place.
• Be sure to turn the unit off at least every 15 minutes (for 1 minute) to cool the engine. Failure to
do so may result in engine failure.
• DO NOT use this unit for more than 4 hours (including breaks).

Page 4
PARTS NAME
Power Switch
Curved Extension Tubes
Hose
Drain Pipe
Carpet Brush
Crevice Attachment
Hard Floor / Water Attachment
Bristle Brush

Page 5
OPERATION METHOD
Insert the hose connector into
the hose socket
Hose
connector
socket
Hose
connector
Handle
Insert the handle into the tube with
a twisting force
Extension tube
Extension tube
Insert the handle into the tube with
a twisting force

Page 6
OPERATION METHOD
Extension tube
Floor brush
Insert the handle into the tube with
a twisting force
Tube storage
PLEASE NOTE
We have included larger accessories with
this vacuum more suited for higher
domestic and industrial cleaning.
These attachments will not fit in the Tube
Storage locations.

Page 7
OPERATION METHOD
Hold the plug and insert into socket
ON/OFF Switch
Press the switch button to
turn ON/OFF the cleaner
NOTICE: It is not allowed to turn ON both switches at the same
time, they must be turned on one by one.
For safety there is a waterproof cover this must be replaced if it
becomes torn or damaged
You can adjust the airflow by
pushing the sliding block UP and
DOWN

Page 8
TO REPLACE DUST BAG
When the dust barrel is full you must empty it as soon as possible
Release the locking lever to
open-up the housing
Empty the dust barrel
Take out
Drain
liquid

Page 9
MAINTENANCE
WARNING; When the filters and covered with dust or the suction decreases considerably,
please clean the filters. This will improve the working efficiency and extend the life of the
cleaner. NEVER use the machine without filters
Twist the locking knob with an anti-clockwise
force and take off the filters
Sponge filter
Clean filter carefully
Dry by airing
Replace the filter

INSTALLATION INSTRUCTIONS
Page 11
Locking
pin
Wheel
Cover Washer
Support
tube
Attach the large wheel to the support tube, place the washer, then fix it
with the locking pins, finally cover the wheels with their respective covers.
(The method of installation is the same for both sides.
Lock nut
Lock nut
Casters
Put the casters into the caster mounting
holes, then secure in place using the M12
locking nuts

SPECIFICATION
Page 10
Air Flow (CBM/Min)
Dust capacity (L)
Motor type
Wattage (W)
Voltage/Frequency
Flexible hose
G.W/N.W
Fully assembled dimensions
In the box
3.0 ± 0.1
75 L
2-Stage - Low noise 1200W motors
2400 W
220-240V/50Hz
1.5m x Φ40 mm
23.6/20.6 KG
622mm x 526mm x 935mm
Main unit –Flexible hose –
Wet dry floor brush –
Stainless steel extension tube –
Crevice nozzle –
Dusting brush
DECLARATIONS of CONFORMITY
Genpower Ltd confirms that this Hyundai product conform to the following CE
Directives;
2006/42/EC Machinery Directive
2004/108/EC EMC Directive
2006/95/EC Low Voltage Directive

HYUNDAI Corporation
25, Yulgok-ro 2-gil, Jongno-gu,
Seoul 03143, Korea,
Post Code : 03143
Copyright2016HYUNDAICorporationAllrightsreserved.
Made inP.R.C
Importedinto UK
by GENPOWER
GENPOWER LTD
IsaacWay,LondonRoad
Pembroke Dock, UNITED KINGDOM, SA72 4RW T:
[phone]F:[phone]
E: [e-mail]
www.hyundaipowerproducts.co.uk