i-gatU CS-20 User manual

3
2
Zip Tie
Rubber
Bracket
Wheel Magnet Set
Rubber Bracket Set
Cadence
Magnet
Extension
Rubber
Zip Tie
Device Overview
Install Sensor
Install Cadence Magnet Set
Install Wheel Magnet Set
1
Cadence Sensor
Sensing Point
Speed Sensor
Sensing Point
Battery CoverTest Key
Cadence Magnet Set
for crankarm
Top View
IMPORTANT NOTE
Align Cadence Magnet with Cadence Sensor
Sensing Point as shown. Proper distance between
sensor and magnet should be less than 10 mm
Install Cadence Magnet on left crankarm near pedal
as shown. Do not tighten zip ties completely to
allow magnet placement. Use Extension Rubber for
proper distance adjustment
Top View
IMPORTANT NOTE
Align Wheel Magnet with Speed Sensor Sensing
Point as shown. Proper distance between sensor
and magnet should be less than 10 mm. Use screw
driver for proper distance adjustment.
Pre-t Sensor and Rubber Bracket on left rear
chainstay (non-drive side) and trim excessive
rubber from bracket. Ensure the battery cover is
facing up. Install zip ties loosely to allow sensor
placement.
Unscrew the wheel magnet
to install on spoke.
For Round Spokes
For Bladed Spokes
Cadence
Magnet
Cadence Sensor
Sensing Point
CS-20 Speed & Cadence Sensor User’s Guide
INSTALLATION

Adjust angle and position of sensor to achieve recommended
gap distance range and align sensing points.
IMPORTANT NOTE
Please make sure the Battery Cover is
securely sealed to prevent unexpected
water leakage
GAP <10 mm
GAP <10 mm
Turn the crankarm clockwise to pass the Cadence
Sensor Sensing Point. The Test Key LED should start
ashing if the device is installed properly.
Press the Test Key on the Sensor to enter Test
Mode for 60 seconds.
CS-20 Speed & Cadence Sensor User’s Guide
5
6
Test Speed and Cadence Sensor with Magnet Sets
Assemble and Change Battery
Adjust Sensor and Magnet Sets
4
Spin the wheel counterclockwise to pass the Speed
Sensor Sensing Point. The Test Key LED should start
ashing if the device is installed properly.
Use a coin to unclinch the Battery Cover.
Lithium Battery ( CR2032 )
O-ring : waterproof component
Remove the battery inside with a
new one, then close the battery
cover onto the device.
After entering Test Mode and tested
successfully, use the needle nose plier
to help tighten the zip tie and make sure
the Sensor is securely installed on the
left rear chainstay. Then use the plier
to trim o excessive zip tie.
Caution
1. The device can be used in rain but should not be used underwater.
2. The position of Sensor and gaps between Sensor and magnets
should be checked periodically.
3. Do not use corrosive chemicals to clean the device.
4. Do not disassemble the device.
Connect to Speed & Cadence Sensor
Supported Apps can be downloaded at iTunes App Store. After
installing the downloaded App, follow the instructions in App to
complete Bluetooth connection to the Speed and Cadence Sensor.
Note: The Bluetooth interface is disabled by default. Bluetooth
connection will be established when the Bike is moving and
Speed or Cadence data is detected.
Supported Devices & Software
This device is a Bluetooth® 4.0 device, compatible and applicable with
many iOS devices, including:
• iPhone 4S / iPhone 5
• The New iPad / iPad 4 / iPad mini
• iPod Touch 5
In addition, this device has been tested to work with various Apps,
listed in the following link:
http://global.mobileaction.com/SCS-support.jsp