I-GO EMERGENCY CHARGER User manual

A/W 8330377-01 REV. C
Material: 80g art paper
Congratulations on your iGo®power
purchase! Compatible with today’s most
popular devices, this iGo emergency charger
uses two standard AA batteries to add
hours of runtime to all of your devices. Use
the iGo emergency charger to power your
mobile phone, Bluetooth®headset,
smartphone/PDA, MP3 player, portable gaming
device and more with this single, convenient
power solution.
Patented iGo®Tip Technology
iGo power products deliver the precise
amount of power required by your device
through the use of patented tip technology.
This way, you don’t have to worry about
selecting the correct amount of power as you
do with other products – we do it for you!
Simply attach the appropriate iGo power tip
(sold separately) and you are ready to get
energized.
User Guide
For use with:
Specifications
Output Voltage: 4.2-6 VDC
Output Power: Up to 5 Watts
Output Current: Varies (up to 800mA)
Dimensions: 3.6 x 1.9 x .89"
(94.44 x 48.266 x 22.61mm)
Safety Features
Current limit
Short circuit protection
Thermal protection
Package Contents
• iGo emergency charger
• 2 AA batteries
• User guide
©2002-2008 iGo, Inc. iGo is a registered trademark of iGo, Inc. All
other brand names and logos are trademarks or registered trademarks
of their respective owners. Specifications are subject to change without
notice. Protected under one or more of the following patents:
5,347,211, 6,967,885 and D506,981. Other United States and foreign
patents pending. Made in China. P/N 8040377-01 Rev. C.
Fo
emergency charger
powerXtender_UG_2:Layout 1 10/28/2008 12:30 PM Page 1

Quick Connect Guide
OPEN
1. TO OPEN: Hold the unit logo side up
with the bottom towards you. Push the
latch to the left while pulling the case apart
to remove battery cover.
2. Insert AA batteries as indicated by
battery diagrams and replace battery cover.
3. Plug the appropriate iGo power tip onto
the charger.
4. Insert the power tip connector into the
device you wish to charge.
5. Turn on charger. Blue indicator
light should be illuminated.
6. To replace the batteries in your unit, use
new AA batteries and repeat steps 1
through 3.
Note: Flashing blue light indicates that the
batteries are low and have less than 25% of
power remaining.
Carefully read this Quick Connect Guide before
using this iGo charger for the first time. Incorrect
usage can result in your equipment not charging.
iGo power tips are required (sold separately).
Unit may shut off prematurely when used with
select devices. If this occurs, turn the unit off and
disconnect from the device.Wait 10 minutes and
connect again.
For best results:
• Charge your device before its battery
becomes fully exhausted.
• Charge your device while it is off.
• Use premium batteries for maximum runtime.
Before using this charger, please read this
important information:
• Turn off and disconnect when charging is
complete.
• Turn off and disconnect when the batteries
in the charger are depleted.
• Some devices may display inaccurate battery
charge indications when connected.
• Do not mix new and old batteries.
• Do not mix battery chemistries.
• Remove batteries from this charger when
not in use for extended periods of time.
• The charger batteries may become
warm during the charging process. Wait for
batteries to cool before removing them.
• From a fully discharged device battery, it may
take several minutes of charging for the
device to become operable.
• Some device/tip connections may not be
able to support the weight of the charger
unit. Charge these devices on a flat surface.
iGo®emergency charger
Additional iGo®power tips
(sold separately)
OPEN
latch
OPEN
powerXtender_UG_2:Layout 1 10/28/2008 12:30 PM Page 2