Getting Started:
1. Connect the 24VDC power as shown on the connector
below.
2. Install i3Configurator (V9.30 or later) onto your PC.
3. Connect serial programming cable into port MJ1 or USB
cable to mini USB port.
4. If using the mini USB port, or a USB to serial convertor,
please check in Window Device Manager which com
port has been assigned. Then enter menu Tools->Editor
Options->Communications port->Configure, and set
accordingly.
5. Press the ‘SYS’ function key on the front of the unit and
check Network ID. Then press the target sign in the
Configurator and make the Target ID match that of the i3
WARNING: Please ensure power is ON and i3is in Idle
mode before inserting SanDiskMicroSD.
This equipment is suitable for use in Class I, Division 2,
Groups A, B, C and D or Non-hazardous locations only
WARNING: EXPLOSION HAZARD –Do not disconnect
equipment unless power has been switched off or the area is known to be
non-hazardous.
AVERTISSEMENT - RISQUE D'EXPLOSION - AVANT
DE DECONNECTOR L'EQUIPMENT, COUPER LE COURANT OU
S'ASSURER QUE L'EMPLACEMENT EST DESIGNE NON
DANGEREUX.
WARNING:To avoid the risk of electric shock or burns, always
connect the safety (or earth) ground before making any other connections.
WARNING: To reduce the risk of fire, electrical shock, or physical
injury it is strongly recommended to fuse the voltage measurement inputs.
Be sure to locate fuses as close to the source as possible.
WARNING:Replace fuse with the same type and rating to provide
protection against risk of fire and shock hazards.
WARNING:In the event of repeated failure, do not replace the fuse
again as a repeated failure indicates a defective condition that will not
clear by replacing the fuse.
WARNING: EXPLOSION HAZARD –Substitution of
components may impair suitability for Class I, Division 2
AVERTISSEMENT - RISQUE D'EXPLOSION - LA
SUBSTITUTION DE COMPOSANTS PEUT RENDRE CE MATERIAL
INACCEPTABLE POUR LES EMPLACEMENTS DE CLASSE 1,
DIVISION 2
WARNING:The USB parts are for operational maintenance only. Do
not leave permanently connected unless area is known to be non-
hazardous.
WARNING: EXPLOSION HAZARD - BATTERIES MUST
ONLY BE CHANGED IN AN AREA KNOWN TO BE NON-
HAZARDOUS
AVERTISSEMENT - RISQUE D'EXPLOSION - AFIN
D'EVITER TOUT RISQUE D'EXPLOSION, S'ASSURER QUE
L'EMPLACEMENT EST DESIGNE NON DANGEREUX AVANT DE
CHANGER LA BATTERIE
WARNING: Battery May Explode If Mistreated. Do Not Recharge,
Disassemble or Dispose Of In Fire
WARNING: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved
should install, adjust, operate, or service this equipment. Read and
understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in
severe bodily injury or loss of life.
