IBM E400 User manual

IBM E400 PROJECTOR
User’s Guide


IBM E400 PROJECTOR
User’s Guide


Note: Before using this information and the product it supports, read the information in
Appendix D, “Service and Support,” on page D-1 and Appendix E, “IBM Statement of
Limited Warranty - Z125-4753-07 - 11/2002,” on page E-1
Second Edition (February 2004)
© Copyright International Business Machines Corporation 2004. All rights reserved.
US Government Users Restricted Rights – Use, duplication or disclosure restricted by GSA ADP Schedule Contract
with IBM Corp.

Contents
Safety information . . . . . . . . . .v
General safety information . . . . . . vii
Service . . . . . . . . . . . . . . . . vii
Power cords and power adapters . . . . . . . vii
Extension cords and related devices . . . . . . viii
Plugs and outlets . . . . . . . . . . . . viii
Batteries . . . . . . . . . . . . . . . viii
Heat and product ventilation . . . . . . . .ix
CD and DVD drive safety . . . . . . . . . .ix
Registering your option . . . . . . . .xi
Preface . . . . . . . . . . . . . . xiii
Chapter 1. Introduction . . . . . . . 1-1
Chapter 2. Setting up the projector . . 2-1
Starting and shutting down the projector . . . . 2-1
Adjusting the projector height . . . . . . . . 2-2
Positioning the projector . . . . . . . . . . 2-2
Adjusting the zoom, focus and keystone . . . . 2-3
Adjusting the volume . . . . . . . . . . . 2-4
Chapter 3. Connecting devices to the
projector . . . . . . . . . . . . . 3-1
Connecting devices . . . . . . . . . . . 3-1
Chapter 4. Using the projector features 4-1
Using the remote control . . . . . . . . . . 4-1
Inserting the remote control batteries . . . . . 4-2
Operating range . . . . . . . . . . . . 4-3
Projector and remote control buttons . . . . . . 4-3
Chapter 5. On-Screen Display menu
controls . . . . . . . . . . . . . . 5-1
Navigating the OSD . . . . . . . . . . . 5-1
Setting the OSD language . . . . . . . . 5-1
Quality menu . . . . . . . . . . . . 5-1
Properties menu . . . . . . . . . . . 5-4
Options menu . . . . . . . . . . . . 5-5
Setup menu . . . . . . . . . . . . . 5-6
Information menu . . . . . . . . . . . 5-8
Appendix A. Maintenance . . . . . . A-1
Cleaning the lens . . . . . . . . . . . . A-1
Replacing the projection lamp . . . . . . . . A-1
Resetting the lamp timer . . . . . . . . . A-3
Using the security slot . . . . . . . . . . A-3
Appendix B. Troubleshooting . . . . B-1
Projector LEDs . . . . . . . . . . . . . B-2
Appendix C. Specifications . . . . . C-1
Appendix D. Service and Support . . . D-1
Online technical support . . . . . . . . . D-1
Telephone technical support . . . . . . . . D-1
Appendix E. IBM Statement of Limited
Warranty - Z125-4753-07 - 11/2002 . . . E-1
Part 2 - Country-unique Terms . . . . . . . E-4
Part 3 - Warranty Information . . . . . . . E-15
Appendix F. Notices . . . . . . . . . F-1
Trademarks . . . . . . . . . . . . . . F-2
Electronic emission notices . . . . . . . . . F-2
Federal Communications Commission (FCC)
statement . . . . . . . . . . . . . . . F-2
© Copyright IBM Corp. 2004 iii

iv IBM E400 PROJECTOR: User’s Guide

Safety information
Before installing this product, read the Safety Information.
Antes de instalar este produto, leia as Informações de Segurança.
Pred instalací tohoto produktu si prectete prírucku bezpecnostních instrukcí.
Læs sikkerhedsforskrifterne, før du installerer dette produkt.
Ennen kuin asennat tämän tuotteen, lue turvaohjeet kohdasta Safety Information.
Avant d’installer ce produit, lisez les consignes de sécurité.
Vor der Installation dieses Produkts die Sicherheitshinweise lesen.
Prima di installare questo prodotto, leggere le Informazioni sulla Sicurezza.
Lees voordat u dit product installeert eerst de veiligheidsvoorschriften.
Les sikkerhetsinformasjonen (Safety Information) før du installerer dette produktet.
Antes de instalar este produto, leia as Informações sobre Segurança.
Antes de instalar este producto lea la información de seguridad.
© Copyright IBM Corp. 2004 v

Läs säkerhetsinformationen innan du installerar den här produkten.
vi IBM E400 PROJECTOR: User’s Guide

General safety information
Always observe the following precautions to reduce the risk of injury and property
damage.
Service
Do not attempt to service a product yourself unless instructed to do so by the IBM
Support Center. Use only an IBM authorized service provider who is approved to
repair your particular product.
Note: Some parts can be upgraded or replaced by the customer. These parts are
referred to as Customer Replaceable Units, or CRUs. IBM expressly identifies CRUs
as such, and provides documentation with instructions when it is appropriate for
customers to replace those parts. You must closely follow all instructions when
performing such replacements. Always make sure that the power is turned off and
that the product is unplugged from any power source before you attempt the
replacement. If you have any questions or concerns, contact the IBM Support
Center.
Power cords and power adapters
Use only the power cords and power adapters supplied by the product
manufacturer.
Never wrap a power cord around the power adapter or other object. Doing so can
stress the cord in ways that can cause the cord to fray, crack or crimp. This can
present a safety hazard.
Always route power cords so that they will not be walked on, tripped over, or
pinched by objects.
Protect the cord and power adapters from liquids. For instance, do not leave your
cord or power adapter near sinks, tubs, toilets, or on floors that are cleaned with
liquid cleansers. Liquids can cause a short circuit, particularly if the cord or power
adapter has been stressed by misuse. Liquids can also cause gradual corrosion of
the power cord terminals and/or the connector terminals on the adapter which can
eventually result in overheating.
Always connect power cords and signal cables in the correct order and ensure that
all power cord connectors are securely and completely plugged into receptacles.
Do not use any power adapter that shows corrosion at the ac input pins and/or
shows signs of overheating (such as deformed plastic) at the ac input or anywhere
on the power adapter.
Do not use any power cords where the electrical contacts on either end show signs
of corrosion or overheating or where the power cord appears to have been
damaged in any way.
© Copyright IBM Corp. 2004 vii

Extension cords and related devices
Ensure that extension cords, surge protectors, uninterruptible power supplies, and
power strips that you use are rated to handle the electrical requirements of the
product. Never overload these devices. If power strips are used, the load should
not exceed the power strip input rating. Consult an electrician for more
information if you have questions about power loads, power requirements, and
input ratings.
Plugs and outlets
If a receptacle (power outlet) that you intend to use with your computer
equipment appears to be damaged or corroded, do not use the outlet until it is
replaced by a qualified electrician.
Do not bend or modify the plug. If the plug is damaged, contact the manufacturer
to obtain a replacement.
Some products are equipped with a three-pronged plug. This plug fits only into a
grounded electrical outlet. This is a safety feature. Do not defeat this safety feature
by trying to insert it into a non-grounded outlet. If you cannot insert the plug into
the outlet, contact an electrician for an approved outlet adapter or to replace the
outlet with one that enables this safety feature. Never overload an electrical outlet.
The overall system load should not exceed 80 percent of the branch circuit rating.
Consult an electrician for more information if you have questions about power
loads and branch circuit ratings.
Be sure that the power outlet you are using is properly wired, easily accessible,
and located close to the equipment. Do not fully extend power cords in a way that
will stress the cords.
Connect and disconnect the equipment from the electrical outlet carefully
Batteries
All IBM personal computers contain a non-rechargeable coin cell battery to provide
power to the system clock. In addition many mobile products such as Thinkpad
notebook PCs utilize a rechargeable battery pack to provide system power when in
portable mode. Batteries supplied by IBM for use with your product have been
tested for compatibility and should only be replaced with IBM approved parts.
Never attempt to open or service any battery. Do not crush, puncture, or incinerate
batteries or short circuit the metal contacts. Do not expose the battery to water or
other liquids. Only recharge the battery pack strictly according to instructions
included in the product documentation.
Battery abuse or mishandling can cause the battery to overheat, which can cause
gasses or flame to “vent” from the battery pack or coin cell. If your battery is
damaged, or if you notice any discharge from your battery or the buildup of
foreign materials on the battery leads, stop using the battery and obtain a
replacement from the battery manufacturer.
Batteries can degrade when they are left unused for long periods of time. For some
rechargeable batteries (particularly Lithium Ion batteries), leaving a battery unused
in a discharged state could increase the risk of a battery short circuit, which could
viii IBM E400 PROJECTOR: User’s Guide

shorten the life of the battery and can also pose a safety hazard. Do not let
rechargeable Lithium-Ion batteries completely discharge or store these batteries in a
discharged state.
Heat and product ventilation
Computers generate heat when turned on and when batteries are charging.
Notebook PCs can generate a significant amount of heat due to their compact size.
Always follow these basic precautions:
v Do not leave the base of your computer in contact with your lap or any part of
your body for an extended period when the computer is functioning or when
the battery is charging. Your computer produces some heat during normal
operation. Extended contact with the body could cause discomfort or, potentially,
a skin burn.
v Do not operate your computer or charge the battery near flammable materials or
in explosive environments.
v Ventilation slots, fans and/or heat sinks are provided with the product for safety,
comfort, and reliable operation. These features might inadvertently become
blocked by placing the product on a bed, sofa, carpet, or other flexible surface.
Never block, cover or disable these features.
CD and DVD drive safety
CD and DVD drives spin discs at a high speed. If a CD or DVD is cracked or
otherwise physically damaged, it is possible for the disc to break apart or even
shatter when the CD drive is in use. To protect against possible injury due to this
situation, and to reduce the risk of damage to your machine, do the following:
v Always store CD/DVD discs in their original packaging
v Always store CD/DVD discs out of direct sunlight and away from direct heat
sources
v Remove CD/DVD discs from the computer when not in use
v Do not bend or flex CD/DVD discs, or force them into the computer or their
packaging
v Check CD/DVD discs for cracks before each use. Do not use cracked or
damaged discs
General safety information ix

x IBM E400 PROJECTOR: User’s Guide

Registering your option
Thank you for purchasing this IBM
®
product. Please take a few moments to
register your product and provide us with information that will help IBM to better
serve you in the future. Your feedback is valuable to us in developing products
and services that are important to you, as well as in developing better ways to
communicate with you. Register your option on the IBM Web site at
http://www.ibm.com/pc/register/
IBM will send you information and updates on your registered product unless you
indicate on the Web site questionnaire that you do not want to receive further
information.
© Copyright IBM Corp. 2004 xi

xii IBM E400 PROJECTOR: User’s Guide

Preface
The IBM
®
E400 projector can be used for both business presentations and home
entertainment and is easy to connect, use, and maintain.
In addition to this User’s Guide, your option package contains the following:
1 Projector with lamp housing and lens cap included
2 Remote control
3 Two AAA batteries
4 USB cable
5 S-video cable
6 Video cable (DVI-DB15) to VGA
7 Audio cable (Mini Jack-to-RCA)
8 Power cord
9 Composite video cable
10 User’s Guide (and installation) CD
11 Multi-language Quick Start guide
12 Carrying case
© Copyright IBM Corp. 2004 xiii

If any of the items listed above are missing or damaged, contact your place of
purchase.
Note: Be sure to retain your proof of purchase; it will be required to receive
warranty service.
For information on optional accessories for your projector, please go to
http://www.ibm.com.
Attention:
v Avoid using the projector in dusty environments.
v Do not obstruct the vent openings of the projector.
v Leave the power cable plugged in (for 2-5 minutes) until the projector returns to
room temperature before placing the projector inside the soft case. Placing the
projector into the case too soon after switching off the power could cause the
projector to overheat and will shorten lamp life.
v Be sure to attach the lens cap and place the projector into the soft case to avoid
damaging the lens.
xiv IBM E400 PROJECTOR: User’s Guide

Chapter 1. Introduction
The figures below show the features of the projector.
1 Lens/focus
2 IR receiver
3 Connectors
4 Power cord connector
5 Leveling foot
6 Elevator foot
7 Elevator foot adjuster button
Figure 1-1. Front right view of projector
© Copyright IBM Corp. 2004 1-1

1 Zoom
2 Focus
3 Power
4 System status LEDs
5 Control buttons
6 Source button
7 Menu button
8 Auto button
9 Speaker
Figure 1-2. Top view of projector
1-2 IBM E400 PROJECTOR: User’s Guide

Figure 1-3. Top view of the control buttons
and LEDs on the projector
1 Power (LED)
2 Ready (LED)
3 Keystone/Up cursor
4 Volume/ Right cursor
5 Enter button
6 Keystone/ Down cursor
7 Volume/ Left cursor
1 Audio-in
2 RS-232
3 DVI-I
4 AC socket
5 Composite video
6 S-video
7 USB
8 Security slot
Figure 1-4. Connectors
Chapter 1. Introduction 1-3

1 Projection lamp cover
2 Elevator foot
3 Leveling foot
4 Ceiling support holes
Figure 1-5. Bottom view of the projector
1-4 IBM E400 PROJECTOR: User’s Guide