ICC ICRESAV42L User manual
Video Splitter Modules
2 GHz Video Splitters can support up to eight locations, offering a choice of 4, 6, or
8-ports, and are designed for installation in ICC’s Net.Media Centers. The Video
Splitters receive and distribute CATV, antenna, satellite, or modulated video
signals up to eight analog or digital television sets.
Deluxe Series Video Splitter Modules
INSTALLATION INSTRUCTIONS
Residential Cabling Solutions
ASSEMBLY INSTRUCTIONS
16800 Edwards Road, Cerritos CA 90703 • 562-356-3111 • Fax 562-356-3100
© Copyright 2006, ICC. ICC and ICC logo are registered trade name and trademark. All rights reserved. MSR-0411-2 REV C
2 GHz Video Splitter, 1 piece
A
Fasteners, 4 pieces
B
ICRESAV42L
ICRESAV62L
ICRESAV82L
INCLUDES:
A
Step 1.
1. Place module horizontally and align fasteners
with the peg board. Make sure the fasteners are
NOT in locked positions.
Step 3.
3. Once module bracket is in the desired location,
push the fasteners to their lock position.
Step 2.
2. Push the module so that the fasteners goes into
the peg board of the enclosure.
Fasteners (4x)
Splitter
Enclosure
Module Bracket
B
Step 4.
4. Prepare an incoming coaxial cable and outgoing coaxial cable by using ICC’s coax cable stripper tool (ICACSCSCTV), All-in-One Universal
Compression tool (ICACSCT01U), and F-type compression connectors (ICRDSAV01F for RG-6, and ICRDSAV04F for RG-6 Quad-Shield). Connect
the incoming cable to the “IN” port of the splitter and the outgoing coaxial cables to the “OUT” ports. The “OUT” ports route the video signal to each
location.
ASSEMBLY INSTRUCTIONS
This manual suits for next models
5
