idatastart ADS-CH4 User manual

REMOTE CAR STARTER
OWNER’S GUIDE
COMPATIBLE WITH:
ADS-CH4, ADS-CH5,
ADS-CH7, ADS-FO1,
ADS-GM2, ADS-GM7,
ADS-GM10, ADS-HA6,
ADS-HA7, ADS-NI5
CONFORMITY
FCC COMPLIANCE
This device complies with FCC rules, and is subject to the
following conditions:
(1) This device may not cause harmful interference.
(2) This device may accept interference received, including
interference that may cause undesired operation.
INDUSTRY CANADA COMPLIANCE
This device complies with the RSS-210 Radio Standards
Specification from IC.
NOTE: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority
to operate this device.
OGALL201501E

OWNER'S GUIDE
2www.idatastart.com © Automotive Data Solutions Inc.
WELCOME TO IDATASTART!
Congratulations on the purchase of your iDataStart remote start system. You are now moments
away from enjoying the added comfort of remote start along with the factory features you love.
Please take a moment to review the following operating instructions.
REMOTE STARTING YOUR VEHICLE
The following vehicles can be remote started by using your factory keyfob.
See vehicle coverage and instructions below:
VEHICLE BUTTON ACTION FUNCTION
CH4, CH5, CH7, FO1, GM10, HA6 (All models)
GM2 (2007-2012 models only)
GM7 (Std. key models only)
NI5 (2007-2008 models only)
Press 3x rapidly Start engine
Press 3x rapidly Stop engine
The following vehicles require the installation of aftermarket remotes sold separately.
See vehicle coverage and instructions below:
VEHICLE ACTION
GM2 (2004-2006 models only)
GM7 (Flip-key models only)
HA7 (All models)
NI5 (2009+ models only)
Refer to your aftermarket RF kit owner’s
manual for details
AFTER REMOTE STARTING
A ‘Key Takeover’ procedure is required to keep the engine running before driving.
See table below.
KEY TAKEOVER PROCEDURE
Step 1 Unlock and enter vehicle
Step 2 Insert key into ignition and turn to ON position
Step 3 Press foot brake
NOTE: If foot brake is applied before inserting key into ignition, the vehicle engine will shut down.

OWNER'S GUIDE
3
© Automotive Data Solutions Inc. www.idatastart.com
DIAGNOSTICS
Your vehicle didn’t remote start? Count your parking light flashes for a system diagnostic and
apply the listed solution.
# OF PARKING
LIGHT FLASHES DIAGNOSTIC SOLUTION
3 + 1 Engine is already running Turn engine OFF
3 + 2 Key in ignition at ON position Remove key from ignition
3 + 4 Trunk is open Close trunk
3 + 5 Foot brake is ON Release foot brake
3 + 6 Hood is open Close hood
3 + 8 Tach failure Contact Authorized Dealer
3 + 10 System is in Valet Mode Exit Valet Mode
3 + 11 Can communication failure Contact Authorized Dealer
3 + 12 Remote starter not synced Perform System Sync Procedure
SYSTEM SYNC PROCEDURE
Step 1 Start engine with key
Step 2 Let engine run for at least 15 seconds
Step 3 Turn engine OFF
For any additional assistance, contact your Authorized Dealer.
WHEN SERVICING YOUR VEHICLE
To ensure safety during vehicle servicing the remote starter must be placed in ‘Valet Mode’.
The ‘Valet Mode’ will disable remote start functionality. To activate or deactivate the ‘Valet Mode’,
follow the instructions below:
COMMAND ACTION # OF PARKING
LIGHT FLASHES
Activate Valet Mode Cycle ignition ON/OFF 5x rapidly. 2 + 1
Deactivate Valet Mode Cycle ignition ON/OFF 5x rapidly. 2 + 2

OWNER'S GUIDE
4www.idatastart.com © Automotive Data Solutions Inc.
LIMITED LIFETIME WARRANTY
Automotive Data Solutions Inc. (“ADS”) warrants to the original purchaser of the iDataStart
product that the control module and installation harness shall be free of defects in material and
workmanship under normal use and circumstances, for as long as the original purchaser owns
the vehicle in which it was originally installed.
In the event of any product malfunction during the Warranty period, the original purchaser
must return to the Authorized Dealer where it was originally purchased with the original proof
of purchase. If a malfunction is detected, the Authorized Dealer will elect to repair or replace
the product at its discretion. Labor costs may be applicable and are at the discretion of the
Authorized Dealer.
The Limited Lifetime Warranty is automatically void if:
• An original proof of purchase is not provided when servicing the product
during the warranty period;
• The date code and/or serial number is defaced, missing, or altered;
• The iDataStart product is transferred to another vehicle;
• The vehicle in which the product was originally installed is transferred to a new owner.
ADS is not responsible for any damages whatsoever, including but not limited to any
consequential damages, incidental damages for loss of time, loss of earnings, commercial loss
of economic opportunity and the like that may or may not have resulted from the installation or
operation of an iDataStart product.
CUSTOMER SUPPORT
• For all questions regarding to the functionality of your iDataStart remote start system,
contact your local Authorized iDataStart Dealer.
• For all other questions or comments call Automotive Data Solutions Inc.
toll-free at 866.427.2999.