idatastart BM1 User manual

REMOTE CAR STARTER
OWNER’S GUIDE
COMPATIBLE WITH:
ADS-BM1
Bm1
CONFORMITY
FCC COMPLIANCE
This device complies with FCC rules, and is subject to the
following conditions:
(1) This device may not cause harmful interference.
(2) This device may accept interference received, including
interference that may cause undesired operation.
INDUSTRY CANADA COMPLIANCE
This device complies with the RSS-210 Radio Standards
Specification from IC.
NOTE: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority
to operate this device.
OGBM201310E
www.eldibg.com
car audio & multimedia system

OWNER'S GUIDE OWNER'S GUIDE
2 3
Bm1Bm1
WELCOMETOIDATASTART!
Congratulations on the purchase of your iDataStart remote start system. You are now moments
away from enjoying the added comfort of remote start along with the factory features you love.
Please take a moment to review the following operating instructions.
REMOTESTARTINGYOURVEHICLE
Your iDataStart system is designed to remote start directly from your factory key fob*.
See table below:
BUTTON ACTION FUNCTION
Press 3x rapidly Start engine
Press 3x rapidly Stop engine
*Compatible long-range aftermarket remotes are also available
and sold separately. Ask your Authorized Dealer for details. DIAGNOSTICS
Your vehicle didn’t remote start? Count your parking light flashes for a system diagnostic and
apply the listed solution.
# OF PARKING
LIGHT FLASHES DIAGNOSTIC SOLUTION
3 + 1 Engine is already running Turn engine OFF
3 + 2 Key in ignition at ON position Remove key from ignition
3 + 4 Trunk is open Close trunk
3 + 5 Foot brake is ON Release foot brake
3 + 6 Hood is open Close hood
3 + 8 Tach failure Contact Authorized Dealer
3 + 10 System is in Valet Mode Exit Valet Mode
3 + 11 Can communication failure Contact Authorized Dealer
3 + 12 Remote starter not synced Perform System Sync Procedure
SYSTEM SYNC PROCEDURE
Step 1 Start engine with key
Step 2 Let engine run for at least 15 seconds
Step 3 Turn engine OFF
For any additional assistance, contact your Authorized Dealer.
WHENSERVICINGYOURVEHICLE
To ensure safety during vehicle servicing the remote starter must be placed in ‘Valet Mode’.
The ‘Valet Mode’ will disable remote start functionality. To activate or deactivate the ‘Valet Mode’,
follow the instructions below:
COMMAND ACTION # OF PARKING
LIGHT FLASHES
Activate Valet Mode Cycle ignition ON/OFF 5x rapidly. 2 + 1
Deactivate Valet Mode Cycle ignition ON/OFF 5x rapidly. 2 + 2
AFTERREMOTESTARTING
A ‘Key Takeover’ procedure is required to prevent the engine from inadvertently shutting down
before driving. See below for instructions for vehicles with and without ‘Comfort Access’:
FOR VEHICLES WITH ‘COMFORT ACCESS’ SYSTEM
Step 1 Unlock and enter the vehicle
Step 2 Apply the foot brake to complete the takeover
IMPORTANT: If your ‘Comfort Access Sytem’ features are NOT functional following remote start,
please follow the key takeover procedure for vehicles WITHOUT Comfort Access as listed below.
FOR VEHICLES WITHOUT ‘COMFORT ACCESS’
Step 1 Unlock and enter the vehicle
Step 2 Insert the key fob into the key port*
Step 3 Apply the foot brake to complete the takeover
*The usual key ‘pull’ motion will NOT be heard, the key port will charge your key battery normally.
ADJUSTINGYOURDRIVERSETTINGS
When remote starting, your climate and radio preferences will remain in their last positions
by default. Your seating preferences will not auto-adjust, but can be activated via the pre-pro-
grammed buttons beside your seat.
www.eldibg.com
car audio & multimedia system

OWNER'S GUIDE
4
Bm1
LIMITEDLIFETIMEWARRANTY
Automotive Data Solutions Inc. (“ADS”) warrants to the original purchaser of the iDataStart
product that the control module and installation harness shall be free of defects in material and
workmanship under normal use and circumstances, for as long as the original purchaser owns
the vehicle in which it was originally installed.
In the event of any product malfunction during the Warranty period, the original purchaser
must return to the Authorized Dealer where it was originally purchased with the original proof
of purchase. If a malfunction is detected, the Authorized Dealer will elect to repair or replace
the product at its discretion. Labor costs may be applicable and are at the discretion of the
Authorized Dealer.
The Limited Lifetime Warranty is automatically void if:
•Anoriginalproofofpurchaseisnotprovidedwhenservicingtheproduct
during the warranty period;
•Thedatecodeand/orserialnumberisdefaced,missing,oraltered;
•TheiDataStartproductistransferredtoanothervehicle;
•Thevehicleinwhichtheproductwasoriginallyinstalledistransferredtoanewowner.
ADS is not responsible for any damages whatsoever, including but not limited to any
consequential damages, incidental damages for loss of time, loss of earnings, commercial loss
of economic opportunity and the like that may or may not have resulted from the installation or
operation of an iDataStart product.
CUSTOMERSUppORT
• For all questions regarding to the functionality of your iDataStart remote start system,
contact your local Authorized iDataStart Dealer.
www.eldibg.com
car audio & multimedia system