Identive TouchSecure User manual

Manufactured and Distributed by: Approvals and Standards:
N30126
FCC ID: Z43-8800
1900-B Carnegie Avenue Email: [e-mail]
Santa Ana, CA 92705 USA
Tel. [phone]
Fax [phone] Revision 1.3Document 8805-900-01
TouchSecure
Open Access Reader
®
Quick Start Guide
Use Philips
machine screws
3.5 X .6 X 12 for
electrical box
mounting or
Philips 138-20 X
1.5 sheet metal
screws for wall
mounting.
Mounting Template

Connector Connections
Specifications
Technical Support: [e-mail]
Introduction
TouchSecure OpenAccess Readers are a complete paradigm shift from the historical
design of card readers, offering innovative customer solutions to meet the demands of a
changing world. The design is based upon the convergence of secure IT open platforms
with physical access compatibility, offering complete scalability from local to cloud-based
management and reporting.
The TouchSecure OpenAccess family of readers will read a wide selection of proximity
card formats, MIFARE, ISO144443A/B and ISO15693 CSN.
The mounting surface will affect the overall read range performance of the reader. When
mounting on a metal surface, expect a decrease in read range (10-20% from maximum
rated range).
Parts List
Installation
1. Remove the reader from the box.
2. Determine the mounting location of the reader.
3. Using the mounting plate as a template, mark the desired mounting holes and
terminal location. Remove the mounting plate and drill the marked holes.
4. Using the screws included, mount the mounting plate to the wall.
5. Connect the reader’s terminal to the system wires. The reader should not be
powered on during connection.
6. Swivel the reader into place on the mounting plate and secure with the bezel
screw.
7. Power up the reader, letting the reader setup and prepare for operation.
8. Present a card that is programmed to operate in the system and if operating
correctly, the LEDs change color depending on programming.
Power
+ 5 to +16 VDC
Peak Current 140mA
Read Distance
125 kHz
13.56 MHz
Up to 10.16 cm (4”)
Up to 5.1 cm (2”)
Data Output Wiegand
Temperature Range
-35 to 65C (-31 to 150F)
Wiegand Range
22AWG @ 12V 500 ft
(1) Installation Guide
(1) Mounting Plate
(1) Bezel Reader Assembly
(2) Mounting Screws (machine)
(2) Mounting Screws (sheet metal)
(1) Bezel Screw
Federal Communications Statement
The FCC requires the following statements for your information:
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Changes or modifications not expressly approved by Identive could void the user's authority to operate the
equipment.
•RFU
•RFU
•Buzzer
•RFU
•LED
•Tamper
•Wiegand Data 1
•Wiegand Data 0
•Ground
•+DC (5 – 16V)