Idexx SNAP Pro User manual

Cleaning the SNAP Pro* Mobile Device
To clean the internal components (perform weekly or as needed)
1. Power off the device and
disconnect the power and/or
Ethernet cord.
2. On the bottom of a powered-off
device, use a flat-tip screw driver
or coin to turn the 2 silver fasteners
counterclockwise a quarter turn.
3. Remove the base from the device. 4. Clean the entire base using a lint-
free wipe or cotton swab dampened
with 70% isopropyl alcohol, mild
liquid soap and water, or a 10%
bleach solution.
reflectors
lens
activator
axle
5. Clean the 3 white reflectors, the axle,
and the activator using a new lint-free
wipe or cotton swab dampened with
70% isopropyl alcohol, mild liquid
soap and water, or a 10% bleach
solution. DO NOT clean the lens.
6. After the base has dried, reattach it
to the device and ensure it is locked
into place.
7. Turn the silver fasteners clockwise
a quarter turn to lock the base into
place.
8. Ensure the base and silver
fasteners are flush with the device
and locked into place. Not locking
the base and fasteners properly
can impact device performance.

To clean the case and screen (perform as needed)
© 2016 IDEXX Laboratories, Inc. All rights reserved. • 06-0002430-02
*SNAP Pro is a trademark or registered trademark of IDEXX Laboratories, Inc.or its affiliates in the United States and/or other countries.
When cleaning, do not expose the device to:
Organic solvents
Ammonia-based cleaners
Ink markers
Sprays containing volatile liquids
Insecticides
Disinfectant
Polish
Room freshener
DO NOT wipe the vents underneath the power
button or the USB/power/Ethernet ports.
Clean the case and screen using a lint-free cloth
dampened with 70% isopropyl alcohol, mild liquid
soap and water, or a 10% bleach solution.