iFIT IFAHR120 User manual

Thank you for purchasing the innovative iFIT®
SMARTBEAT heart rate monitor. Please read this
manual before using the heart rate monitor.
IMPORTANT: To download a manual in a different
language, please see the accompanying Quick
Start Guide.
If you have questions after reading this manual,
please see the accompanying Quick Start Guide
for Member Care contact information.
HOW TO CHARGE THE HEART RATE MONITOR
You must charge the heart rate monitor before
it can be used. To charge the heart monitor, first
remove the small sheet of clear film (not shown)
from the back of the sensor (A).
Next, align the metal pins (B) on the charger (C) with
the contacts (D) on the back of the sensor. Then, set
the charger on the sensor; a magnet in the charger
will hold the charger in place.
Plug the cord (E) on the charger into a USB port on
your computer or on another power source. While
the heart rate monitor is charging, the LED light
on the front of the sensor will flash red. When the
sensor is fully charged, the LED light will turn solid
green.
B
C
D
A
E
Model Number IFAHR120
IFIT is a registered trademark of iFIT Inc. The Bluetooth®word mark
and logos are registered trademarks of Bluetooth SIG, Inc. and are used under license.
ANT+™ is a trademark of Garmin Ltd. or its subsidiaries.

2
HOW TO PUT ON THE HEART RATE MONITOR
Locate the end of
the armband (F) that
does not have the iFIT
logo. Peel that end
of the armband away
from the rest of the
armband.
Slide the heart rate
monitor onto your arm
as shown. Make sure
that the iFIT button (G)
is facing upward. You
must position the heart
rate monitor under
your clothes, against
your skin, 2 to 3 inches
(5 to 8 cm) above or
below your elbow.
Then, pull the free end
of the armband to adjust the length of the armband,
and firmly press the free end against the rest of
the armband. Do not overtighten the armband;
overtightening may restrict the circulation in
your arm.
HOW TO USE THE HEART RATE MONITOR
The heart rate monitor must be paired with
compatible fitness equipment that contains an
ANT+receiver or a Bluetooth®Smart receiver.
When the heart rate monitor is paired with compat-
ible fitness equipment, the fitness equipment will
display your heart rate.
See the photograph above. To activate the heart
rate monitor, press the iFIT button (G). While the
heart rate monitor is detecting your heart rate, the
LED light on the sensor will alternate between blue
and green. When your heart rate is detected, the
LED light will flash green. If your heart rate is not
detected, the LED light will alternate between blue
and red.
To pair the heart rate monitor with your fitness
equipment, follow the instructions in the user’s
manual included with your fitness equipment. When
the heart rate monitor is successfully paired, the
LED light on the sensor will be solid blue for a few
seconds and will then flash green.
To turn off the heart rate monitor, press and hold the
iFIT button for 3 seconds. The LED light will be solid
red for 2 seconds and will then turn off.
CARE AND MAINTENANCE
• Store the heart rate monitor in a warm, dry place.
Do not store the heart rate monitor in a plastic
bag or other container that may trap moisture.
• Do not expose the heart rate monitor to direct
sunlight for extended periods of time, and do not
expose it to temperatures above 122°F (50°C)
or below 14°F (-10°C) during use, transportation,
or storage. CAUTION: If the heart rate monitor
is exposed to very high temperatures or very
low pressures, if it is disposed of in a fire or
an incinerator, or if it is disposed of by cutting
or crushing, the battery may explode or leak
flammable gas or liquid.
• For maximum battery capacity, use the battery
at room temperature. If the battery is used in
low temperatures, the battery capacity will be
reduced.
• To clean the sensor, use a damp cloth and a small
drop of mild soap. Then, wipe the sensor with a
damp cloth and thoroughly dry it with a soft towel.
Never use alcohol, abrasives, or chemicals
to clean the sensor. Hand wash and air dry the
armband.
F
F
G

3
TROUBLESHOOTING
If the heart rate monitor does not function properly,
try the steps below.
• Make sure that your fitness equipment has an
ANT+receiver or a Bluetooth Smart receiver. The
heart rate monitor will transmit only to compatible
fitness equipment.
• Make sure that you are wearing the heart rate
monitor as described on page 2. If the heart rate
monitor does not function when positioned as
described, move it slightly lower or higher on your
arm.
• For the fitness equipment console to display heart
rate readings, you must be near the console.
• The heart rate monitor is designed to work with
people who have normal heart rhythms. Heart
rate reading problems may be caused by medical
conditions such as premature ventricular contrac-
tions (pvcs), tachycardia bursts, and arrhythmia.
• The operation of the heart rate monitor can be
affected by magnetic interference from high
power lines or other sources. If you suspect that
magnetic interference is causing a problem, try
relocating the fitness equipment.
CANADA COMPLIANCE INFORMATION
This device contains license-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
This Class B digital apparatus complies with
Canadian ICES-003.
USA COMPLIANCE INFORMATION
FCC Statement. This device complies with Part
15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not
cause harmful interference, and (2) this device must
accept any interference received, including interfer-
ence that may cause undesired operation.
FCC Warning: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to
operate this equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential instal-
lation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is encour-
aged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and the receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device meets the FCC requirements for RF
exposure in public or controlled environments.

Part No. 437549 R0122A Printed in China © 2022 iFIT Inc.
USA/UK/CANADA LIMITED WARRANTY
IMPORTANT: For warranty information outside
the USA, the UK, and Canada, see the accom-
panying Quick Start Guide and download the
user’s manual in the applicable language.
iFIT Inc. (iFIT) warrants this product to be free from
defects in workmanship and material, under normal
use and service conditions. Parts are warranted for
one (1) year from the date of purchase.
This warranty extends only to the original purchaser
(customer) and is not transferrable. iFIT’s obligation
under this warranty is limited to repairing or replac-
ing, at iFIT’s discretion, the product through one
of its authorized service providers. All repairs for
which warranty claims are made must be preau-
thorized by iFIT. If replacement parts are shipped
while the product is under warranty, the customer
will be responsible for a minimal handling charge.
This warranty will automatically be voided by the
following conditions: (1) if the product is used as a
store display model, (2) if the product is purchased
or transported outside the USA, the UK, or Canada,
(3) if any instruction or warning in this manual is not
followed, (4) if the product is abused or improperly
or abnormally used, (5) if the product is modied to
alter functionality or capability without the written
permission of iFIT, or (6) if the product is used for
commercial or rental purposes. No other warranty
beyond that specically set forth above is authorized
by iFIT.
iFIT is not responsible or liable for the following
damages: (1) indirect, special, or consequential
damages arising out of or in connection with the
use or performance of the product; (2) damages
with respect to any economic loss, loss of property,
loss of revenues or prots, loss of enjoyment or
use, or costs of removal or installation; or (3) other
consequential damages of any kind. Some states
do not allow the exclusion or limitation of incidental
or consequential damages. Accordingly, the above
limitation may not apply to the customer.
The warranty extended hereunder is in lieu of any
and all other warranties, and any implied warranties
of merchantability or tness for a particular purpose
are limited in their scope and duration to the terms
set forth herein. Some states do not allow limitations
on how long an implied warranty lasts. Accordingly,
the above limitation may not apply to the customer.
This warranty provides specic legal rights; the
customer may have other rights that vary from state
to state.
UK RECYCLING INFORMATION
This electronic product must
not be disposed of in munici-
pal waste. To preserve the
environment, this product
must be recycled after its
useful life as required by law.
Please use recycling facilities
that are authorized to collect this
type of waste in your area. In
doing so, you will help to conserve natural resources
and improve European standards of environmental
protection. If you require more information about
safe and correct disposal methods, please contact
your local city office or the establishment where you
purchased this product.
iFIT Inc.,1500 S. 1000 W., Logan, UT 84321-9813, USA