
3
UK
9�2 General parameter setting���������������������������������������������������������������������������16
9�3 Settings for volumetric flow monitoring��������������������������������������������������������18
9�3�1 Settings for limit value monitoring with OUT1�������������������������������������18
9�3�2 Settings for limit value monitoring with OUT2�������������������������������������18
9�3�3 Setting the analogue value for volumetric flow �����������������������������������19
9�4 Settings for consumed quantity monitoring �������������������������������������������������19
9�4�1 Settings for quantity monitoring via pulse output��������������������������������19
9�4�2 Settings for quantity monitoring via the preset counter ����������������������19
9�4�3 Settings for program-controlled counter reset ������������������������������������19
9�4�4 Deactivation of the counter reset��������������������������������������������������������19
9�4�5 Counter reset using an external signal �����������������������������������������������20
9�5 Settings for temperature monitoring ������������������������������������������������������������20
9�5�1 Settings for limit value monitoring with OUT2�������������������������������������20
9�5�2 Setting the analogue value for temperature ���������������������������������������20
9�6 User settings (optional)��������������������������������������������������������������������������������20
9�6�1 Setting of the standard unit of measurement for volumetric flow��������20
9�6�2 Configuration of the standard display �������������������������������������������������21
9�6�3 Setting of measured value damping ���������������������������������������������������21
9�6�4 Setting of the error behaviour of the outputs ��������������������������������������21
9�6�5 Setting of the standard pressure to which the measured and display
values for volumetric flow refer���������������������������������������������������������������������21
9�6�6 Setting of the standard temperature to which the measured and dis-
play values for volumetric flow refer �������������������������������������������������������������22
9�6�7 Setting of the low flow cut-off��������������������������������������������������������������22
9�7 Service functions �����������������������������������������������������������������������������������������22
9�7�1 Reading of the min/max values for the volumetric flow ����������������������22
9�7�2 Reset of all parameters to factory setting �������������������������������������������22
9�8 Setting of the preset counter / the pulse value (ImPS) ��������������������������������22
10 Operation���������������������������������������������������������������������������������������������������������25
10�1 Reading of set parameters ������������������������������������������������������������������������26
10�2 Changing the display unit in the Run mode�����������������������������������������������26
10�3 Error indications�����������������������������������������������������������������������������������������26
10�4 General operating conditions���������������������������������������������������������������������26
11 Technical data and scale drawing ��������������������������������������������������������������������26
12 Factory setting �������������������������������������������������������������������������������������������������27