IKEA LUFTIG User manual

GB
DE
FR
IT
LUFTIG

ENGLISH 4
DEUTSCH 15
FRANÇAIS 26
ITALIANO 44

4
ENGLISH
For your safety and correct operation of the appliance, read this
manual carefully before installation and use. Always keep these
instructions with the appliance even if you move or sell it. Users must
fully know the operation and safety features of the appliance.
Recommendations and suggestions
• The manufacturer will not be held liable for any damages resulting
from incorrect or improper installation.
• The minimum safety distance between the cooker top and the
extractor hood is: for electrical hob 500mm and for gas hob
650mm.
• If the instructions for installation for the gas hob specify a greater
distance, this must be respected.
• Check that the mains voltage corresponds to that indicated on the
rating plate fixed to the inside of the hood.
• For Class I appliances, check that the domestic power supply
guarantees adequate earthing.
• Connect the extractor to the exhaust flue through a pipe of
minimum diameter 120 mm. The route of the flue must be as short
as possible.
• Do not connect the extractor hood to exhaust ducts carrying
combustion fumes (boilers, fireplaces, etc.).
• If the extractor is used in conjunction with non-electrical appliances
(e.g. gas burning appliances), a sufficient degree of aeration must
be guaranteed in the room in order to prevent the backflow of
exhaust gas. When the cooker hood is used in conjunction with
appliances supplied with energy other than electric, the negative
pressure in the room must not exceed 0,04 mbar to prevent fumes
being drawn back into the room by the cooker hood.
• If the supply cord is damaged, it must be replaced from the
Contents
Safety information 4
Product description 7
Care and cleaning 7
What to do if... 9
Technical Data 10
Energy efficiency 11
Environment concerns 12
IKEA GUARANTEE 12
Safety information

5
ENGLISH
manufacturer or its service agent.
• Connect the plug to a socket complying with current regulations,
located in an accessible place.
• With regards to the technical and safety measures to be adopted
for fume discharging it is importat to closely follow the regulations
provided by the local authorities.
• WARNING: Before installing the Hood, remove the protective films
(white and transparent).
• Use only screws and small parts in support of the hood.
Warning: Failure to install the screws or fixing device in
accordance with these instructions may result in electrical hazards.
• Connect the hood to the power net by using a bipolar switch
having a contact gap of at least 3 mm.
• Do not flambè under the range hood; risk of fire.
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.
• Children should be supervised to ensure that they do not play with
the appliance.
Accessible parts may become hot when used with cooking
appliances.
• Clean and/or replace the Filters after the specified time period
(Fire hazard).

6
ENGLISH
Use
• Switch off or unplug the appliance from
the mains supply before carrying out any
maintenance work.
• The extractor hood has been designed
exclusively for domestic use to eliminate
kitchen smells.
• Never use the hood for purposes other
than for which it has been designed.
• Never leave high naked flames under the
hood when it is in operation.
• Adjust the flame intensity to direct it onto
the bottom of the pan only, making sure
that it does not engulf the sides.
• Deep fat fryers must be continuously
monitored during use: overheated oil can
burst into flames.
Care and cleaning
• Activated charcoal filter these filters
are not washable and cannot be
regenerated, and must be replaced
approximately every 4 months of
operation, or more frequently with heavy
usage.
• Grease filters the filters must be cleaned
every 2 months of operation, or more
frequently for particularly heavy usage,
and can be washed in a dishwasher.
• Clean the hood using a damp cloth and
a neutral liquid detergent.

7
ENGLISH
Product description
Upper Chimney
Lower Chimney
Hood body
Lighting
Grease filters
Control Pannel
DCBA E
BUTTON FUNCTION
A =
Pilot
Light ON if the motor is working.
B =
Speed Turns the Motor ON at Speed one. Turns the Motor OFF.
C =
Speed Set the Motor at Speed two.
D =
Speed Set the Motor at speed three.
E =
Light Turns the Lighting System ON and OFF.
Care and cleaning
Switch off or unplug the appliance from
the mains supply before carrying out any
maintenance work.
Clean the hood using a damp cloth and a
neutral liquid detergent.
Charcoal Filter
These filters are not washable and cannot
be regenerated, and must be replaced
approximately every 4 months of operation, or
more frequently with heavy usage.

8
ENGLISH
Grease Filters
Clean or replace the filters continuously
according to below time intervals, to maintain
good performance of the hood and to prevent
a potential fire hazard, caused by excessive
grease build-up.
The grease filters must be cleaned every 2
months of operation, or more frequently for
particularly heavy usage, and can be washed in
a dishwasher.
Replacing the lamps
Unscrew the bulbs, by using the gloves, and
replace them with new ones having the same
characteristics 28W (Connection type: E14).
2x
Lamp Power (W) Socket Voltage (V) Dimension (mm) ILCOS Code
28 E14 220-240 104 x 35 HSGSB/C/UB-28-220/240-E14

9
ENGLISH
What to do if...
PROBLEM POSSIBLE CAUSE SOLUTION
Appliance not stable. The appliance is not correctly
installed. Respect the Installation instruction enclosed to the appliance.
Appliance is not in horizontal
position. The appliance is not correctly installed. Respect the Installation instruction enclosed to the appliance.
Performance in terms of oil
capture arent satisfying. Oil and grease on metal lters. Respect the cleaning frequency of lters as described in the user manual.
Appliance doesn't work. The appliance is not correctly
connected.
Verify that the main cable is
connected to the motor group or the
plug is connected to the socket.
The lamp is not working. The lamp is not correctly xed. Verify that the lamp is screwed
properly to the lampholder.
The lamp is not working. The lamp is faulty. Replace the lamp bulb.
If there is a fault, first try to find a solution to the
problem yourself. If you cannot find a solution
to the problem yourself, contact an authorized
service center.
If you operated the appliance wrongly, or
the installation was not carried out
according to the Assembly instructions, the visit
from the After Sales Service technician may not
take place free of charge, even during the
warranty period.

10
ENGLISH
Technical Data
Unit Value
Product Type Wall mounted hood
Dimension
Width mm 598
Depth mm 471
Height min/max mm 620/995
Airow max* - Exhaust m3/h 400
Noise max* - Exhaust dBA 64
Airow max* - Recirculating m3/h 270
Noise max* - Recirculating dBA 72
Total Power W161
Lamps info
Halogen Bulb
2 x 28W
E14
Installation minimum height - gas hob mm 650
Installation minimum height - elec hob mm 500
Net Weight Kg 6,4
This appliance has been designed,
manufactured and marketed in compliance with
the E.E.C. Directives.
The technical information is situated in the rating
plate on the internal side of the appliance.
* Maximum speed (boost excluded).