IKEA KULINARISK User manual

GB
KULINARISK

 

4
13
Warning Strips
Warning strips show that specialist should do the connecting water, gas and electricity:
The electricity installation
specialist.
The gas installation specialist.
The water installation
specialist.
MANUAL
www.ikea.com
KULINARISK
0$18$/
ZZZLNHDFRP
0$18$/
ZZZLNHDFRP
KULINARISK
2x
1x
H.2
2x
F
G
I.1
8AA-725973-1
1x
1x
C
1x
B
A
1x 3x 4x
1x
D E
1x
1x
1x
1x
L
I.2
H.1
8AA-725973-1
1x
1x
C
1x
B
A
1x 3x 4x
1x
D E
1x
1x
1x
1x
D
1x

5 ENGLISH
Filters Alarm.
When the filter alarm is activated, the following messages will appear over time:
Grease filter alarm must be cleaned: “A” key flashes once per second.
Anti-odour filter alarm must be cleaned: “A” key flashes twice per second.
Once the filters have been regenerated reset the alarm signal.
S0614 (170201)
backlight symbols
112
20 20 20 20
8
S0614 (170201)
backlight symbols
"
#
$
%
&
"
Speed
Turns the motor on/o at speed one.
Attention: the product is with the lter alarm disabled.
Press and hold the button for approximately 2 seconds, with all the loads turned o (Motor+Lights), to turn the grease lter alarm on. LED
(B) ashes twice to conrm.
To turn the alarm o, press the button again and hold for at least 2 seconds. The relevant LED (B) ashes once.
#
Speed
Turns the motor on at speed two / Activate charcoal lter alarm.
Attention: the product is with the lter alarm disabled.
Press and hold the button for approximately 2 seconds, with all the loads turned o (Motor+Lights), to turn the Activated Charcoal Filter
alarm on. LED (A) ashes twice to conrm.
To turn the alarm o, press the button again and hold for at least 2 seconds.The relevant LED ashes once (A). Only for recirculation mode.
$
Speed
Turns the Motor on at speed three / Reset alarm grease lter saturation.
Press and hold the button for approximately 2 seconds, with all the loads turned o (Motor+Lights), to reset the grease lter
saturation alarm or charcoal lter alarm. LED (A) ashes three times.
%
Speed
Turns the motor on at Booster speed.
This speed is timed to run for 6 minutes. At the end of this time, the system returns automatically to the speed that was set before. If it is
activated with the motor turned o, it will switch to OFF at the end of the time. To deactivate it, press button D or press button A.
&
Light
Press briey: Turns the lighting system on and o at maximum intensity.
Press and hold to change the lighting intensity up or down.
Product description
Control panel
Upper chimney
Lower chimney
Hood body
LED Lighting
Grease filter
Control panel