iLive DTM301WL Instruction Manual

Desk
with Drawer
User’s Guide for Model DTM301WL v2733-01
Assembly Instructions & User Guide
60mins

2 3
SAFETY WARNINGS
•WARNING:To prevent re or shock hazards, do not expose this unit to
rain or moisture.
•Clean only with a dry cloth. Do not clean with liquid cleaners or a damp cloth.
• DO NOT use with devices that should not be used unsupervised.
• DO NOT use in a bathroom or other locations where it may come into contact
with water or splashing.
• WARNING:Where the mains plug or appliance coupler is used as the
disconnect device, such disconnect device shall remain readily operable
• Risk of electric shock. Grounding continuity must be maintained.
•SAVE THESE INSTRUCTIONS
• DO NOT connect the power strip to an ungrounded outlet.
• DO NOT use the power strip with 2-wire extension cords or adapters.
• This power strip is designed for indoor use only. Do not install near any heat
sources such as radiators, heat registers, stoves, or other apparatus (including
ampliers) that produce heat.
• DO NOT install where excessive moisture is present.
• DO NOT plug extension cords into the power strip.
• Never install electrical, telephone, network or coaxial wiring during a
lightning storm.
• DO NOT drill into any part of the housing or open the housing for any reason.
There are no user-serviceable parts inside.
FCC WARNINGS
Warning: Changes or modications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide
reasonable protection against harmful interference in a residential installation.This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: This product can expose you to chemicals
including lead, which is known to the State of California to cause
cancer and birth defects or other reproductive harm. For more
information go to www.P65Warnings.ca.gov.This product meets
and complies with required Federal product guidelines.
Safety & Warnings Features
10kg weight limit (22 lbs)
Desk with paper laminated drawer
Includes
Assembly hardware
User’s Guide and assembly instructions

4 5
What you will need
Flathead Screwdriver
Phillips-Head Screwdriver
Do not use a power
drill.
ASSEMBLY TOOLS REQUIRED (NOT INCLUDED)
Maintenance
Thank you for your purchase. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to ensure quality.
Prior to beginning assembly, please make sure all parts and hardware are included and
free of defect. If a part is missing or defective, please contact the place of purchase.
To ensure you furniture maintains its quality and longevity, please
follow the following care suggestions.
1. Keep out of direct sunlight so the color is preserved.
2. Dust or wipe clean with a damp cloth. Be sure not to leave water spots on the surface.
These water spots will dry and could possibly leave permanent marks.

6 7
Before assembly
Tips before your start:
- Remove all wrapping material, including staples & packing straps before you start to
assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
QUICKFIT
Tighten quickt until shoulder is ush with panel. Do not overtighten or undertighten.
CAM LOCK
When tting cam lock, ensure starting position is correct before you insert connecting
quickit.
Quickt head should be in the
Center of the cam lock when the
two panels are joined.
Cam lock should be inserted before
quickt.
Turn cam lock clockwise to tighten.
1
2
3
4
5
7
8
10
11
12
13
14
15
69

8 9
Part list
When unpacking, please be careful not to discard any parts with the packaging.
Before continuing, please make sure you have the following parts:
11
Drawer left
side panel
1
1
1
Drawer back
panel
Drawer right
side panel
Drawer
bottom panel
Drawer front
panel
11 12
13 14
15
NO
12
4
6
8
Description Description
Qty Sketch
Top panel Left frame
NO Qty Sketch
Left side
panel
1 1
11
11
Right frame
1
1
Front
stretcher Stretcher 1
1
Bottom panel
Back panel
10
3
5
7
9
Back stretcher
Partition
panel
Hardware list
When unpacking, please be careful not to discard any parts with the packaging.
Before continuing, please make sure you have all of the following hardware:
Handle
Hx1 Ix10
Bx6 Cx17 Ex6
x1 x1 x1 x1
Dx4
Cam Bolt
Ax6
Cam Lock Screw Screw
Slider
(Left) (Right)
Slider
Flat shape for side panel
(Left) (Right)
Slider Slider
L Shape for drawer
Screw
Bolt
Gx1
Screw
Lx2
Screw
Fx1
Allen Key
Kx4
Jx2
Wooden Dowel
Leveler
Nx2
Screw
Mx2
Buckle

10 11
Step 1
Step 2
2xC
Left
Step 3
Step 4
Right
2xE
3xI
3xI
2
4
C
C
Left
I
I
I
5
Right
3
I
I
I
2
3
8
E
E
E
F
Do not tighten ANY bolts until entire unit is set up!

12 13
Step 5
Step 6
4xC
5xC
Step 7
Step 8
2xA
2xJ
2xB
2
C
C
C
1
3
C
7
2
3
Notice:
Remove the plastic protective
sleeves before assembly.
3
2
A
1
A
B
3
2
5
J
J

14 15
Step 9
Step 10
2xE
2xL
Step 11
Step 12
4xK
2xE
6
2
3
L
L
6
9
8
E
E
E
F
6xC
E
E
2
3
10
E
F
C
C
C
9
C
C
C
Gently Tighten All Bolts.
K

16 17
Step 13
Step 14
4xA
4xB
1xG
1xH
4xD
Step 15
Step 16
Right
Left
4 xI
A
B
11
12
15
14
15
11
12
13
H
G
D
Back
Back
Back
Front
Front
Front
TURN BACK
Left
Left
M
M
MM
N
N
N
Right
Right 15
11
12
13
I
I
I
I
If needed, adjust levelers (K) to
level the desk.
2xN
2xM

Protect for Today
Sustain for Tomorrow
Made
Green
Customer Support
Copyright © 2021 Digital Products International (DPI, Inc.). All other trademarks appearing
herein are the property of their respective owners. Specifications are subject to change
without notice.
For Warranty Information, the most up-to-date version of this User’s
Guide or to download this User’s Guide in English, French or Spanish,
please go to: www.iLiveElectronics.com
Customer Service: 1-888-999-4215
Email Support: [email protected]om
Email Parts: par[email protected]