imagistics im7520 User manual

www.imagistics.com
User's Guide
im7520
im6020
Copy Operations
®

9
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
Replacing Toner
Cartridges and Staples
and Emptying Dust Boxes

9Replacing Toner Cartridges and Staples and Emptying Dust Boxes
9-2 im7520/im6020
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
9 Replacing Toner Cartridges and Staples
and Emptying Dust Boxes
9.1 Replacing the Toner Cartridge
When the toner is about to run out, the warning message shown below ap-
pears. Replace the toner cartridge.
!
Detail
Some copies can be printed between the time that the message “Toner
Cartridge needs to be replaced.” appears until the time that the message
“Replace the Toner.” appears. However, it is recommended that the ton-
er cartridge be replaced when the message “Toner Cartridge needs to be
replaced.” appears.
When the message“Replace the toner” appears, the machine is stopped.
When the toner is empty, the warning message shown below appears and
copies can no longer be made.

Replacing Toner Cartridges and Staples and Emptying Dust Boxes 9
im7520/im6020 9-3
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
!
Detail
For details on replacing the toner cartridges, refer to “To replace the toner
cartridge” on page 9-4.
Display in Enlarge Display Mode
When the toner is empty, the screen shown below appears.
Touch to display the message enlarged.
7 WARNING
Handling toner and the toner cartridges
%Do not throw toner or the toner cartridge into a fire.
%Toner expelled from the fire may cause burns.

9Replacing Toner Cartridges and Staples and Emptying Dust Boxes
9-4 im7520/im6020
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
7 CAUTION
Precautions for toner spills
%Be careful not to spill toner inside the machine or get toner on your
clothes or hands.
%If your hands become soiled with toner, immediately wash them with
soap and water.
%If toner gets in your eyes, immediately flush them with water, and then
seek professional medical attention.
To replace the toner cartridge
1Open the toner cartridge
door.
2Pull out the cartridge holder.
While pulling the toner-
cartridge-securing lever
toward you, pull the car-
tridge holder out toward
you as far as possible.

Replacing Toner Cartridges and Staples and Emptying Dust Boxes 9
im7520/im6020 9-5
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
3Pull up the used toner
cartridge to remove it.
4Shake the new toner
cartridge by turning it
over about five times.
– The toner within the
toner cartridge may
have become com-
pacted. If it has, be
sure to shake the
toner cartridge until
the toner is mostly
broken up before in-
stalling the cartridge.
5Remove the cover from
the toner cartridge.

9Replacing Toner Cartridges and Staples and Emptying Dust Boxes
9-6 im7520/im6020
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
6Install the toner cartridge, making sure that it is correctly oriented.
With the label at the end
of the toner cartridge
facing up, insert the bot-
tom of the cartridge into
the slot in the cartridge
holder.
7Return the cartridge
holder to its original po-
sition, and then close the
toner cartridge door.

Replacing Toner Cartridges and Staples and Emptying Dust Boxes 9
im7520/im6020 9-7
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
9.2 Replacing the Staples
When finisher 9202/9204 is installed and is about to run out of staples, the
message shown below appears.
Display in Enlarge Display Mode

9Replacing Toner Cartridges and Staples and Emptying Dust Boxes
9-8 im7520/im6020
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
!
Detail
Be sure to replace the staple cartridge only after the message appears,
otherwise the machine may be damaged.
When staples run out in either of Saddle Staple Cartridge 1 or 2, the mes-
sage “Replace Staple Cartridge 1” or “Replace Staple Cartridge 2” ap-
pears.
To replace the staple cartridge for finisher 9202
1Open the finisher door.
2Pull out the stacker unit.
– Hold the stacker unit
handle, and then
slowly pull out the
stacker unit as far as
possible.

Replacing Toner Cartridges and Staples and Emptying Dust Boxes 9
im7520/im6020 9-9
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
3Remove the empty staple cartridge from the staple cartridge holder.
– Hold the lever on the
staple cartridge, and
then pull the car-
tridge down to re-
move it.
4Install the new staple cartridge.
– Push up the staple
cartridge, and then
check that the car-
tridge is securely in-
stalled.
5Return the stacker unit
to its original position.

9Replacing Toner Cartridges and Staples and Emptying Dust Boxes
9-10 im7520/im6020
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
6Close the finisher door.

Replacing Toner Cartridges and Staples and Emptying Dust Boxes 9
im7520/im6020 9-11
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
To replace the staple cartridge for finisher 9204
1Open the finisher door.
2Pull out the stacker unit.
– Hold the stacker unit
handle, and then
slowly pull out the
stacker unit as far as
possible.

9Replacing Toner Cartridges and Staples and Emptying Dust Boxes
9-12 im7520/im6020
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
3Remove the staple cartridge.
– While lifting the lever
on the staple car-
tridge, pull the car-
tridge toward you to
remove it.
– Remove the staple
cartridge by guiding
it along the rails.
4Remove the empty car-
tridge case from the sta-
ple cartridge.
1
2

Replacing Toner Cartridges and Staples and Emptying Dust Boxes 9
im7520/im6020 9-13
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
5Load the new cartridge
case into the staple car-
tridge.
– Align the side of the
staple cartridge
marked by the arrow
with the side of the
cartridge case
marked by the arrow,
and then fully insert
the staple cartridge.
– Carefully pull the seal
off the cartridge
case.
6Install the staple cartridge.
– Place the staple car-
tridge on the rails,
and then guide it
back to its original
position.
– Push down the sta-
ple cartridge, and
then check that the
cartridge is securely
installed.
1
2

9Replacing Toner Cartridges and Staples and Emptying Dust Boxes
9-14 im7520/im6020
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
7Return the stacker unit
to its original position.
8Close the finisher door.
2
Reminder
Do not remove the remaining staples, otherwise the machine will not be
able staple after the cartridge is replaced.

Replacing Toner Cartridges and Staples and Emptying Dust Boxes 9
im7520/im6020 9-15
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
9.3 Emptying the Dust Boxes
To empty the dust box of the punch kit
If the punch dust box in punch kit im9220010 installed on finisher 9202/9204
becomes full, the message shown below appears.
Display in Enlarge Display Mode

9Replacing Toner Cartridges and Staples and Emptying Dust Boxes
9-16 im7520/im6020
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
1Open the finisher door.
2Pull out the punch dust
box.
3Empty the punch dust
box.

Replacing Toner Cartridges and Staples and Emptying Dust Boxes 9
im7520/im6020 9-17
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
4Install the punch dust
box into its original posi-
tion.
5Close the finisher door.
To empty the dust box of the Z-folding unit
If the punch dust box in Z-folding unit 9263 installed on finisher 92029202/
9204 becomes full, the message shown below appears.

9Replacing Toner Cartridges and Staples and Emptying Dust Boxes
9-18 im7520/im6020
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
Display in Enlarge Display Mode
1Open the finisher door.

Replacing Toner Cartridges and Staples and Emptying Dust Boxes 9
im7520/im6020 9-19
Replacing Toner Cartridges and Staples and Emptying Dust Boxes Chapter 9
2Pull out the punch dust
box.
3Empty the punch dust
box.
4Install the punch dust
box into its original posi-
tion.