imagistics DL170 User manual

Printer Controller (PCL Printer Port)
Network Interface Kit Hardware
Setup Guide
(to be used in conjunction with User’s Manual FX30075)
Models 5000/3500/DL170
Network Interface Kit Setup Guide.doc 12/4/02

Table of Contents
Printer Controller and Network Interface Illustration
and Descriptions…………………………………………………………………………………Page Three
Installing the Printer Controller PCB (Printer Port
And Network Interface Card…………………..……………………………………………….Page Four
Specification for Print Controller, Network Interface Kit
and Twain Scanner………………………………………………………………………………Page Eight

Description/Illustrations
When equipped with a Printer Controller (PCL Printer Port), your fax machine can also
be made available as a printer to network users by connecting it to the network through
a print server PC. In this arrangement, the 5000/3500 with a Printer Port is connected
to the print server PC with a bi-directional parallel cable. The print server PC is
connected to the network through a network interface card inside the PC.
In this environment the server must be on, operating and logged onto the network for
the 5000/3500 fax to be available for use as a printer. Arranging and programming to
make this printer available on the network is the responsibility of the Network
Administrator.
1

2

3

PCL (5000: 6429755 / 3500: 6429760 Network Interface Card (6429742)
Packaging contents:
4

5

6

Next, Install the Printer driver software.
Please refer to the User’s Manual Set Up. The guide describes pc
printing/scanning and network printing.
(FX30075)
IMPORTANT!!
Prior to setting up the 3500/5000/dL170 for network printing, the
customer must provide you with the following:
1. IP Address
2. Subnet Mask
3. Default Gateway
7

8