IMC F63/700 User manual

IS759 ECN 4748 - May 2020
JUNIOR MOBILE HAND WASH UNIT
INSTALLATION AND USER MANUAL
PLEASE LEAVE WITH OPERATOR
JUNIOR MOBILE HAND WASH UNIT –F63/700

INDEX
INPORTANT INFORMATION
1
Guarantee
1
Delivery
1
DIMENTIONS
2
SPECIFICATION
2
PRODUCT FEATURES
3
INSTALLATION
4
Procedure
Location
4
4
Commissioning
5
Emptying / Refilling
6
Cleaning
6
SPARE PARTS
Spare Parts List
Ordering Spear Parts
7
7
7

MOBILE HAND WASH UNIT 1
INPORTANT INFORMATION
Read these instruction carefully. This manual outlines the installation, operation
procedures relevant to this unit.
WARNING
The unit should be used under adult supervision
Guarantee
The Mobile Hand Wash unit is guaranteed by Lincat for 1 years from the date of
purchase from Lincat, or from one of its stockists, dealers or distributors. The
guarantee is limited to the replacement of faulty parts or products and excludes
any consequential loss or expense incurred by purchaser. Defects which arise
from faulty installation, inadequate maintenance, incorrect use or fair wear and
tear are not covered by the guarantee.
The guarantee applies in this form to installations within the United Kingdom.
Please observe these instructions carefully. Keep this manual for future reference
The manufacturer disclaims any liability for incidental, or consequential damages.
Attendance is based on reasonable access to the appliance to allow the
authorised technician to carry out the warranty work.
Delivery
The packaged unit contains:
IMC MOBILE HAND WASH UNIT:
Fully Assembled Hand Wash Unit
Splashback Panel
Paper Tower Dispenser
Soap Dispenser
1
1
1
1
Funnel with flexible spout
1
Water container 20L - Natural
2
Instruction Booklet
1
Please notify LINCAT-IMC on the day of receipt if anything is missing or
damaged.
UK: 01522 875555
Check that the correct machine has been supplied. The data plate is located on
the rear of the unit.

2MOBILE HAND WASH UNIT
592
704 304
118
520
1003
DIMENSIONS
SPECIFICATION
Tank Capacity
20 litres
Net Weight
22.7kg

MOBILE HAND WASH UNIT 3
TOWEL HOLDER
WATER SPOUT
SINK
ACCESS KNOB
FOOT PUMP
WHEEL
SURROUND
SOAP HOLDER
PRODUCT FEATURES

4MOBILE HAND WASH UNIT
INSTALLATION
These Instructions contain important information designed to help the user obtain
the maximum benefit from their investment in an IMC Mobile Hand Wash Unit.
Please read them carefully before starting work and consult with your
distributor/supplier in the event of any queries.
Be sure to leave this Instruction Manual with the user after installation of the
machine is complete, or in a safe location.
Procedure
WARNING
The following table shows the weight and the minimum quantity of
people required to lift each unit:
Net Weight
Quantity of People
IMC Mobile Hand Wash Unit
22.7 kg
1
Before using the hand wash; remove all packaging and ensure that the unit is
checked over for damage, any damage must be reported to the carrier or
distributor/supplier immediately.
Remove any protective plastic coating on the unit.
Do not be alarmed if water is present in the tanks or pipes of the unit, this is
normal and a consequence of the testing procedures.
Location
The Mobile Hand Wash Unit is only suitable for use where there is no risk for the
unit to be adversely affected by its surrounding environment.
The unit must be stationed on a flat surface capable of safely supporting the units
weight when fully laden with water.
The unit it is fitted with a handle on the back to assist when moving.

MOBILE HAND WASH UNIT 5
Commissioning
Remove the front panel by unscrewing the black knob on the front of the unit, tilt
the panel backwards and pull upwards away from the unit at an upward angle.
This will enable the operator to gain access to the clean and waste water
containers inside the unit.
Once the front panel has been removed, lift out the suction hose from the clean
water container and remove the water container. Note the water container can
hold a maximum of 20 litres. You can fill the container with less if you want.
Ensure when refitting the water container that the suction hose has been placed
at the bottom container. Check that the funnel is fitted to the waste container and
position under the sink waste pipe.
We advise that you operate the foot pump and pass water through the unit before
refitting the front panel. To prime the pump depress the foot pump several times
until water is seen coming out of the spout located above the sink on the unit.
Once all of the above steps have completed and the front panel has been refitted,
your Mobile Hand Wash Unit should now be ready for operation.

6MOBILE HAND WASH UNIT
Emptying / Refilling
Once the unit has completed its total number of operations, the waste water
container will need emptying and the clean water tank refilled.
To empty the waste water container; remove the front panel. The waste-water
container can now be removed and the container can be slid out of the unit.
Remove the funnel from the waste container and empty appropriately.
To re-install the waste water container, follow the above steps in reverse.
To refill the clean water container, follow the steps outlined in the commissioning
section.
Cleaning
Clean the externals of the unit as required; using a damp cloth and an appropriate
cleaning product.
DO NOT USE CLEANING MATERIALS CONTAINING ABRASIVES OR
BLEACHES.

MOBILE HAND WASH UNIT 7
SPARE PARTS
Spare Parts List
PART NUMBER
DESCRIPTION
WC01
20 LTR WATER CONTAINER
WP02
FOOT PUMP
A19/042
MOBILE HANDWASH WHEEL
A10/498
FUNNEL WITH FLEXIBLE SPOUT
A21/044
KNOB 2160_M M8 x 14 BLACK
Ordering Spare Parts
In the event that spare parts or accessories need to be ordered, please always
quote the SERIES AND SERIAL NUMBER of the machine. This is to be found on
the rating plate located near the supply cable if applicable or at the rear of the
appliance.
For help with the installation, maintenance and use of your Lincat - IMC
equipment, please contact our service department:
UK: 01522 875520
For non-UK customers, please contact your local Lincat dealer
All service work, other than routine cleaning should be carried out by one of our
authorised service agents. We cannot accept responsibility for work carried out
by other persons.
To ensure your service enquiry is handled as efficiently as possible, please tell
us:
Brief details of the problem
Product code
All available on serial plate
Type number
Serial number
Lincat reserve the right to carry out any work under warranty, given reasonable
access to the appliance, during normal working hours, Monday to Friday, 08:30
to 17:00.