In-situ Partech ChemScan RDO-X Stainless Steel User manual
2022-05-11 | 2000382
Connect the instrument to the Twist-Lock cable
and twist until it clicks into place.
Remove the cover from the Control Point 2.0
(also compatible with the Partech 7300w2
Monitor). Wire the cable into the terminals
1Attach the Twist-Lock
cable to the probe.
Wire the other end of
the cable.
2
Reinstall the terminal cover. Connect power to
the controller and turn it on. Press Menu.
Use the arrow keys to select Sensor Cong.
Power up the Control
Point 2.0 or 7300w².
34 Congure.
4
RDO-X Stainless Steel Instructions
Information subject to change without notice. In-Situ, In-Situ logo, Baro Merge, BaroTROLL, HERMIT, HydroVu™, iSitu,
Pocket-Situ, RDO, RuggedCable, RuggedReader, SmarTROLL™, TROLL, VuSitu, and Win-Situ are trademarks or registered
trademarks of In-Situ Inc.©2016. All rights reserved. This product may be covered by patents identied at www.in-situ.com/
patents
2
Maintenance
Use the arrow keys to select Add Sensor. When
complete, the RDO-X Stainless Steel will appear
on the list.
The display will now show readings from the
RDO-X Stainless Steel.
5 Add Sensor. 6 Read Display.
How to Install and Replace the RDO Cap
Unscrew and remove
the guard.
Slide the RDO
cap away from the
instrument. Do not
twist cap.
Align the at edge
inside the cap with
the at edge on the
instrument. Slide the
new cap into place.
Replace the guard
and calibrate the
instrument.
Align
with cap
1-970-498-1500 www.in-situ.com
3
How to Clean the Instrument
Unscrew and remove
the guard.
Gently clean the cap
with a soft cloth. Use
Alconox or vinegar to
remove build-up.
Do not use organic
solvents to clean cap.
Never wet the lens
area under the cap.
Use only the supplied
lens cloth to clean lens.
Replace the cap
and calibrate the
instrument.
Get complete instructions about calibration, logging and working with data in the
product manual. Download it from www.in-situ.com.
1-970-498-1500 www.in-situ.com
Other In-situ Accessories manuals
