Indian Motorcycle 2884309 User manual

AAPPPPLLIICCAATTIIOONN
Verify accessory fitment at www.indianmotorcycle.com.
BBEEFFOORREE YYOOUU BBEEGGIINN
Read these instructions and check to be sure all parts and tools are accounted for. Please retain these
installation instructions for future reference and parts ordering information.
KKIITT CCOONNTTEENNTTSS
REF QTY PART DESCRIPTION P/N AVAILABLE
SEPARATELY
1 2 Speaker, 6.5 Inch, 100W 4017741
2 1 Pry Bar, Plastic Trim Removal 5456907
TTOOOOLLSS RREEQQUUIIRREEDD
• Safety Glasses
• Socket Set, Hex Bit, Metric
• Socket Set, Hex Bit, Metric, Ball-End
• Torque Wrench
•Special Service Tool:
– Non-marring Pry Tool, P/N 5456907 (or
equivalent)
Instr 9929888 Rev 01 2019-11 Page 1 of 4
P/N 2884309
FFAAIIRRIINNGG AAUUDDIIOO UUPPGGRRAADDEE KKIITT

Instr 9929888 Rev 01 2019-11 Page 2 of 4
IIMMPPOORRTTAANNTT
Your Indian Motorcycle®Fairing Audio Upgrade Kit is exclusively designed for your vehicle. Please read
the installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and
free of debris. For your safety, and to ensure a satisfactory installation, perform all installation steps
correctly in the sequence shown.
IINNSSTTAALLLLAATTIIOONN IINNSSTTRRUUCCTTIIOONNSS
VVEEHHIICCLLEE PPRREEPPAARRAATTIIOONN
GGEENNEERRAALL
1. Turn key or ignition switch to OFF position and
remove key. If equipped with keyless fob,
remove fob from proximity of vehicle.
2. Ensure motorcycle is parked on a flat surface,
kickstand is fully extended, and vehicle is
stable.
AACCCCEESSSSOORRYY IINNSSTTAALLLLAATTIIOONN
RH speaker shown. LH speaker similar.
RREEMMOOVVEE SSPPEEAAKKEERR GGRRIILLLL
1. Carefully pry along edge with non-marring pry
tool to disengage speaker grill assemblies.
RREEMMOOVVEE SSTTOOCCKK SSPPEEAAKKEERRSS
5.25 INCH SPEAKERS
1. Remove and retain four screws Afrom speaker
adaptor ring.
NOTICE
Speaker and adaptor ring assembly will be
removed together.
2. Rotate speaker assembly and remove. Unplug
speaker connector B.

Instr 9929888 Rev 01 2019-11 Page 3 of 4
6.5 INCH SPEAKERS
1. Remove and retain four screws Afrom speaker.
2. Rotate speaker and remove. Unplug speaker
connector B.
IINNSSTTAALLLL AACCCCEESSSSOORRYY SSPPEEAAKKEERR
1. Plug in speaker connector Band rotate new
speaker into place.
2. Rotate speaker so tweeter is located in top inner
corner of opening as shown. (RH Speaker
shown.) Secure with retained screws A. Torque
screws to specification.
TORQUE
Fairing Speaker Screws A:
25 in-lbs (2.8 N·m)
3. Reinstall fairing speaker grill.
4. Repeat for LH side speaker and ensure tweeter
is installed in top inner corner of LH opening.

Instr 9929888 Rev 01 2019-11 Page 4 of 4
FFEEEEDDBBAACCKK FFOORRMM
A feedback form has been created for the installer to provide any comments,
questions or concerns about the installation instructions. The form is viewable
on mobile devices by scanning the QR code or by clicking HERE if viewing on
a PC.