JWA Mathews 71558 User manual

Mathews
OFFICE CHAIR
ITEM CODE:71558
1
ASSEMBLY INSTRUCTIONS

PRE-ASSEMBLY PREPARATION
Allow 15 min For 1 person
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to the
point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
7. Assembly is to be carried out by a competent adult(s) ONLY
8. During assembly, children should be kept away from the product due to possible
risk to injury.
9. Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.
2

3

SETP 1:
•Prepare a protected surface with a blanket or
cardboard.
•Attach the castors(F) to the base(E). As shown
below.
•Insert Gas lift(D) into the base(E), press down
firmly. Check that the gas lift is properly in, lift the
gas lift and make sure the base goes up with it.
•Place the cover(C) over the gas lift(D) and let is
slide down.
4

SETP 2:
•Put the mechanism(B) on the chair body(A)
•Use 4 screws to tighten the mechanism(B)
4

STEP 2:
•Attach the seat(A) to the gas lift, as shown below.
•Press down firmly. Check that the gas lift is
properly in, lift the seat and make sure the gas lift
goes up with it.
5
The tilt dial can be adjusted to limit the amount the can tilt.

9
ASSEMBLY IS COMPLETE