InFocus LP130 User manual

Windows XP USB setup
Windows 2000 automatically detects and installs USB drivers for the keyboard, mouse and composite
device. You need only to follow the Found New Hardware Wizard to complete the driver installation
process. It starts automatically when Windows 2000 detects a new hardware device.
Store the file you download your computer's hard drive or on a floppy disk. You'll need access to it when
you set up the computer for use with the projector.
Note that you need to install the driver once on each laptop or desktop PC you use with the projector.
To install the InFocus USB Projector Control Drivers for Windows 2000
When you plug the USB cable into the USB connector on the computer, the Found New Hardware dialog
box appears.
NOTE The illustrations below refer to the LP130. The dialog boxes you see will refer to your projector
model. Otherwise the procedure is the same.
1 In the Found New Hardware Wizard, click Next.

USB Driver Installation for Windows XP 2
2 Select Search for a Suitable Driver, then click Next.
3 Select Specify a Location, then click OK.
NOTE If you stored the file on a floppy drive, do not select Floppy Disk Drives. Instead, click
Specify a Location, then navigate to the floppy drive on your computer.

USB Driver Installation for Windows XP 3
4 To specify a path, click Browse, then navigate to the location where you stored the file, then click
OK.
5 When the wizard locates the .inf file, click OK.
6 When the drivers are installed, click Finish.

USB Driver Installation for Windows XP 4
You have completed the setup on the current laptop or desktop computer. You now have
keyboard "Page Up" and Page Down" capabilities and mouse control through the remote.
NOTE Windows 2000 installs the driver file in C:\WINNT\System32\drivers, and the .inf file in
C:\WINNT\INF.