InFocus LP70+ User manual

LP
®
70+
collaboration without limits
User’s Guide
6693LP70_Dividers.qxd 2/12/04 1:29 PM Page 1

WARNING: This product contains chemicals, including lead, known to the State of California to cause
birth defects or other reproductive harm. Wash hands after handling.
WARNING: This product has a lamp which contains a very small amount of mercury. Dispose of it as
required by local, state, or federal ordinances and regulations. For more information, see www.eiae.org
6693LP70_Dividers.qxd 2/12/04 1:29 PM Page 2

LP
®
70+
collaboration without limits
User’s Guide
6693LP70_Dividers.qxd 2/12/04 1:29 PM Page 3

Copyright © 2004 by InFocus Corporation
Wilsonville, Oregon. All rights reserved.
LP70.book Page 1 Friday, February 13, 2004 7:39 AM

FCC Warning
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communi-
cations. Operation of this equipment in a residential area is likely to cause harm-
ful interference in which case the user will be required to correct the interference
at his own expense.
Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Can-
ada.
Safety Certifications
UL, CUL, TUV, GOST
Other specific Country Approvals may apply, please see product certification
label.
EN 55022 Warning
This is a Class A product. In a domestic environment it may cause radio interfer-
ence, in which case the user may be required to take adequate measures.
InFocus reserves the right to alter product offerings and specifications at any time.
LP70.book Page 2 Friday, February 13, 2004 7:39 AM

Declaration of Conformity
Manufacturer: InFocus Corporation
27700B SW Parkway Ave. Wilsonville, Oregon 97070 USA
European Office: Strawinskylaan 585, 1077 XX Amsterdam, The Netherlands
We declare under our sole responsibility that the projector conforms to the follow-
ing directives and norms:
Directive 89/336/EEC, Amended by 93/68/EEC
EMC: EN 55022
EN 55024
EN 61000-3-2
EN 61000-3-3
Directive 73/23/EEC, Amended by 93/68/EEC
Safety: EN 60950: 1992 + A1 + A2 + A3 + A4: 1997
January, 2004
Australian Certification C-tick mark
Trademarks
Apple, Macintosh, and PowerBook are trademarks or registered trademarks of
Apple Computer, Inc. IBM and PS/2 are trademarks or registered trademarks of
International Business Machines, Inc. Microsoft, PowerPoint, and Windows are
trademarks or registered trademarks of Microsoft Corporation. InFocus and LP
are trademarks or registered trademarks of InFocus Corporation.
LP70.book Page 3 Friday, February 13, 2004 7:39 AM

i
TABLE OF CONTENTS
Safety Instructions iii
Introduction 1
Image Resolution 1
Compatibility 1
Unpacking the Projector 1
Usage Guidelines 4
If You Need Assistance 4
Warranty 4
Setting up the Projector 5
Connecting a Computer 7
Connecting a Video Player 9
Powering up the Projector 11
Turning Off the Projector 14
Using the Projector 15
Basic Image Adjustment 15
Adjusting the Projector 15
Using the Remote Control 17
Using the Keypad and Remote Buttons 18
Using the On-Screen Menus 20
Basic Menu 21
Setup menu 23
Maintenance & Troubleshooting 29
Cleaning the Lens 29
Cleaning the Lamp Filter Screens 29
Replacing the Projection Lamp 30
Replacing the Batteries in the Remote Control 32
Using the Security Lock 32
Troubleshooting 33
Appendix 37
Accessories 37
Projected Image Size 38
Index 39
LP70.book Page i Friday, February 13, 2004 7:39 AM

ii
table of contents
LP70.book Page ii Friday, February 13, 2004 7:39 AM

iii
SAFETY INSTRUCTIONS
Please read and follow all safety instructions provided BEFORE
using your new projector. Failure to comply with safety instruc-
tions may result in fire, electrical shock, or personal injury and
may damage or impair protection provided by equipment. Please
save all safety instructions.
Safety Definitions:
•Warning: Statements identify conditions or practices that
could result in personal injury.
•Caution: Statements identify conditions or practices that could
result in damage to your equipment.
Safety Symbols:
Attention: For information about usage of a feature, please
refer to the User’s Guide.
Warning: Hot surface. Do not touch.
An arrow pointing to the lamp door on the projector.
Warning: Turn the projector off, disconnect the power cord,
and wait 60 minutes before opening the lamp housing.
Safety Terms:
•Warning: Don’t look directly into the lens when the projector is
turned on.
•Warning: To replace the lamp, turn the projector off
and unplug the power cord. To avoid burns, wait 60 min-
utes before opening the lamp door. Follow all instructions pro-
vided in this User’s Guide.
•Warning: Please use the power cord provided. Connect
the power cord to a receptacle with a protective safety
(earth) ground terminal.
•Warning: Refer all service to qualified service personnel. Ser-
vicing your own projector will void the warranty.
•Caution: Don’t block ventilation openings.
LP70.book Page iii Friday, February 13, 2004 7:39 AM

iv
Safety Instructions
•Caution: Don’t set liquids on the projector. Spilled liquids may
damage your projector.
•Caution: Don’t place the projector on a hot surface or in direct
sunlight.
•Caution: Do not drop the projector. Transport the projector in
an InFocus-approved case; see page 37 for a list of cases.
Important Operating Considerations for Safety
•Place the projector in a horizontal position no greater than 15
degrees off axis.
•Locate the projector in a well-ventilated area without any
obstructions to intake or exhaust vents. Do not place the projec-
tor on a tablecloth or other soft covering that may block the
vents.
•Locate the projector at least 4' (1.2 m) away from any heating or
cooling vents.
•Refer to this manual for proper startup and shutdown proce-
dures.
•In the unlikely event of the lamp rupturing, discard any edible
items placed in the surrounding area and thoroughly clean the
area along all sides of the projector. Wash hands after cleaning
the area and handling the ruptured lamp. This product has a
lamp which contains a very small amount of mercury. Dispose
of it as required by local, state or federal ordinances and regula-
tions. For more information see www.eiae.org.
Follow these instructions to help ensure image quality and lamp
life over the life of the projector. Failure to follow these instruc-
tions may affect the warranty. For complete details of the war-
ranty, see the Warranty section at the end of this user's guide.
Do not place objects in
this area on the back of the projector
2ft(.6m)
LP70.book Page iv Friday, February 13, 2004 7:39 AM