Ingics IGS01 User manual

INGICS TECHNOLOGY
AP NOTE 001
Ver.1
iGS01 Quick Start Guide
Introduction
The iGS01 gateway reads beacons(ex. iBeacon,
Eddystone ..), customized tags, or BLE sensors and sends
the information to the local TCP server, internet HTTP or
MQTT server. Following are some mostly used examples :
iGS01 as a TCP server
Diagram
By default, the iGS01 is in AP mode as a TCP
server.
Steps:
1. Connect to iGS01 WiFi AP
2. Use TCP client tool to connect iGS01 TCP server
3. You can see the tag/beacon information in your
TCP client tool
 INGICS TECHNOLOGY CO., LTD. • [email protected] • WWW.INGICS.COM
1

INGICS TECHNOLOGY
iGS01 as a TCP client
Diagram
In this example, the iGS01 is a TCP client and
connects to an existing TCP server through the
external AP.
Steps:
1. Connect to iGS01 WiFi AP
2. In the browser, open 192.168.10.1
3. set iGS01 to connect to your AP
4. set iGS01 to connect to your TCP server
5. After iGS01 rebooting and building TCP
connection, you can see the tag/beacon
information on your TCP server.
 INGICS TECHNOLOGY CO., LTD. • [email protected] • WWW.INGICS.COM
2

INGICS TECHNOLOGY
iGS01 as a HTTP or MQTT client
Diagram
In this example, iGS01 is a HTTP or MQTT client
connects to the internet HTTP or MQTT server.
Steps:
1~3 are the same with “iGS01 as a TCP client”
4. set iGS01 to connect to your HTTP/MQTT server
5. After reboot, iGS01 is connecting to your
HTTP/MQTT server. You can see the tag/beacon
information in your server.
Revision History
DATE
REVISION
CHANGES
Nov 29, 2015
1
Initial release
 INGICS TECHNOLOGY CO., LTD. • [email protected] • WWW.INGICS.COM
3