InkJet ANSER U2 User manual

10 STEPS
TO INSTALL
YOUR ANSER
U2 PRINTER
1-800-280-3245
customercar[email protected]
www.inkjetinc.com

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Drill four (4) holes
for the M8 bolts.
(A template is
included if
needed.)
1

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Attach the bracket
holder to the
conveyor using the
previously drilled
holes.
2

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Place stainless bar (A)
into the receptacle of
the bracket holder
and tighten firmly.
3

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Slide the bracket
adjuster onto
stainless bar (A)
and tighten into
place.
M8xL25 screw
4

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Place stainless bar (C)
into the bracket adjuster
and tighten.
M8xL25 screw
5

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Put the Printhead
adjuster onto stainless
bar (C). Use the handle
to tighten.
6

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Place stainless bar (B)
into the Printhead
adjuster. Tighten into
place.
7

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Attach the deflection
(Anti-Shock) plate to the
U2 controller. (The plate
should be mounted to
the side closest to the
oncoming substrate.)
8
Turn screws counter clockwise
M3xL5 screw and washer

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Attach the Anti-shock
Mechanism to the
U2 controller.
9
M4 washer
M4xL16 screw

ANSER U2 INSTALLATION GUIDE
www.InkJetInc.com
Place the U2 controller
onto stainless bar (B)
and tighten firmly.
10
U2 ahead of
guide-bar
about 2mm
M8xL25 screws

Thank you!
1-800-280-3245
www.inkjetinc.com
[e-mail]
THE AUTHORIZED ANSER DISTRIBUTOR IN THE U.S.