Inmu Touch inmu User manual

INMU USER MANUAL
Watch the instructional videos and learn more
about the inmu at inmutouch.com/support
or contact support at [email protected]
A touch activates the inmu and
awakens the music. Unplug the
cable if it is connected.
TURN ON
The music automatically stops
when the inmu is lying still.
Please note: No cable is needed.
TURN OFF
Silent during transport:
Unzip the cover and connect the
cable. The inmu will stay silent
until the cable is unplugged.
DEACTIVATE
Core (green)
Charger connecting plug
Cover *
The inmu
charger
and cable
The cover can have dierent
colours and fabrics
*
OVERVIEW

Watch the instructional videos and learn more about the inmu at inmutouch.com/support or contact support at [email protected]
WASH THE COVER
DRY THE COVER
PUT ON THE COVER
Find the zipper pull tap.
Unzip the zipper.
Take o the cover.
Turn the cover inside out.
Zip up the cover and leave
4 cm open for easy handling.
Wash according to the care
label instructions.
Machine wash or hand wash.
Unplug the cable if the
cable is connected.
Turn the cover right side out
again.
Put on the outer cover.
Air dry flat -
e.g. on a towel.
Do not tumble dry.
Please note! Make sure the care
label and plug are aligned.
Zip up and conceal
the pull tab.
While still damp, carefully
stretch the cover into shape.
!
4 cm !

Watch the instructional videos and learn more about the inmu at inmutouch.com/support or contact support at [email protected]
CHARGING
VOLUME (Please follow these instructions closely or watch the instructional videos at inmutouch.com/support)
MAINTENANCE
The inmu is water repellant.
It can be wiped with a damp
cloth.
1. Awake the music. Connect
the cable and the inmu goes
silent. Then immediately ...
When the battery level is low a
“Knock, knock, knock” signal
sound will be heard and the
inmu needs to be charged.
The cover and the core can be
wiped with a disinfectant tissue.
2. ... squeeze firmly on both
sides simultaneously. Listen and
stop at the preferred volume:
Low, medium or high and then
immediately...
Find the pull tab of the zipper.
Unzip the cover. Connect the
cable and the charger. A signal
sound indicates that charging has
begun.
Attention!
The inmu is NOT watertight.
Attention! Do not disassemble
the inmu (core).
3. ... unplug the cable to save the
preferred setting. Zip up the
cover and conceal the pull tab.
Charging time: up to 3 hours.
A “Humm...” sound will be heard
until the battery is fully charged.
The volume of sound reflects the
battery level.
The setting should be completed
within 4 sec. If a “Wizz...” signal
sound is heard the new setting
was not successful. Then repeat
steps 1-2-3.
When the “Humm... “ sound stops
the inmu is fully charged. Unplug
the cable, zip up the cover and
conceal the pull tab.
3H
“Knock
knock
knock” “Humm...”
“Wizz...”
1234 sec

Watch the instructional videos
and learn more about the inmu at
inmutouch.com/support or contact
support at [email protected]
CONTACT
inmutouch.com ApS
Klakring Stationsvej 20
DK-7130 Juelsminde
Denmark
www.inmutouch.com
Email: [email protected]om
Phone: [phone]
DISPOSAL
The inmu has a rechargeable Lithium-ion
battery, which corresponds to the EU-direc-
tive 2006/66/EC. It must not be disposed of
as ordinary household waste. Please follow
your local regulations for battery disposal to
prevent negative impact on the environment
and health.
Model name: Soprano.
Product name: inmuRELAX and inmuDANCE
SAFETY ADVICE
1Do not attempt to disassemble the inmu or take o the inner cover (the core).
2Avoid striking the inmu against sharp or hard objects.
3Keep the inmu away from fire.
4 Keep the inmu away from flammable fluids.
5The inmu is NOT watertight. Contact with fluids should be avoided.
Keep the charger and cable dry.
7Do not leave the inmu outdoors or in environments with high humidity.
8The inmu should not be used or stored at temperatures below 5° C or above 45° C.
9The inmu should not be charged at temperatures below 10° C or above 45° C.
10-12 The inmu and battery charger should not be exposed to direct sunlight.
13-14 Only the original charger and cable should be used when charging the inmu.
15 The charger must not be dismantled.
16 The inmu should not be exposed to more than 100 kg of continued pressure.
17 The inmu can absorb moderate shocks only (avoid drop of more than 2 meters).
18 The inmu is not made to end in a trash can. Most parts can be reused.
1
2 64 5
7
+5 °C
+45 °C
8
+10 °C
While charging
+45 °C
9 10 11 12
100 kg
100kg
16 1713 1514
3
18
The inmu is made of materials that are as
sustainable, natural and hypoallergenic as
possible. We make our products with care,
consideration and dignity. Touch the inmu
—enjoy it and share it with others...
RECYCLING