Innovamed Health VenaPro User manual

INSTRUCTIONAL
POWER OFF:
Unit is in “sleep”mode. No visible illumination.
POWER ON:
When the unit is powered on the power button will illuminate GREEN
can be illuminated ifbattery is LOW). After a 5 second delay, the pumps will
mmHg. Once the pressure reaches the proper level, the pump will turn OFF
so on every 50 seconds.
By Prescribing Physician Only:
Unit use time (amount of time the unit is powered ON) is monitored and
stored by the MPU (Microprocessor Unit) and can be downloaded into Excel
via the USB interconnecting to an interface module.
BATTERY INDICATOR:
In order to properly indicate the state of the battery and charger, there are THREE stages of
the BATTERY INDICATOR as follows:
STAGE 1 – GREEN:When the unit power is ON and the battery is
button indicates battery is fully charged (if connected to charger)
or has adequate power for portable operationif not connected to
charger.
STAGE 2 – YELLOW: The yellow LOW BATTERY INDICATOR will REMAIN
ILLUMINATED during the pumping time and rest period. At this stage the
battery charger MUST be connected immediately to avoid any interruption
in the treatment sessions.
STAGE 3 – GREEN: When the unit is turned OFF and the battery is
charging, the GREENpower button FLASHES. Once the battery reaches full
charge, the GREENpower button REMAINS SOLID.
SYSTEM
COMPONENTS QUICK START
Low Pressure Indicator
USB Port
Power Button &
Battery Indicator
Charging Port
CALF CUFF APPLICATION
Make sure the wrap is snug, but not too tight.
When both wraps are secured
on your legs, they should look
like the picture above.
Left Leg Pictured
1
2
USING THE DEVICE
Don’t be startled. The device will make a“humming”sound when
THIS IS NORMAL. The wraps will
is normal. This is a function of the device to keep your legs cool.
TURNING THE DEVICE ON
When the wraps are secured on your
legs PRESS and HOLD the WHITE power
button for about a second until a
single BEEP tone is heard and the light
is illuminated on each unit. To turn the
unit OFF, PRESS and HOLD the WHITE
power button for about a second until
a DUAL BEEP tone is heard and the
light is no longer illuminated.
3
4

USING THE AC ADAPTER /
BATTERY CHARGER
UNIT POWERED OFF
Insert the supplied power supply plug by into the port at the bottom end of the unit
and connect the power supply adapter to the wall socket. The GREEN“Charging”
A full charge of a depleted battery should take about4hours. When the unit is
Once the battery reaches full charge the power button will be green and remain
solid.
UNIT POWERED ON
For extended operation periods, or to charge the battery during treatment sessions,
the AC adapter CAN be connected while the device is in use. The power button
charging. The power button WILL REMAIN SOLID GREEN once the battery is
fully charged.”
CHARGING THE BATTERY: USE ONLY THECHARGER PROVIDED BY
INNOVAMED HEALTH.
Use of the wrong charger can cause excessive heat,
damage to the charging circuit and shorten the life of the battery.
ALARMS:
“Battery Critical” – If battery voltage drops below critical level, cycling stops,
audible alarm will sound, and power button WILL FLASH RED. Alarm will continue
for 30 seconds (unless unit is powered OFF) and automatically turn the unit OFF.
Plug in power supply immediately.
“Low Pressure or Leak” – When activated, if pressure limit is NOT reached
within 20 seconds after pump is energized, cycling stops, ALARM sounds and BLUE
(unless unit is powered OFF) and automatically turn the unit power OFF. Make sure
wrap is attached snuggly to the leg. Turn the unit OFF, and then turn the unit back
customer service for a replacement unit at 877-475-7050.
ALARM RESET:
To reset analarm condition after the“operation inhibit”stage is reached, the unit
must be turned OFF. If notmanually turned OFF within 30 seconds of such an alarm
condition occurring, unit automatically turns itself OFF. Once the unit is turned back
on the alarm is RESET.
OPTIONS:
By Prescribing Physician Only:
At the top edge of the pump/controller unit is access to amini USB port. This is
NOT to be directly connected to a computer. In order to download use data, a data
expander interface must be purchased from InnovaMed Health.
An additional function available through the USB port is to add a remote control
module for ON/OFF operation from a hand-held transmitter. These modules aid in
controlling the system for patients unable to access the device operations.
CLEANING AND DISINFECTING
NOTE: Inspect the VenaPro unit and follow the cleaning and disinfecting procedures prior to eachuse.
WARNING:
cleaning or disinfecting.
DO NOT IMMERSE UNIT IN ANY LIQUID FOR ANY REASON
• Clean the outer surface of the pump unit using a soft cloth, moistened withsoapy water or 70%
isopropyl alcohol.
• Do not use abrasive or volatile cleaners.
WARNINGS AND
PRECAUTIONS
• T
use only.
• Medical Electrical Equipment needs special
precautions regarding EMC. Portable and mobile
other Medical Electrical Devices.
•
may cause skin irritation. Regulary check for patent
discomfort, compliance, and skin irritation.
• To prevent extremity compartment syndrome,
special attention should be given to patients who
are positioned in the supine lithotomy position for
extended lengths of time. This includes patients
• Do not open or remove covers. No user serviceable
parts inside. Direct all unit issues to InnovaMed
Health.
•
wrapped too tightly. Loosen Immediately.
• Stop using device if swelling occurs; consult a
Physician.
• Device is to be used only by the patient prescribed,
and only for its intended use.
•
unplugged from the wall outlet prior to and while
cleaning or disinfecting.
• Equipment should not be used in the presence of
or nitrous oxide.
• Do not immerse in any liquid for any reason.
• Do not operate device in a wet environment.
•
• Do not subject the unit to extreme shocks, such as
dropping the pump.
• Contains no user serviceable parts. Contact
InnovaMed health Customer Service.
• Do not place any items in an autoclave.
• Operation of this device can be done by the patient.
• No Service is to be attempted while the device is in
use.
•
•
•
•
water or 70% isopropyl alcoholand let air dry.
• To ensure the unit IS completely dry prior to use, leave unit in the OFF
condition and disconnected from the wall outlet for 30 minutes after cleaning
or disinfecting.