Inrico S300 User manual
System Parameter
Security information
匮
Care and Cleaning
warning
Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined byby turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
SAR tests are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands, although the
SAR is determined at the highest certified power level, the actual
SAR level of the device while operating can be well below the
maximum value.
Before a new model device is a available for sale to the public, it
must be tested and certified to the FCC that it does not exceed the
exposure limit established by the FCC, Tests for each device are
performed in positions and locations (worn on the body)as required
by the FCC.
For face-up,10mm was used for test, this equipment should be
installed and operated with minimum distance 10mm.
For body worn operation, this model phone has been tested and
meets the FCC RF exposure guidelines when used with an
accessory designated for this product or when used with an
accessory that Contains no metal and that positions the handset a
minimum of 5mm from the body.
Non-compliance with the above restrictions may result in violation
of RF exposure guidelines.
Other manuals for S300
1
Table of contents
Other Inrico Radio manuals
Inrico
Inrico S300 User manual
Inrico
Inrico TM-7 Plus User manual
Inrico
Inrico IRC590 User manual
Inrico
Inrico TM-9 User manual
Inrico
Inrico TM-7Plus User manual
Inrico
Inrico T310 User manual
Inrico
Inrico T710A User manual
Inrico
Inrico PD660 User manual
Inrico
Inrico T320 User manual
Inrico
Inrico S100 User manual
