Insignia M.2 NVMe 2280 User manual

Before using your new product, please read
these instructions to prevent any damage.
PACKAGE CONTENTS
• Heat sink
• Thermal pad (2)
• Screw for heat sink (4)
• Screw for xing PS5 and SSD
• Screwdriver
• Quick Setup Guide
QUICK SETUP GUIDE
M.2 NVMe 2280
Heat Sink
NS-PM2HS / NS-PM2HS-C
FEATURES
• Specially designed for single and
double-sided M.2 2280 or M.2 22110 SSDs,
cooling down your device to a safe
temperature
• Double-sided construction works with most
desktop computers and PlayStation 5
• Groove design provides a 50° F ~ 68° F
(10° C ~ 20° C) all around cooling (varies
depending on environment)
• Helps avoid overheating and throttling,
improving the performance of your device
• Silicone thermal pads provide durability,
protection, and improved heat dissipation
COMPATIBILITY
• M.2 2280 or M.2 22110 SSDs
• PS5 and desktop computers with 12 mm
clearance on the motherboard
OVERVIEW SETTING UP YOUR HEAT SINK
1Remove the protective lm from one of the
thermal pads and place the pad inside the
heat sink.
2Remove the protective lm from the other
thermal pad, then place the pad on top of
the M.2 SSD.
Thermal pad
SSD
Heat sink
Thermal pad
Heat sink
Thermal pad
Thermal pad
Heat sink
SSD
Top cover
NS-PM2HS_-C_22-0565_QSG_V2_EN_Final.ai 1 6/10/2022 3:40:01 PM

3Place your M.2 SSD on the center in the heat
sink by aligning the back of the SSD with the
back of the heat sink.
4Place the top cover on the M.2 SSD.
V2 ENGLISH 22-0565
5 Use the included screwdriver and four small
screws to secure both sides of your heat sink.
6 Install your M.2 SSD pin side rst in your PS5
or desktop at a 30° angle. Press the other end
of your M.2 SSD down until it is level. Secure
it in place with the included long screw.
Note: When installing the M.2 SSD, make sure that
the aluminum ferrule is used with the long screw
to provide stability and proper oset for the M.2
drive. Failure to use the aluminum ferrule can
result in M.2 damage.
Screws
SSD
Top cover
M.2 SSD (2280 mm)
M.2 SSD (22110 mm)
SPECIFICATIONS
Dimensions (H×W×D):
2.9 × .9 × .4 in. (7.5 × 2.4 × 1 cm)
Working temperature: 32 ~ 158° F (0 ~ 70° C)
Working humidity: 20% RH to 90% RH
ONEYEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call
1-877-467-4289 (U.S. and Canada)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2022 Best Buy. All rights reserved.
0.1 in. (3.8 mm)
NS-PM2HS_-C_22-0565_QSG_V2_EN_Final.ai 2 6/10/2022 3:40:01 PM